My laptop is configured with an alternative configuration with static IP address for my network, normal TCP/IP settings are set to automatically, yet every time i boot up my laptop it struggles to resolve the IP address, leaving a Yellow triangle over the Network icon in the System tray, the IP address eventually will resolve it self allowing internet connect, I Can't seem workout what is slowing procoess down, any applications like web browser, updates, become non-responsive until the connection is fully established.
My Dell was running very slow, so I used the disks that came with the computer to reinstall Windows XP. After doing this, it wasn't detecting our wireless network. I went through on the drivers disk and installed the drivers in order according to Dell's specifications. It still wouldn't work, so I went to the dell website from another computer, and downloaded the drivers that pertained to the network. Now it is recognizing the network, I was able to enter my key, but it won't stop "acquiring network address". When I do the ipconfig /all, it looks like there is no IP address:
Microsoft Windows XP [Version 5.1.2600] (C) Copyright 1985-2001 Microsoft Corp. C:Documents and SettingsUser>ipconfig /all
My computer was recently cured of a damaged processor and a viral infestation, and it seems to be working properly again, however,I've been unable to connect to my network because the connection gets stuck on "acquiring network address".I am running Windows XP service pack 3 and the network device that isn't connecting is a Realtek RTL8168C(P)/8111C(P) PCI-E Gigabit Ethernet NIC.
I connect to the internet using a wireless USB. I woke up this morning and the internet showed that it was connected yet it wouldn't allow me to open the web or anything such as "msngr" I took the wireless card out for a couple minutes and then tried. That didnt do anything but say acquiring network address. I am not that knowledgeable when it comes to computers but these are the things that I have tried so far :
I went into properties and configure USB . . Made sure that the SSID said "Any" I Also tried going into properties and tcp/IP internet protocol and made sure it was on obtain IP address automatically . Hmm I tried. RUN>SERVICES> to make sure that the DHCP and TCP were started and on Automatic. I then tried system restore :- (went back about 2 weeks) . . Nothing. I then tried RUN>CMD>IPCONFIG/RELEASE *ENTER* IPCONFIG/RENEW *ENTER*.
when I did that it showed wireless network is now connected, yet back to ground zero. It wont let me browse. Its not really connected. When I look at the connection status, signal strenghth is good. Packets sent & received are good. I feel like there is just something little that. I am not getting, that is making this happen.
my daughter accessed a website and got the XP Security 2012 virus on her laptop. Then she went on my pc and did the same thing. Fortunately, it appears that I have gotten both systems cleaned up. At this point my system seems to be fully functional, but her laptop is another story. It is working ok, except that we cannot connect to the internet/network with it. It seems to be stuck on the "acquiring network address" loop. I am not super computer savvy, but I have looked at the device manager for issues (found none).
Recently during the power failure my PC shut down abruptly since since then it is not connecting to the network. I have a cable broadband internet, I am using Ethernet wired connection, Intel PRO/100 VE. The Ethernet jack is good as I have confirmed using my laptop. The network connection gets stuck in acquiring network address state. I tried restoring the system to earlier date but it fails to restore. I installed new Intel drives, deleted ethernet adapter from device manager, reinstalled TCP/IP but no luck.. I am using XP SP3 on P4 machine,
I recently started a thread called 'Network Controller Not Found (clueless!)' which highlighted a problem I had with a RaLink Wireless Adapter and the system not locating the correct driver. It's now found the Ralink Wireless Turbo 802.11g driver and wireless connectivity is live. However I have a new problem with connecting to the BT Homehub. BT Fon and Openzone connections are fine, and it finds my BT homehub by name, but on clicking 'connect' I have a constant 'acquiring network address' over the icon in the system tray. I've seen this problem mentioned before, but am completely new to setting up wireless connections, so don't understand much of the terminology at all! Even when trying to reinstall from CD, the homehub is not indentified, resorting to wired setup. I've looked at other threads but just don't know where to begin. I've followed instructions and reset the homehub, but nothing. The IP address values are 0, is thing something to address (no pun intended)?
Here is a rundown of a wireless networking test.
Windows IP Configuration Host Name . . . . . . . . . . . . : Air Primary Dns Suffix . . . . . . . :
I have a Asus EeePC SeaShell 1005HA-H and i have a LINKSY ROUTER in my home. I recently been having problems with my wireless internet. I know it isnt the router because i have went to my boyfriends house and my laptop usually automatically connects to his internet and the same message continues to show up "Acquiring Network Address message". I try to repair the network and a error comes up. Then i went to check the firewall settings and the firewall is tured off.
