I am having a terrible time getting a good signal from my DLink-DIR655 router to my Samsung HDTV with a linkstick to have access to the apps like Netflix. My router is located about 60 feet away but the signal is sufficient to connect to my laptop located in the same room as the tv. I have been told the router should be no more than 20 feet from the tv and have tried a DWL-G710 range extender but that doesn't work.
View 1 Repliesunable to set up wi fi connection on my samsung laptop model no NP300E5Z-A01IN.
View 1 Replies View RelatedI have problem connecting Samsung (series6) TV to DIR-600. TV wired connection does not work with DLINK DIR-600 150. Is there a work around ?
Config :
DIR 600 is working in access point mode
Check list : Cat-6 Patch Cord - works (brand new works fine with laptop)TV network port - works (works fine with aztech ADSL/Switch)
My laptop has a very unstable connection and I am completely stumped. I've monitored the ping and it is usually around 32-50, but it constantly spikes to 3k+ for roughly 10 seconds, it also disconnects at random intervals. I've tried updating the networking drivers, disabling firewalls and changes the preferences.
I have a Samsung Series 7 Chronos running Windows 7.
a new samsung galaxy y phone and am unable to open websites using my wifi network my modem is mtnl 450tc1. my phone shows that its using 192.168.1.2. no changes can be made to dis option My phone shows that it has been conected to the wifi but it does not loads the websites
View 1 Replies View RelatedI'm having trying to connect my Samsung Smart TV to the Internet.I purchased the Samsung EH5300 yesterday and have connected it to my router (ZyXEL P-660HW-T1) via Ethernet. This works fine and picks up all the settings (ie: IP address, gateway etc) automatically and I can connect to the Internet fine.The problem comes when I then connect any device to the router using Wi-Fi - this could be my iPad, iPhone, PC, laptop - anything will disconnect the wired TV connection immediately from the Internet but it DOES NOT disconnect it from the network. In other words, I can still see the TV in the list of devices on my router and still ping the IP from my PC. All the settings on the TV remain the same but when running the network test, it says it is connected to the network but not the Internet.I have disconnected all cables, reset the router, turned everything off and on several times, placed the Ethernet cable in different ports on the router, manually input all the IP addresses etc but none of it is working.
View 6 Replies View RelatedUse Samsung galaxy y s5360 Wi-Fi connection without wireless video?
View 1 Replies View RelatedHow do i configure my netgear router to my samsung blu-ray player to allow wireless connection?
View 2 Replies View RelatedI have a Samsung Galaxy 10.1 tablet and have bee trying to connect to my WRVS4400N router with VPN through the "on board" software as well as with the Any Connect software from Cisco. I have no issues at the moment using Quick VPN from my laptop.
When using the Any Connect software I receive the following messages:
Security warning: untrusted certificate
AnyConnect cannot verify the identity of <IP address>. Would you like to continue anyway?
- Certificate does not match the server name.
- Certificate is from an untrusted source.
- Certificate is not identified for this purpose
[Accept] [Details] [Cancel]
If I select accept, the following error is received:
"Error: Connection attempt has failed due to server communication errors. Please retry the connection".
I have tried setting up the on board VPN with the Samsug Galaxy but every attempt has resulted in a time-out of the connection.
My data usage via my ATT dsl link has gone over the limit for the past 2 months.
Perhaps a neighbor is using my connection?
I would like to set a password for my dLink connection.
I was assisting a friend by trying to set up a wireless password on their network, I have no clue why they didn't have one, and when it did the normal resetting machine protocol after the password setup we lost all internet, we can connect to the wireless network fine but it has no internet. The modem has internet connection as when I link via ethernet I can connect to the internet. DHCP is not enabled on the router, I'm not sure if I have to set that setting on the modem? or frankly how to do that either.
