Wireless ArtNet DMX Control?

I am currently at a standstill when it comes to our desired set up for the following:Originally we purchased an iPad app called Luminair, which works as a DMX board. The idea was to be able to control a set of light fixtures hard lined into a Linksys WRT54G router, which would then allow us to control the lights with the iPad and the Luminair App.After quite a long time and a lot of different settings, I've found myself at this point:We recently were able to connect and control our lights from DMX Workshop, an application running on a Windows 7 64bit connected directly to the fixture through a standard ethernet cord. Both the computer and fixture are set at a 2.x.x.x IP address and a 255.0.0.0 subnet. To allow the two systems to connect andw work with each other, the speed had to be throttled from 100Mb to 10Mb.

I've now tried to introduce the Linksys WRT54G router in between the computer and the fixture hard lined with ethernet cables. My hope is to establish a connection with this setup, and then swap the computer for the iPad.Is it possible to set up the Linksys to a 255.0.0.0 subnet? And do you think it needs to be at this subnet and a 2.x.x.x IP to allow it to work?Also, is it possible to throttle the speed in the router to 10Mb as well, because if it is trying to connect at 100mbps, I am confident it will not work.