Cisco Firewall :: Move Some Configurations Over To ASA5510?

I'm trying to move some configurations over to an ASA5510 and some of the commands are a bit different than I'm used to (worked on old pix before)
 
I've configured the following on the device:
Outside interface:  65.66.64.34/28
DMZ                  :  65.66.64.49/28
Inside                :  10.2.3.3/26
===========================

The current firewall has the below configured on it (old Juniper)
 
10.2.3.0/24                       gateway 10.2.3.15               **10.2.3.15 is the IP for 3750 switch on the inside LAN**
10.0.0.0/24                       gateway 10.2.3.4                 **10.12.175.4 internal vpn- will remove later but thats a different discussion**
0 0                                    gateway  65.66.64.33            **to internet
10.0.1.0                            gateway 10.2.3.2                 **10.2.3.2 represents mpls traffic

[code]...
 
The current set up for this network has an mpls router and a vpn concentrator as part of the network my aim currently is to replace the juniper with an asa5510 the changing of the vpn tunnels will be for a different time:

work station ===>  switch (3750) DG to =====> MPLS (vendor owned and managed) ====> non mpls traffic ====> vpn concentrator ===>firewall ===> router
 
The above will need acls to go with the routes, which I should manage ok just want to make sure the routing is configured properly