View 7 Replies View RelatedRegion : Argentina
Model : TL-WR740N
Hardware Version : V1
Firmware Version :
ISP :
Region : UnitedKingdom
Model : TL-WR740N
Hardware Version : V1
Firmware Version :
ISP :
Am trying to use a TP-Link TL-WR702N to connect my Samsung SmartTV to a wireless network, using "client mode".For some reason, the TV refuses to accept it is connected, or even connected to a router. Enabling DHCP on the TP-Link does seem to convince the TV that it is connected to a router, but still not to the internet. Strangely though, I can control the TV via the Android app operating on the local network, so clearly it is connected. I assume the SmartTV is trying to get a response on the local network that the TP-Link is filtering out for some reason, but no idea why.
I'm trying to connect our ASUS VIJ series laptop to a dlink DIR-615 wireless router. The router connection page asks us to: "Please enter the PIN from your wireless device and click the below "Connect" button". How to find the PIN number for the laptop? The laptop uses a wireless g connection. The laptop can find the dlink router's signal on the wireless profiles & has been connected wirelessly in the past to a router (a plug & play type) without a problem.
View 7 Replies View RelatedI'm on a Virgin media 50 Meg connection currently connected via cable using the modem provided.I'm hoping to connect my PS3 to the internet using the router provided (dlink DIR-615) and I'm wondering if I'll still get the same speeds if I connect the cable through the router. I hear that the wireless data transfer won't be able to handle 50 Meg but if I attach a cable from the router to my PC will I still get the full 50?
View 1 Replies View Relatedmy internet has been acting slow, i have a dlink router 615 and high speed comcast internet
View 4 Replies View RelatedI am using an old DLink router, DI-704P. However, the router has randomly started to drop the connection quite regularly. The status lights on the router all indicate that it's working properly.
View 1 Replies View RelatedI have my first notebook connected to D-Link DIR-600 and its working but i am trying to connect to second notebook, can not connect to internet.
View 2 Replies View RelatedWe have a dlink DIR 615 router that keeps dropping the internet connection. I checked with our internet provider about the connection and it is fine. The desktop has no internet issues just the wireless devices. We run a laptop, iPod, cell phone and tablet. Everything was fine until we added the phone and the tablet.
View 3 Replies View RelatedMy wireless connection randomly drops, or has no Internet connection, or says it has connection and Internet but no web pages load. Usually, what happens is it says I have no Internet connection. I have to disconnect and reconnect to get the Internet back. My ethernet connected computer never loses connection.
I am running Windows 7 with a Realtek wireless card. I have updated the driver to the latest. The wireless router is a D-Link 615 e1 using DD-WRT. The router is hooked up to a Brighthouse Arris TM402G/110 modem for internet access (note: this is my second modem. I had the same problem with another modem. Unfortunately, I don't remember the name.)
When the router is connected to a U-Verse 2Wire 3800HGV modem/wireless router (with the wireless turned off) I have no Internet disconnections. Everything else is the same (I just move the Ethernet cable between the two modems). Of course, one is just a modem and the other is a NAT router/modem.
I noticed that the wireless connection has a weaker signal when connected to the Brighthouse modem then when connected to the U-Verse modem. I therefore tried to up the TX signal strength on the router. This improved the situation (and the signal strength) but I still get disconnects. I also tried setting the MSS to 1492.
I have two computers linked to our d link wireless computer, i am trying to connectmy childs computer but it dosnt even come up as a available connectionThe wireless button is on, why it dosnt come upas an available connection
View 1 Replies View RelatedWould like to set up a secure internet conection and I found out that can be done though the D link, but not sure how to do it free.
View 1 Replies View Relatedthe modem is open.the router also is open but dont have internet access.
View 1 Replies View RelatedDlink Dir-657 keeps losing internet connection on wifi devices only . the connection remains to the router but no internet .if I disconnect the connection i am unable to reconnect to the router until i reboot it. My internet remains on my network cabled devices .I am running on an empty channel 3 , usually happens 20 to 60 minutes after the router is up . Dlink sent me a replacement refurbished one and this one is doing the same thing . I owned the original one for about 5 months with no problems at all ,no new electronics in the house and have not changed the placement of the router .
