Way To Find IP Address And Hosts In The Network
May 23, 2012Do you have any suggest for network scanning software?Something who can find IP address and hosts in the network?
View 11 RepliesDo you have any suggest for network scanning software?Something who can find IP address and hosts in the network?
View 11 RepliesI need a tool to find all the hosts connected on my network. I need something that will tell me the MAC and host type/name. I ran an IP Address tracker and got all the IPs in use, but that doesn't tell much beyond the IP address. Don't really need to do a full in-depth nmap port scan. My concern about using nmap is it can bog down a router...Although I can't say for sure if there are ways to scale the scan back in nmap so it won't cause any issues?
View 17 Replies View RelatedI have several Cisco switches connecting our network. Switch N connects to the gateway, Switches Y & Z connect to some hosts. Switch N connects to Y and Y connects to Z. Assume our gateway IP is a Class B address with a netmask of 255.255.254.0 and all the hosts attached on switches Y & Z have static IP addresses assigned to them. This gateway connects to the internet.In addition to this IP address, some of the hosts also have a second IP address assigned to the same NIC. This IP is Class A (10.0.###.###) and have a netmask of 255.255.0.0 A second gateway address is not defined.
The hosts that have 2 IP's bound to their nic, use the 10. address to communicate with each other. (Programs running on the hosts are specifically configured to use 10. address).I have several questions regarding this setup:
1) Assume Host has only 1 IP (Class B) - if the destination is on the same network, does the host system send the packet to the gateway first to find the destination on the network or does the host send a "where are u" packet to the broadcast address to find the destination?
2) Assume Host as 2 IPs (Class A & B) - if the destination is a 10. address, how does the host go about finding it?
Since there is no Gateway defined for the Class A address, does the host simply send out a packet to the broadcast address for the Class A network? or does it go to the gateway defined in the Class B network as it was defined first (i'm assuming primary connection)
3) Assume Switch N's connection to Switch Y is disabled - how will this affect communication between hosts on Switches Y & Z that have a 10. IP trying to share data with each other, using the 10. Address. If the answer is this should not affect it, what additional circumstances are required that may cause the systems with a 10. address to be unable to communicate when the connection from Switch Y to N is terminated?]
Our copier has been cabled to our network but the copier company cannot install the printer driver without the IP address. Where do I find this? We don't have an IT dept.
View 3 Replies View RelatedNew install discovered router and switches at same location with no issues. However when running an acquisition on those switches most fields are populated except the ip address of end host associated with port. Mac address, port speed, etc. but no ip address info on per port basis. Using snmp v3 if that makes a difference.
View 10 Replies View RelatedI have just started to use an ASA 5510 for my network. I use the DHCP server on it and after i made the change over to ASA hosts started loosing their IP address. This was not a problem before on my old firewall that aso had the roll of DHCP.
Is it possible that something is wrongly sett on the asa? All traffic is flowing normaly when this does not happen.
Information:
Lease length: 172800
address pool: 134 addresses
hosts: around 45 + mobile units 45
How can I find my IP Address number on my wireless router. I'm trying to connect my blue-ray player for the Netflix.
View 1 Replies View Relatedhow can i know my neighbor's wifi network password .i already know his computer ip address?
View 3 Replies View RelatedI have a PC upstairs, let's call it (Peter-PC), my dad has a PC downstairs (Kris-PC) and I just setup a linux home server downstairs as well called (server).Now, Peter-PC is connected through Linksys powerline adapters to the router, and server and Kris-PC are connected directly to the router as well.Peter-PC stays constantly connected to the internet, only until Kris-PC is turned on, then Peter-PC connection goes mental and begins to disconnect, reconnect, can't ping the router. As soon as Kris-PC is turned off,Peter-PC is back to normal.However, if Kris-PC and server are both on, they both operate fine. Seems like Peter-PC is the only unfortunate one.I mean the powerline adapters have been working for over 3 years now, and the Powerline light is flashing meaning they are communicating, I highly doubt it's the adapters.
View 18 Replies View RelatedI'm just new with ASA. I'm just self-studying on it. I was tasked to have an ACL that will allow inside hosts to access a specific network. Is there a way on how to know all the inside hosts on the behind ASA so that I can do a "object-group network" on those inside hosts which I think it will look neat.
View 1 Replies View Related1. To specify static IPs for components on my network, is it simply a matter of reserving each component in the DHCP Reservations List portion of the Network Settings page?
2. On the same page, in the DHCP Server Settings portion, if Enable DHCP Server : is deselected, does this mean that only the hosts specified in the DHCP Reservations List can access the network? In other words, is access now restricted to these entries?
3. If the DIR-615 is powered OFF, will the above settings, etc. be lost (similar to a reset)?
I'm migrating our network objects from our current firewall to a new ASA 5520 configuration. I'm using ASDM 6.4 for configuration.
