Belkin F7D1101 V1 Basic Wireless USB Adapter Not Working?
Sep 14, 2012
while my younger brother borrowed my USB adapter to fix somerhing on his computer (he normally doesn't have net), I was using a flash drive. I had left the drive in, and my (very heavy) DVD drive was dropped on it, breaking both the front USB 2.0 ports and the flash drive. So I had to put the adapter in the back ports. The first few hours were fine, then net cut out. I repaired the connection, only to have to keep repairing every 30 seconds to 10 minutes. Then it stopped working altogether. I've attempted re-installing drivers, but when I do, my computer tells me that the driver I'm installing from my hard drive "Has no information on my hardware", but it's the correct driver and version for my hardware.
Recently my desktop has experienced very slow download speeds (~0.11 Mbps), however the upload speed appears to be in line (~2.0Mbps). These numbers are taken from Comcast's speed test (my ISP). It is obviously a problem with my PC because everything else on the network (PS3, Laptop) have great signals with no problems. I just recently reverted the Desktop back to its factory state, and everything was working fine for a couple of months. The desktop in question uses Vista 32-bit and the Belkin Basic USB Wireless Adapter.
I have a Belkin F5D7050 USB Wireless G network card and it won't connect to windows xp. It tried using on Linux (ubuntu 10.04 live cd) and it works perfectly. But when I boot into windows, it doesn't. I have installed all the drivers and software I could find for it. But the programs for it don't open at all and for some reason i cant even configure it using windows "Connect to". (You know how usually you get the little wireless icon at the bottom of the screen and stuff)
after going through the several troubleshooting steps (un/reinstall driver; download a fresh setup; comb thru all network and internet settings; multiple cold re-boots; system restore etc.) While the adapter shows up in device mgr, only getting error msg that there is a problem with the driver.Did try several ways to find out where the hang-up was, and only get the driver error.Using Windows7 Home Premium-all updated.Was using my ethernet to my LAN previously.
My neighbor is using my Belkin Router the basic one and has comcast. We both use his internet and have had no problems until the past 3 days. He just got the home phone service from comcast and the phone line is setup through the modem. Ever since comcast came to his apartment and set this up the home phone service to his modem the router is connected but there is no internet access. What is going on and how can I fix this. He has an HP with windows Vista and I have a Toshiba Satellite L675 that has Windows 7 Home premium edition on it.
I just bought a new Belkin N750 USB wireless adapter today to replace my old cisco USB adapter well I install the drivers and software that came with it and everything loaded correctly and showed that there was connections available.Where I live we don't have access to the routers as the are controlled by the rental agency and I can't get access to them. But anyways I can connect to the networks with my old usb adapter but not with the new one. My computer is Windows 7 64 bit.
I have a question about my Desktop and the Belkin Wireless adapter that I am using for it. There seems to be a problem with my internet connection and I can't figure it out! I'm suppose to have speeds up to 18mbps and I'm only getting up to 5mbps on my Desktop. Now, here's the weird part...when I connect to my wifi on my laptop and cell phone it gets 16mbps. Why this is only happening to my Desktop??? I have the latest wireless adapter driver installed and everything. Is it the adapter or my system??
Wireless Adapter: Belkin F5D8053 N Windows 7 Home Premium
Upstairs I have a Century Link modem/wireless router. My wife and I use our laptops, smart phones, and XBox 360 on the wireless network. Downstairs I have an older Dell PC that I use for my business. I have an Ethernet run from upstairs to downstairs. The Ethernet jack upstairs is near a cable outlet because we used to have cable internet. Now we have DSL and the phone jack is on the other side of the room. Here's my question... I have a Belkin N600 wireless router, is there any way I can plug it into the Ethernet port on the other side of the room, and use it like a wireless adapter? I have tried a few time to set it up as an "access point" but it doesn't seem to work. As soon as I do, I can no longer access the Belkin router to make any changes and I need to do a manual reset. can I plug my downstairs PC into the Belkin N600, and have wi-fi internet access from the wireless modem/router upstairs?