View 4 Replies View Relatedi have my pcwhich doesn't have wifi capabality so i purchased D-Link N 150 Wireless USB Wifi Adapter,it possible share internet to my phone via wifi adapter.
View 1 Replies View RelatedI am puzzled about some problems that occured at my work place. Unmanaged switch like D-link & Linksys was used and it worked pretty fine only for certain areas of the factory. Then office with more workers will be using managed switch to ensure the workers have decent connection to the local server.
Question is, why are some small offices' connection so ridiculously slow?
*Info*
The switches manage 4PCs
Tested - The main connection cable cannot go through the switch to distribute the connection. Even if there is only 1 PC linked to the switch, it will still be slow. It will be at it's max if it didnt go through the switch, but directly to the PC instead.
True enough that unmanaged switch aren't smart enough to allocate the speed, but why is it possible for some other part of the small office to have fast connection even by using the normal unmanaged switch?
I have a DLink D604T wireless modem. It has been working fine for the past 5 years but today the connection to my netbook computer kept dropping out.I can fix it temporarily by going into Network Connections, right clicking the modem, selecting wireless networks, clicking the modem, going to properties and retyping the network password. I then have to set the firewal to advanced connection settings and typing in my family network password, and changing the Windows firewall settings from On to Off.However, the connection drops out again after just a few minutes. If I then turn the firewall back on, it comes back on again for 5 minutes, but then drops out again. Then I have to repeat the whole process.
View 1 Replies View RelatedI have been putting up with rubbish wireless signal down one end of my house now for quite some time. So I thought I have a spare wireless router and I could put it down there but I am sure ts not as easy as just plugging it and away you go.
Network Setup
Router 1 is a D-Link DIR-655
Router 2 is a D-Link DI-524
I need to know how to setup Router 2 so it basically become just a wireless access point
I am trying to set up two routers so that I can offer free wireless connectivity via three AP's in three adjoining rooms on a first floor and secured wireless and wired network connectivity in upstairs offices. The setup is like this:
Verizon DSL connectivity..static IP
The gateway modem/router is a Verizon DLink DSL 2750B with three ports connecting to three wired Access Points in three first floor adjoining rooms, and the 4th port connecting to a Cisco E1200 (wireless and ethernet router) located next to the Verizon Dlink. I would like the Verizon DLink to give open wireless connectivity via the access points and also connect to the adjacent E1200 router.
I would like the Cisco E1200 to offer secured wireless and ethernet connectivity to the upstairs offices. (connecterd to the Cisco E1200 is a 24 port Netgear switch.)I have spent considerable time talking with Verizon and Cisco/Linksys but have not been successful in just how to set this up.A former tech actually did have this setup but for what ever reason the settings were reset to factory defaults with no written record as to the necessary settings.
How to connect net to pc on samsung Monte
View 1 Replies View RelatedHow to configure VPN on Samsung Star Next ?
View 1 Replies View RelatedMy Samsung UN46C7000 will not connect to my wireless internet. It was connected in the past, but when I go through the test, it fails at "IP address, Subnet, Gateway, DNS Server Test Failed" I have done the typical reomve power from router/wireless combo, wait 30 seconds, plug back in.My other wireless devices connect to my wireless network with no issues. I even disconnected one and reconnected just to verify I had my security code correct.I saw something from Samsung that says DHCP needs to be enabled, but I believe this is disabled on my router and not sure how to change it.
View 1 Replies View RelatedI have been bought a samsung tab 2 7 inch and it cant find my router , it find's others on the street but not mine . I have and android phone and thats ok.
View 3 Replies View RelatedI have an Apple time capsule and Samsung Smart TV. I set up the wireless connection, checked the status on the TV, connected. When I try to open something in the Smart TV, it says I'm not connected.
View 1 Replies View Related