We have a range of IP addresses for hosts that we need to add to a firewall rule/ACL. In the previous FW software I could create an object that was a range of IP address. For example there is an object called emailservers that is defined as 192.168.2.25-192.168.2.50.
Is there a way to do a similar thing on the ASA 5520?
I can see how to create subnets, but in this case I only have a range of IP addresses, no subnet mask.
I can't connect to the internet on my laptop. When I tried to reconfig, it says I can't because media is disconnected.
View 1 Replies View Relatedfind host by MAC Address
View 1 Replies View Relatedhow can i find my friends ip address
View 1 Replies View RelatedI have been working nicely with an industrial scanner that runs on Linux, but the harddrive has become corrupted and I need to get it working again. The problem is that the main PCB has a realtek chip which I believe has the most basic webserver abilities that is used in the most basic way possible. To use it ARP commands were used to assign an IP address to the chips MAC address e.g. something like: arp -s 192.168.2.5 00-05-a4-00-a8-f8(the actual MAC address was lost along with the HD)So now I'm starting from scratch in XP, how do I find the MAC address in the first place?
View 4 Replies View RelatedI have a Zyxel storage box. How do I find it's IP address if I have it's MAC address? I am trying to connect to it but don't know the IP.
View 4 Replies View Relatedi need to find the ip address for my xbox
View 1 Replies View RelatedHow would i find a "server address"? It is for an app i downloaded on my phone, the app is for my job...it allows me to view my schedule, punch in/out, request time off, etc..Our company (lowes) uses Kronos, which all of our scheduling, payroll, etc is all thriugh and they came out with app but you have to have "server address" We are on the Workforce Central 6.1 Version Suite.. I tried finding it while at work yesterday with no luck, I only found site address of which I couldnt even pull up here at home.
View 2 Replies View RelatedHow to find ip address on my hp photosmart printer
View 1 Replies View RelatedIn the run box I enter cmd and hit enter. It got me to the command promt and I typed in ipconfig/all and hit enter. It displayed Windows IP Configuation but nothing else except another C prompt. Windows XP version 5.1.2600 What next?
View 8 Replies View Relatedcant find server name for address...(server) : time out..15 nod is join to server(win2008R2) but new of nod is join for network error : computer name change....Note: This information is intended for a network administrator. If you are not your network's administrator, notify the administrator that you received this information, which has been recorded in the file C:WINDOWSdebugdcdiag.txt.An error occurred when DNS was queried for the service location (SRV) resource record used to locate a domain controller for domain puya.org.The error was: "No records found for given DNS query."(error code 0x0000251D DNS_INFO_NO_RECORDS)The query was for the SRV record for _ldap._tcp.dc._msdcs.puya.orgFor more information
View 1 Replies View RelatedI can usually solve most problems given enough time but after 4x hours work I have admitted defeat.I need the Mac Address of my Wireless printer so I can set mac filters for our laptops and printer.The printer is an HP F4500 all in one wireless printer.I managed to find out how to print a configuration page but there is no ip or mac address on it.Tried Ipconfig /all on the laptop and it only lists the ip and Mac address of the netbook.Phoned HP twice. wasted half hour being transferred all over the place then told to check their tech website. Nothing on their website about obtaining mac address naturally
View 8 Replies View RelatedHow can I find the name of a remote unix server if the client can only provide me the ip address which they use to connect?
View 5 Replies View RelatedI have an iPod 4G running iOS 5.0.1, and have accidentally downloaded an app that runs on 4.2.1. This messed up my iPod's screen calibration and dimensions completely, and I need to boot it in safe mode to fix it. All that I need is to SSH it, but I can't get its IP address, because I can't do anything on it! How do I get my iPod's IP address to SSH it?
View 2 Replies View Relatedfinding my photosmart c 2700 ip add that i need for magicprint
View 1 Replies View RelatedHow can I get my computer to find it's IP address and connect?
View 2 Replies View RelatedI'm trying to wirelessly connect my HP Photosmart printer series C4780 to my mac osx even though I have the disc it is now asking me for the ip address, this doesn't seem to be anywhere on the device.
View 1 Replies View RelatedHow to find the mobile number from Name and address of the person.
View 8 Replies View RelatedI can't find wins server,where is situated?
View 1 Replies View RelatedI want to know IP address ,If I know hostname {OR} I need to know hostname,If I know IP address.
View 2 Replies View RelatedI can find ip address of any website from domains by using simple command [URL] in command prompt.I wonder how I can find the domain names from ip addresses.For e.g. I would like to know the domain names of ip - 207.232.22.200
View 7 Replies View RelatedHow to find the location of a device by using mac address of that device.
View 2 Replies View Related