Cisco VPN :: Anyconnect VPN Setup But Not Responding On Port 443 Outside ASA 5505

I followed a few Youtube videos and replicated another ASA's VPN configuration through ASDM to create the Anyconnect VPN on the ASA 5505.
 
The problem is, after everything checked and triple checked, I still cannot get to https://external_IP.  I can post configs if needed, but I really did replicate another ASA almost exactly.An online port scan shows my external IP as "not listening on port 443".However, when I run on the ASA :
 
I get the following (external IP changed to 123.123.123.123 for the forums):
 
Protocol  Socket    Local Address               Foreign Address         State
TCP       0004426f  192.168.8.4:22              0.0.0.0:*               LISTEN
SSL       0574f7af  123.123.123.123:443            0.0.0.0:*               LISTEN
DTLS      0577b0ef  123.123.123.123:443            0.0.0.0:*               LISTEN
TCP       06fa8d1f  123.123.123.123:80             0.0.0.0:*               LISTEN
SSL       079385bf  192.168.8.4:444             0.0.0.0:*               LISTEN

 
So it does appear to be listening on the external IP on the outside interface correctly.I went ahead and tried the whole "change the ASDM port" as you can see from the inside interface being changed to 444 but management isn't even enabled on the outside interface so I'm not sure why it is acting this way.
 
The outside interface is plugged into a DSL modem.  I don't think this DSL modem has any real intelligence, but I was going to disconnect the ASA and plug my laptop into the outside interface (on the same subnet) and then see if I could reach it.  That was the only thing I could think of...that possibly the DSL modem was blocking the inbound traffic.