Routers / Switches :: Find The Uptime Of An ISP From A Remote Location?
Jan 26, 2012
My boss is asking me to write a batch file or use a utility to monitor the uptime of 16 different ISP accounts that we use across several stores. Most stores have several ISP accounts setup as failover, so they're not always active on our network but the ISP should still be up. He would like this to run from one of our servers. He is suggesting the 'gateway' for the ISP however I am not sure how to find this IP. The tracert utility returns IP addresses which are different than the gateway address in our router settings so I am wary to use those IPs.Which IPs would I ping to monitor the uptime and where would be the best place to find them?
View 2 Replies
ADVERTISEMENT
May 1, 2013
I can get on the internet and surf just fine but when i go to maps or Gas Buddie, or check in with Facebook it says" my device can not be located. Are location services turned on on the device." I have checked on my ipad and location services are on, on everything. I had no problem with the other router I had. I also have a Sprint Airave connected to my internet, but again i had no problem with the other router. The router is definitely faster than my old one and set up was easy but its very frustrating to not be able to find my location.
View 1 Replies
View Related
Mar 10, 2012
how to installs 3 router with same password
View 2 Replies
View Related
Dec 29, 2011
how do i connect two computer together in differance state
View 1 Replies
View Related
May 3, 2012
I'm essentially looking to extend an existing network in a primary warehouse for our company across a parking lot to a secondary warehouse with no network drops. I need to keep the ability to assign addresses in the existing scheme over to two computers in the secondary warehouse.
View 1 Replies
View Related
Aug 23, 2011
i want to find the location of the person who is harassing me in the mails?
View 1 Replies
View Related
Feb 27, 2012
How to find the location of a device by using mac address of that device.
View 2 Replies
View Related
May 24, 2011
how do you find a WPA-PSK for wifi from a laptop? (I forgot mine and cant get into my psp).
View 4 Replies
View Related
Dec 5, 2011
We have a 5508 WLC with WCS and are using 1131AG WAPs. How to determine if there is interference or noise at a remote location without going there with a spectrum analyzer?
View 8 Replies
View Related
Nov 18, 2011
I have a customer which has a main location office and a remote one. Recently we interconnect their facilities using a local ISP service called Virtual Connectivity, which basically is a private network which can be accessed over aDSL or any other data circuit. They are using Cisco 888 routers to interconnect both sites.At the main site the customer also has an Internet circuit (with a Cisco 857 router)and he wants to remove the Internet circtuit from the remote site and provide them access over their main location Internet circuit.At the primary offices, we installed Cisco 2811 router as a gateway to route the Internet and remote network traffic over the required data circuit. Everything is working fine, but we can not access Internet from the remote location over the circuit installed a the main site. I understand this is a routing issue, since the traffic hits the main office network it does not knows how to reach the Internet. I am assuming this routing must be set into the main office Cisco 888 router (installed by the ISP to interconnect to their private cloud) in order to properly route it over the Internet circuit.Since I already have access over the Internet router and the gateway router at the main site, but not into the ISP router, is there any other way I can make this configurtion over the routers I already have access?
View 3 Replies
View Related
Jun 14, 2011
How to connect laptop#2 to wireless router when you donot know security key code?
View 2 Replies
View Related
Aug 19, 2012
Someone hacked into my computer through my Netgear router. They took over as Administrator and setup a Atheros (sp) driver. They pretty much have total control over my computer. How can I rid myself of this hack and protect nyself in the future?
View 5 Replies
View Related
Mar 7, 2012
how can I remote in to my router and I need to get past my router to my pc desktop
View 2 Replies
View Related
Aug 19, 2011
I am trying to connect to my office PCs via VPN and/or RDP. The office uses Qwest DSL and has a dynamic IP address. I use DynDNS.org to keep the DNS updated with the WAN address of the router. However, any attempt to access the network fails. I have tried remote management access (I enabled it on the router) but that fails. I forwarded RDP ports on the router to one of the PCs but can't connect to it. I also set up a VPN server but cannot connect to it either. Something tells me that all requests to myoffice.homeip.net are not getting to my modem/router. I have even tried the IP associated with the name (Yes, I did check that it is correct!) but nothing works there either.
View 1 Replies
View Related
Jan 23, 2011
i have a slow internet but my friend who live canada have high speed internet can use his internet . i do not want use his remote his computer but internet
View 5 Replies
View Related
Jan 11, 2011
I have two locations in the same city and I want to connect them together so I can share files and printers. Each of the LANs has a router and is a simple workgroup. LAN A uses 192.168.1.1 255.255.255.0; LAN B is 192.168.2.1 255.255.255.0. What is the best way to connect these two networks together so I can share printers on both sides? Should I replace the network routers, they are older and definitely could use an upgrade
View 3 Replies
View Related
May 23, 2011
how do i find my routers ip?
View 2 Replies
View Related
Feb 26, 2011
I can't find my netgear password
View 1 Replies
View Related
Sep 13, 2012
how do i find the wps on my linksys router
View 4 Replies
View Related
Jan 12, 2011
i have 3 home computers using the same wireless router. 2 of them have no problems detecting and accessing internet. one computer can access at times, but many times cannot detect network. i have tried restarting my modem, the router, my computer etc. at times, it works, at times it doesn't. at times, it is ok, at other times it is not.
