Cisco WAN :: OSPF ASA 5520 In Failover Mode?

I currently have a set of firewalls in active standby configuration running an ospf process injecting a default route into the rest of my network.I noticed when i was testing the failover that the asa's do not actually pass the route tables on failover, thus forcing the need to wait for routes to converge and for the default route to be advertised back into the network. This of course is not acceptable.
 
Is there a way around this or do I have to setup static default routes on every device in my network. I am trying to avoid setting up default routes on all of the devices because due to the setup of my network I have equal cost links configured in the event of hardware or link failure. So the devices then see an advertised default route from multiple paths.