Cisco VPN :: 2811 - SSL VPN Services / Cannot Pass Traffic To Internet

[OK]     Site to Site IPSec + GRE = success, no problems.
[OK]     IPSec remote access = success, no problems.
[NO]     SSL VPN = remote users can successfully connect to all internal systems. Cannot pass traffic to the Internet.
 
Hardware:
Cisco 2811, Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(22)T5, RELEASE SOFTWARE (fc3) . Software: Cisco Any Connect Secure Mobility Version 3.1.01065
 
Single hub router terminating IPSec+GRE site to site, IPSec remote access, and SSLVPN remote access VPN services. All services currently configured and running successfully with the exception of the SSLVPN service. Remote users can initiate and successfully establish SSL VPN sessions. While established, connectivity to all internal systems/resources are successful. Only when the remote access client tries to connect to "Outside" Internet resources does traffic not pass successfully. Troubleshooting has pointed to a NAT related issue (I believe).
 
When connecting from a remote access workstation, utilizing IPSec remote access client (built-in Cisco IPSec client from Mac OS), the session establishes and the client works flawlessly. Examining the Cisco 2811 router, you see the /32 host route from the remote access session get installed, and you see the corresponding NAT translation entries created when the client accesses outside (Internet) resources. Appropriate configuration to implement "hair pinning" have been included to handle the in and right back out (with NAT translation) needed for remote clients to access the Internet.
 
Configured the 2811 for SSL VPN, and remote access clients can successfully connect and access all internal network resources. Examining the Cisco 2811, the /32 host route for the remote access client is installed, pointing to SSLVPN-VIF0 interface with a next hop of 0.0.0.0  When checking the NAT translation table, there are NO entries for the remote access client address created which leads me to believe the hair pinning/NAT function is not being invoked for SSLVPN clients.
 
Originally, the IPSec remote access VPN local pool was 10.0.100.0 /24. To keep from having to adjust the existing NAT translation, PBR Route-MAP for the hair pinning function - I took the 10.0.100./24 and broke it into a pair of /25 networks. Bottom half for the IPSec remote access VPN pool (10.0.100.0 /25); upper half for the SSL VPN pool (10.0.100.128 /25). By utilizing SSL VPN, is the traffic somehow bypassing the DIALER1 interface where both the crypto map (and more importantly: IP NAT OUTSIDE, and PBR configuration for the hair pinning function)? I cant explain why NAT translation entries are not being created for SSLVPN client sessions.
 
Cisco 2811 Configuration has been included. IPSec & SSL VPN Remote Access Sessions Captures (performed from same remote client) have been included.