View 2 Replies
View Related
Mar 19, 2011
I have wrongly entered a ip address while port forwarding... and my router seems to not be responding.Meaning whenever I put the Default gateway numbers ,my router does not open.
View 1 Replies
View Related
Mar 21, 2011
I have Qwest router on 192.168.0.1 but my linksys router is hardwired to that router to provide a stronger signal throughout the house. I can't get to the 192.168.1.1 page through the internet. I need to configue the linksys router. Specifically to forward some ports to/for the XBox360 or at least make sure Upnp is enabled.
View 1 Replies
View Related
Apr 12, 2011
Main Site allows communication from Remote Site via VPN to Windows ServerMain Site also has a secondary subnet that communicates ONLY through internet but NOT to the Windows Server.Sonicwall 192.168.168.x is main siteRemote Site is 192.168.0.x connecting to Main Site to access shared folders on serverSecondary subnet at Main Site is 192.168.0.x using Windows XP PC's. They are accessing a linux server at 192.168.0.215 which Main Site has no access to.VPN remote ip's are 192.168.0.x - they can successfully access the Windows Server at 192.168.168.100 BUT NOT 192.168.0.215.GOAL: Want to connect Remote Site to Secondary subnetWilling to make router changes or whatever is necessary to get Remote Site to access Secondary Subnet with the only exception that the Secondary Subnet REMAINS.VPN DHCP is turned off but willing to turn it on.Willing to make the Linux Server 'discoverable' on the Windows Server. Don't know linux at all but another co-worker set it up and can make changes.
View 4 Replies
View Related
Jan 7, 2013
I have a existing wireless setup of 4400 WLC with some AP's connected remotely,now i am migrating the whole setup to the new WLC 5500. All the AP has been registered to the new WLC 5500 except the remote location AP's.As there was no option of giving IP address in GUI of the controller in 4400 WLC, i have changed the controller name and restarted the AP, but even though it is going back to the old controller.
View 15 Replies
View Related
Oct 9, 2011
i provide 192.168.1.201 and port No.8150 in CP Plus DVR . I am able to login through Local system via IE with [URL] after pressing enter key Login window appears. I will type User ID as Admin and password 888888. now i am able to enter DVR and view all cameras. no problemin Beetal ADSL router ( ISP Router) i configured port forwarding as followsIP address 192.168.1.201 and Port No. 8150 both internal & external.Now i got internet IP address through MY IP Address.the IP address is 59.92.67.72 ISPs IP address for my Borad Band.through another internet with different different ISPI open IE and type [URL] got same loging window as in LANagain I enter User Id as Admin and password 888888but shows login failed Message through internet I got the same login window when i tried through LAN, but I am to unable login with a message login failed
View 1 Replies
View Related
Feb 7, 2011
I have just upgraded my AIM and Skype messengers and now it won't let me sign in. I did before with my old versions. It is saying that my internet connection is bad which it is not. I have looked up ports in my Yahoo messengers, Control Panel and Bit Torrent still nothing.
View 6 Replies
View Related
Feb 11, 2011
I have a kindle which was successfully connected to my router at Christmas 2010 unfortunatley some thing went wrong ?? have tried using the long serial number which i assume is the password on router . Kindle is telling me the number invalid try again. I have Sky broadband . The Kindle remembers the SSID; number . i have network key number as well but not sure what im suppose to do.
View 2 Replies
View Related
Mar 2, 2011
i use time warner cable for many year and now it have a problem with " couldn't find a network " i try many way but still no work . 1 i do pull the plug off and plug in ( usually it works ) 2 i brought a new router ( still " not able to find network " ) 3 i plug direct computer to the modem and it work but dns doesn't work
View 1 Replies
View Related
Feb 9, 2012
How can I find my WiFi # to add tablet? I have it on my laptop, Ipod Touch, and don't want to reset # to add the tablet
View 1 Replies
View Related
Apr 30, 2013
I am being told from my remote end I do not have port 22 opened up. I have single port forwarding to SSH 22 and Port Range 22 enabled.
View 1 Replies
View Related
May 29, 2013
While trying to connect to WiFi at remote sites APs, the connection is getting time out.User are getting error as 'Unable to connect to <WiFi-SSID>' The APs at corporate office are functioning properly and user are able to connect to the APs.
Wifi Controller: 2504 Software ver: 7.3.101.0
Authentication 802.1x
View 7 Replies
View Related
Jan 3, 2012
I have a Cisco 678 connected to my ISP (Qwest) using DHCP. This is connected to a Linksys WRT54g router. I also have a home server running for remote access to some files and media streaming. I just installed security cameras that I wish to monitor remotely via the internet.I can access my home files over the internet with no issue. However I am unable to access my cameras using the internet. Looking at my router incoming log, I see my request arriving, but I never get to the DVR attached to the camereas for remote viewing.I enabled bridging on the Cisco 678 but this did not solve the issue.
View 1 Replies
View Related
Jan 20, 2011
I am trying to Port Forward HTTP: 80, but my Router wont let me and it keep giving me this error message Status: Port Range Overlap with Remote Management.I have a NETGEAR CG814GCMR Router, I need to add that port for setting up a Game private server online, but my router wont let me, how to fix it?
View 12 Replies
View Related
