Cisco Firewall :: ASA5585 Interfaces Not Connecting Palo Alto Failed Or Shutdown

We have pair of ASA5585 (ver 8.4(4) with IPS module configured with Active/Standby failover. There are total 09 interfaces are connecting to different zones in the firewall and out of which three(3) interfaces are connecting to Palo Alto 2nd layer firewall. When we test the failover whatever interfaces not connecting Palo Alto failed or shutdown, ASA triggers the failover to other unit, however the Palo Alto is not detecting this failover and it still keeps its previous Active Palo Alto to pass traffic, thereby failing passing traffic on Active firewall through Standby Palo Alto firewall.
 
But when there's a interface failed or shutdonw on the interfaces where PaloAlto also connected, then once the ASA failover triggers and the same time Palo Alto also trigger its  failover then both new active firewall and Palo Alto sending traffic through firewall.However we  we cant all the interfaces of ASA also to connect Palo Alto and let the Palo Alto to inspect all the interfaces, but we need our ASA to work in a situation where any of the interfaces failed, the failover to work smooth the pass the traffic via either Palo Alto device.I just need to know is there anything tricky that we can configure on our ASA in this failover senario, or to confirm if there's no any workable solution to this situation.
 
I have attached the senario that I explained above. Just to emphasis the issue again, if any interface of Gig0/0, Gig0/4 or Gig0/5 failed on active firewall, ASA switching to standby firewall and act as Active, but Palo Alto still remains his Active state and the new Active ASA is not passing traffic via standby PA as its not detecting any of its interfaces as failed or unreachable..?