Cisco Wireless :: How To Limit Users Bandwidth Using Nexus 7000 And WLC 5500

I used the following commands to limit users on my wireless network (WLC 5500) and a Nexus 7000.  The previous cisco doc only covers the 6500 and some commands have changed.  Tested and working except the PIR gives an error, post up if you know why, otherwise enjoy!
 
Note Wireless Network assumed to be 172.21.0.0/16.Note This will limit each wireless user to 1 MbpsNote The PIR (Peak Infomation rate, also know as burst) is ignored in following commands, unknown at this time why.Create ACLs:

ip access-list acl-wireless-downstream  10 permit ip any 172.21.0.0/16 ip access-list acl-wireless-upstream  10 permit ip 172.21.0.0/16 any class-map type qos match-all class-wireless-upstream  match access-group name acl-wireless-upstreamclass-map type qos match-all class-wireless-downstream  match access-group name acl-wireless-downstreampolicy-map type qos police-wireless-upstream  class class-wireless-upstream   police cir 1 mbps bc 200 ms pir 1536 kbps be 200 ms conform transmit exceed drop violate droppolicy-map type qos police-wireless-downstream  class class-wireless-downstream    police cir 1 mbps bc 200 ms pir 1536 kbps be 200 ms conform transmit exceed drop violate drop

1.Apply police-wireless-upstream on the incoming port from the controller.

interface port-channel130  description *** LAG for WLC1 ***  switchport mode trunk  switchport trunk allowed vlan 80,130,255,600  service-policy type qos input police-wireless-upstream
 
2.Apply policy-wireless-downstream on the uplink LAN/WAN ports.

interface port-channel101  description *** L3 Port Channel to Core VDC ***  no switchport  service-policy type qos input police-wireless-downstream  ip address 10.70.10.18/30  ip router eigrp 10