I have recently installed a TWC Ubee modem/router combo and have networking a laptop and another PC (this one). The holds a constant internet connection. The PC using a Belkin Wireless G network adapter card is frequently losing connectivity to the internet.
I am attempting to set up a wireless connection on an HP desktop that runs Vista. I recently purchased a Belkin N150 Wireless USB Adapter (Version F9L1001). My computer, first, will not run the software CD automatically; I have to find it and double-click on it. Then, after the drivers are supposedly installed and I restart according to the instructions, my computer is unable to find them when I plug in the adapter. Additionally, when I try to start the driver program myself, it refuses to go. I have uninstalled and reinstalled the driver software four times and I have gotten the following same results every time. Also, I do not have a router installed yet, as we were told initially that all we would need to use to connect the desktop to our wireless Internet was the adapter
My USB Belkin Wireless G Network Adapter seems to disconnect whenever I remove another USB device (usually a memory stick) from the PC.The problem started when I accidentally updated the driver via Windows. It didn't seem to work at all with this updated driver and I couldn't roll back or do a system restore to fix it. I'd done this before and ended up doing a complete re-install of Win 7. This time I did an upgrade install and the driver problem was cured.I'm running a HP XW8400 with Win 7 64 Pro which has been faultless for the 5 years I've had it.The only other change I've made recently is that I've stopped using a D-Link USB hub and started using the USB connectors on the HP LP2465 monitor.This only affects the wireless and no other USB devices.
When it disconnects, Win troubleshooting goes through the motions and reverts to LAN and doesn't see the wireless USB at all. This also happens if I don't use the troubleshooter.Device manager shows the driver to be working, but the wireless USB doesn't function even if I connect it directly to a USB port.The router is still working as all other devices in the house are connected.The only way around it seems to be a re-boot, but when this fault happens the PC gets stuck at "Shutting Down". Without the fault, re-boot or shut down works fine.When it happens I have to power off and on. This usually works fine but every now and then I notice the device driver for the Belkin is disabled.I've found a workaround in that I can take out the Belkin USB before removing another USB device. After the USB stick or whatever is removed if I then reconnect the wireless USB it reconnects fine.
my netgear wireless router cannot see my n300 usb adapter. it shows as working in my device manager, but the netgear router says wireless not connected. when installing the adapter it said that windows has an icon to the left of the taskbar that i can click on and ask to join a network, which it didnt. it just showed network and an option to open network and sharing center, which i did. there were no wireless networks that showed available for me to log into with the adapter
I recently purchased a Belkin F5D8053 N Wireless USB Adapter after my 6 year old adapter was unable to see my home network in the network list.
I installed the software but the adapter wouldn't connect to my home network so I reinstalled and updated the driver, still wouldn't work. Finally about 2 hours later it just randomly connected. Now it has been frequently (1-2 times a day) losing connection to my home network for around 3 hours, it can see a dozen networks in the list with full signal strength but won't connect to any at all then connects to my home network again several hours later.
I have switched between the Windows connector and the Belkin one and tried all 6 USB slots with no luck. I contacted Belkin support and they told me to try the device on another computer and see if the problem still happens but I don't have another computer to test it with.
I suspect this is a problem with my Windows installation rather than the hardware or router as my old card would freeze once every couple of days and was only fixed by powering off my computer as Windows was unable to kill the process to restart it.
having a problem with my Linksys wireless adapter: the light will flash a few times when I plug it in, then it will turn off. It won't let me connect to the internet or my printer.It's not the port: it is recognized when I put it in any other port, but it still won't connect. I think it's a virus, but my antivirus software isn't showing anything when I run a full scan (I use Malwarebytes Free). I'm gonna put AVG on a flash drive from another computer and try to use that later today, but right now I've been thinking that I might have to back everything up and reinstall windows.
-Windows Vista- Home Premium
-Linksys Wireless USB Network Adapter (I think it's WUSB600N, not sure though)
Everytime i plug the cable into my PC it doesn't detect it and the helper says to insert an ethernet cable.When I go to network sharing centre and check my connections it says network adaptor unplugged.im using wireless at the moment.My pc is a packard bell ipower x9810. it was windows vista but i upgraded to windows 7, i checked the packard bell website and can't find any networking adaptors. I have also checked device manager and it says - Belkin N+ wireless USB adapter #4 NVIDIA nForce 10/100/1000 Mbps Ethernet. there is no yellow exclamation mark.