I was connected on wifi and all of a sudden I got disconnected and hasn't been able to connect since. This happened Sunday night and it's now Thursday. I got stuck on acquiring network address. I've been using the same wifi connection for about 7 months now and this never happened before.
All the other laptops at home (Mac and XP) could connect except me. I tried to google over my phone but still wasn't able to fix it.
This is what the ipconfig says: Microsoft Windows XP [Version 5.1.2600] (C) Copyright 1985-2001 Microsoft Corp.
I have a dell laptop. It will pick up and connect to the neighbors wifi. But when trying to connect to mine it will not acquire a network address. It continuously searches but says 0.0.0... it says the signal is excellent but will just not acquire the ip address. By the way, cell phones with Wifi connect to this network with no problems.
Have a computer running windows xp. Whenever I plug in my internet cable it says 'Acquiring Network Address'. I have left it for over and hour but it still says the same thing. I have connected other computers to the router with the same cable and they work perfectly. I have also tried channging the linkspeed for the network connection, renewing my ip address, repairing the network connection and disabling and enabling the connection.
I have a laptop HP Mini 110 1025DX with Windows XP sp3 Home Edition and up to January,31 his wifi was ok. Since February,1 my wifi keep on giving message âAcquiring Network Address on my work. I tried several possible solutions without success. My wireless card is Broadcom 802.11 b/g WLAN. His drive is updated. In my work, haven´t change none parameters from the wireless. What I need to do ?
i recently bought a dell mini laptop and i am already encountering problems with my wireless. i am on the laptop now, but i connected it via ethernet, and that is apparently working. whenever i hit repair it gets stuck at acquiring ip address.
I'm running a Windows XP Dell laptop. A few days ago I completely reformatted the computer because it was just starting to run slow. I reinstalled Windows from the factory CD and downloaded the latest drivers from Dell's website. Now suddenly, after the reformat, my network connection gets stuck on "Acquiring network address." Running ipconfig shows either 0.0.0.0 or a blank space for each field.Other laptops in the house work fine.I did discover that I can get it to say "Connected" if I go into the advanced settings and manually enter an IP address and use the subnet and gateway from my desktop's ipconfig results. The problem is that I can't actually get on the internet. It just says it's "connected."
I'm working on a friends laptop that used to connect wirelessly to their network no problem, and all of a sudden it would no longer connect at all. It a 5 year old Gateway laptop running Windows XP Media Center. It just hangs at "Acquiring network access" and never connects. I'm pretty sure it's their network because it works on my home network perfectly, connects and stays connected.
Can you give me some pointers to do to the laptop and/or the network? I normally would start fresh with the wireless network, but they have a bundle package of AT&T (internet, phone & TV all-in-one) so the router is branded AT&T and don't want to mess any of that up.
I have fitted a thomson router to my desktop coputer using an ethernet cable and all is working fine. My Sony Vaio laptop recognises the wireless connection but fails to connect at the acquiring network address. I have been into the properties section of the network connection page and am only allowed 8 characters for the network key. But the Network key on the bottom of the modem is longer than 8 digits.
Recently, I am having an issue with my LAN connection. After I boot up, I get the "two computer" icon in my system tray that stays active. When I mouse over it, it says "Local Area Network Speed 100 Mbps Status - Acquiring Network Address"However, I am connected to the internet and there seems to be no connectivity problems. And it has an IP address: 192.168.1.66 This "acquiring network address" will persist forever, (although sometimes it will quit). If I right-click and do repair, the problem disappears immediately.I am running Win XP SP3 and am connected by ethernet cable to an ATT-U-verse Gateway.For what it's worth, Windows takes a very long time to boot up -- it takes a while for the icon to appear, and then the boot process completes.
I have a Dell Latitude D620 and my wireless isn't working. It worked before but then I had a malware/spyware on my computer that blocked my wifi and when I managed to get the program off, my wifi still wouldn't connect. It's not the wireless card because I bought an external one and it did the same thing. It's not my router because my other computer connects to the internet.
I have a USB Netgear WN111v2 that has been working perfectly up until now, it can't connect to the network and trying to manually set up the addresses, reinstalling drivers, and trying a system restore haven't worked. Even though the router has a lease for the computer on 192.168.1.11 it's doesn't work, although it will show that it's connecting, it won't ping anything, including the router... WZC utility is stopped?
i have a dell inspiron mini 10 and i put windows xp pro sp2 on it and got all the neccesary drivers for it the problem with it is that it detects my router and everything but when it tries to connect it gets "stuck" on aquiring network adress i tried the winsock fix and everything but nothing seems to work
I have a Dell Inspiron Mini 10 Netbook, when I'm trying to connect to a wireless network I get the message 'Acquring Network Address'. I can connect fine using a wired connection, but using the Wirless 1397 WLAN Mini card it won't connect.
