Cisco Wireless :: New 5508 Not Handing Our Correct IP Address Scope To Clients

Just inserted a new 5508 WLC into the network. We current have 3 4404 WLCs, and there was a need to duplicate, as much as possible, the configurations on the 4404s, and the design. The 5508 came online as expected. We moved a few access points over to it. The APs got the correct address range. The clients are expected to get addresses in the same scope range as the APs. However, the clients are receiving addresses in the management IP scope.I know there are two "not a good way to do it" in here. Why is the management address range in the DHCP scope, and why are the clients using the same scope as the APs. We are going to change that. For now, the AP and client in the same range has been going on since we rolled out wireless in 2006.The 8 ports on the 5508 are configured for LAG. There is no dedicated port for management. They tell me not to do that on a 5508.