I can't find the correct driver for Belkin F9L1101 Version 1 USB Wireless adapter. When I went here [URL] and installed the software my Windows 7 Pro w/64 bit does not recognize the adapter. When I go to Device Manager it does see the Belkin under other devices. When I choose the folder the drivers are located /program files (x86) it says it can't find the driver in that location.
Wireless Adapter D600 USB needs to connect to the internet to finish installing... Problem is, I bought it because I can't get my ethernet port to work on my desktop. It worked find in Windows 7, but Windows 8 needs more information.
F9L1101 N600 DB Wireless Dual-Band USB Adapter : recognizing and connecting to wireless network but unable to use internet. Changed static IP adress, etc but no luck. Followed instructions on support email response:
Windows XP:
Start->Control Panel->Network Connections(classic view)->Right click on Local Area connection(wired)/Wireless network connection(wireless)->Properties->Select Internet Protocol(TCP/IP)->Properties->Under General tab, choose "Use the following IP address" and type the IP address, Subnet mask and Default Gateway, DNS and press OK. Type in the ip address 192.168.2.20 Enter the subnet mask as 255.255.255.0 Enter the default gate way as 192.168.2.1 Type in the primary DNS as 4.2.2.2 Type the alternate DNS as 8.8.8.8
Am currently unstalling and reinstalling. The network is WEP with a long alpha numeric key, which was accepted and network detected and connected. No internet. No internet. No internet.
how to download software and drivers to a belkin usb wireless adapter with no internet on that system and i need that system really bad.and i dont have the cd my friend gave this to me?
I just bought a wireless adapter for my PC, linkseys ae1000. It's been approximately a week, and the computer has been on most of the time...roughly 8-12 hours of a day, not in use the whole time, however. Then today when I booted up my computer, the wireless adapter didn't turn on! It's like a little USB thingy...and when i took it out, it was extremely hot, even though it wasn't doing anything! I tried multiple USB slots as well, to no avail...What basically happens is I put in the CD-rom installation disk, then when it prompts me, I plug in the adapter...and then it takes me to the connect to network screen, at this point the adapter has it's little wireless light blinking, then I try to connect to network, the light stops blinking and turns off, and it just tries connecting to the network for an eternity.
I just purchased a Medialink MWN-150N Wireless N USB Adapter. I have never had wireless on this computer and I have always been hard lined directly to the router without any problems of connecting to the net. I installed the software, am able to connect to my network with full bars, but have limited/no activity. I unplugged everything and hooked up the modem 1st, router 2nd, and turned on the computer last, but no luck.
bought this wireless adapter. installed drivers and everything but it doesn't work. when i plug in the device, the network icon in the system tray doesn't change. it won't let me choose any wifi signal. tested it on other computer and laptop and it works no prob. i used to have one before and i remember it worked okay but now it's not working anymore.
above usb adapter first worked fine with windows7 then i used belkin G usb adapter but it is not worked, so again i switch back to 11n usb adapter but not it is not connected?
My roommate bought a Belkin F5D7234-4 V5 router at Walmart and it keeps dropping the internet. Our computers stay connected but the router keeps telling us that it's trying to connect to the internet again. The apartment wired connection is just fine. Right now I'm writing this and the stupid router is blinking at me... Our apartment complex provides internet so I don't have access to the modem, or even know if it's dsl or cable. I've checked the firmware and it's up to date. All the settings are factory pre sets.
I have a D-Link wireless adapter (DWL-G122) that I have been trying to install on a Windows XP computer. After various uninstalls and reinstalls of the drivers and programs that come with it, I have found currently the best way to get it to work is leave the D-Link programs uninstalled and have Windows install the driver itself.The problem is, it doesn't seem to keep the drivers on restarting, so every time the computer is restarted, it must be installed again. This is not ideal.It occasionally worked when I installed from the CD, but the D-Link programs that would install with the drivers created problems of their own.