I tried to log a call with Dell as the machine is only 2 months old and someone remotely connected and said it was a software fault not hardware and they would charge me to resolve the issue. I found that hard to swallow so thought I would try here.
I have E4200 with fixed ip 192.168.1.2, DHCP off connected through LAN ports to FIOS ActionTec as 192.168.1.1. When connecting through wireless network off the E4200, I can obtain and connect fine under Guest network and WEP security, but for any other security setting, WPA, WPA2, Mixed mode, etc. I get the message "Aquiring network address" forever, and I never get a connection.
... and made a fundamental mistake of uninstalling adapters hastily without looking into it. Now when I try to re-install the adapters, I'm running into difficulties. Specifically, I don't have the CD-ROM I originally must have used, and the following message is popping up: "Files Needed - The file 'atl02_2k.sys' on Atlansic Fast Ethernet Adapter Installation Disk is needed. Type the path where the file is located and then click OK." Unfortunately, I don't have any idea if there is a path where this is located, so installation cannot complete.
The reason I took this option to begin with was that the wireless connection on my laptop [Asus, Windows XP] was acquiring network address without ever connecting fully to the internet. I had previously tried another of other methods, such as manually entering an IP address, to no avail.
A few days ago the internet on my desktop was working fine. now it has the 'limited or no connectivity' sign on it and i have done a few things to try and fix this. I started by trying a simple repair. it comes up with 'the following action can not be completed: Renewing your IP address' This lead me to try and restart my PC and router with no luck.
I then decided to look a bit further into it and went ito CMD and flushed the DNS. i then did 'ipconfig /release' which generated the response 'IP address for adapter wireless connection 9 has allready been released'. I then did 'ipconfig /renew' to which it generated an interestin response:
'An error occurred while renewing interface wireless network connection 9 : The RPC server is unavailable'
I have made sure my DNS client is on automatic, alont with my RPC (this was uneditable). Its not a router problem as i have had multiple devices connected before and my laptop is working just fine connecting wirelessly.
I was having this issue with my Dell Precision M70 laptop until I made this tweak to the Intel Pro Wireless 2200BG card that is built-in and so far its seems to be making a difference with it connecting to our Cisco 541L APs and acquiring a DHCP from our network. However, the only thing different I noticed after making this change is that it is initially a bit slow at connecting to the Cisco APs.  [URL].    Click Advanced > Adapter Settings > Advanced tab. 2.    Select Power Management and uncheck Default / Auto and move the slider to Highest / Maximum Performance.If the slider is already at Highest / Maximum Performance, move the slider to another setting and then back to Highest / Maximum Performance. We are still experiencing this issue with our Dell Latitude E4200 laptops but need to verify that they are using the latest wireless network adapter drivers. In addition, I am planning to tweak the PSP as I did with the Intel Pro Wireless 2200 BG.  F.Y.I. Our PDC and Primary DNS server is a Windows Server 2000 Our BDC, Secondary DNS and DHCP server is a Windows Server 2003
I am registered on a chat sight but for the past week and a half each time I go on I can login and then I get a "Error receiving data from server:Connection reset" what can I do to fix this problem? I have the newest java downloaded
I bought a usb printer server to connect my usb printer to my router. USB cable to the print server and cat 5 from the print server to the router. The print server has a static fixed ip of 169.254.10.10 and a subnet mask of 255.255.0.0 I can ping the printer server and it works perfect from my windows 7 laptop. When I attempt to set it up on my windows xp (SP3) laptop I am not even able to ping the 169.254.10.10 address. On the windows 7 laptop i can navigate to the print servers menu by placing 169.254.10.10 in the address bar of internet explorer. No so with the xp laptop.What is different about the ip configuration between win xp and win7. how to get the xp laptop to "see" the print server. Want to keep the print server at the default settings if possible.
My IP adress has always been external. About 2 years ago, after reinstalling my windows,(I am using and used before reinstalling windows7) my IP adress started to work as it wouldn't be external. I couldn't host servers and stuff like that anymore.I tried turning off firewall, few other tricks but nothing changed.When I look information about my IP adress ,most of the sites see it as external.Also, when I call my interned providers, they tell me that they see my adress as external.
Some details :
-Internet is provided by a cable (not using telephone, TV or something else from those internet dealers)
-I am alone using this internet, no one else is connected to it.
