i bought the Dir 615 a few months ago so that my tenants (i have a triplex) can use the net. it's been great. I recently got a new blackberry bold 9700 and I can't connect it. It finds the router and saves it, but I can't connect. Even when I put in the WEP Key.
View 10 RepliesI am trying to understand how WiFi works - I have shaw wireless in my home - does that mean I can connect my blackberry torch using WiFi
View 1 Replies View Relatedwhy my Blackberry wifi doesnt find my pc wireless. I have Blackberry curve 9300 3G. OS 6
View 1 Replies View Relatediphone and android app but no blackberry.
View 3 Replies View Relatedfirmware v.2.21 working well with laptop for 5 years. unable to connect b/b rim playbook last week. tried a couple of sessions with dlink tech support. turned off all other 2.4 ghz devices. would firmware upgrade 3.13 fix this issue?
View 3 Replies View RelatedRegion : United Kingdom
Model : TD-W8960N
Hardware Version : V1
Firmware Version :
ISP : Unforced 9
I am struggling to get my blackberry Z10 to connect to the router.
I have installed the Phone Remote software [URL] on the torch and playbook but am not able to pair them together.The FAQ's and directions have been followed painstakingly but have not any success. My router is knowledge is basic but read through the manual and have been searching the net for answers. I have uPNP enabled and no firewall.
View 2 Replies View RelatedIn my device I am able to browse through & connect to my HOME wifi network ; But after connecting it says 'No Internet Access'.I tried connecting with my SONY Bluray , iphone , ipad , laptops -- everywhere same story.I am able to plug in the ethernet cable directly from modem & able to connect to network.I am not able to open the http://192.168.0.1 -- ( When I am plugged in the modem directly)
Following are my router details
FCCID - KA2DIR601A1
IC : 4216A-IR601
H/W Ver:A1
F.W Ver:1.00 NA
i cannot connect to the internet through wifi but if using cable is ok for me . i don't know why in my house only me (notebook and iphone) cannot connect to the wifi. i have install and reinstall the network driver but it still can't work. This problem is only occur in my house. When i take my notebook to outside, it can connect to others wifi. When i use my iphone to connect , it says that "It is unable to connect to [SSID]".
View 4 Replies View RelatedI have a tp-link TL-WA5210G set as access point
SSID is Awlad Omran
security is WPA2
The problem is that mobiles (Iphone, Android, Symbian) can not connect to the access point, it just say connecting, but nothing happens.PC's can connect easily without any problem.i tried to change SSID and security and did a reset to the device but non of that worked.
I have been using a TP-Link wifi adapter for last two months, It worked flawlessly till a couple of days ago. It just so happened that i turned on my computer and even though the wifi connections were available, when trying to connect this message keeps showing up " Windows was unable to connect to UoC WiFi". I have tried everything from making a new wifi connection to changing usb-ports
FYI I use the same wifi connection on my netbook and android, and they are working fine, so it's definitely not a problem with the ISP.
[code]....
I have installed a TP Link W8960N router and it is working fine using the ethernet cable. I have installed a realtek 11n USB adapter but cannot get it to connect to the router.
I uninstalled and reinstalled the software and whereas previously today it found my router (but wouldn't connect it says not associated) when I search now it doesnt even come up!
Windows device manager says the adpater is working properly
When installing router and adapter I set them both to WPA2 and used the same passkey. I am using Windows 7
Got a problem with the wifi,,because My ipod touch 4g can't connect to wifi,,my router is dlink how to fix that? my android phone can't access the wifi,,just my ipod that can't connect,,already use wep n unsecurebut still the same
View 1 Replies View Relatedi've just a D-Link DIR-600 router last month and i successfully installed it and its working great. Until 2 to days ago, my brother told me that he can't conlnect to the wi-fi. I said that its working just fine and told him to just reset his phone. And then, my sister also told me that she can't connect too. I checked their devices like iPhone 4S and iTouch and it says "Unable to join the network....... Also phones of my friends can't connect also. It was just working fine. I haven't changed anything on the router's configuration. I already reset the router, unplug then plug it and its still not working. The router is connected to my laptop and I can still browse the internet. Its the wireless connection that is not.
View 5 Replies View RelatedHow i can connect to my 5ghz wifi through my xbox ?
View 5 Replies View Relatedi want to conect my Dir 655 as Wifi to my LAN, i had a fortigate 50b as DHCP and Dlink Switch 10/100 as LAN Switch when i trie to conect the DIR 655 i disable the DHCP, UnP and Firewall. i put a local IP to DIR "192.168.0.221" and the fortigate has "192.168.0.23" then connect the dir to fortigate by LAN Port... when i trie to access via WIFI, dosent work..
[URL]
I had a TP-Link WR841N router which I replaced with a D-Link DIR-615 today. Before the replacement all my laptops, home desktop and my tablet would connect just fine. After the switch, all machines except the tablet connect to the Internet. My tablet shows that its connected to the router but I cannot access the router admin pages or the Internet. All settings on the DIR-615 are the same as the TP-Link one.
View 2 Replies View RelatedRegion : India
Model : TD-W8151N
Hardware Version : V3
Firmware Version : 120530
ISP : BSNL
Net is working smoothly from LAN, but no success on wifi. Over wi-fi, I can connect to router but cannot access net.
I cannot get the camera to connect to our wifi via WPA2-PSK:AES, which is what it runs. The network /SSID is visible in the setup, but it won't connect and get an ip. I see no error messages or any kind of information at all in the admin web page.I've upgraded to firmware 1.05
View 2 Replies View RelatedMy internet speeds are 45 Mbps DL and 1 Mbps UL and my various wireless connections (3 laptops in my household) were achieving speeds anywhere from 25-40 Mbps DL. My router started acting up and wasn't letting anyone connect via wifi so I did a factory reset and set it up the same way I did before (as best as I could), it started working fine again but now the speeds on all the devices that are connecting to at are capped at 18 Mbps. A simple speed test shows that no matter what they won't pass 18 Mbps, I am almost 100% certain this is the router and I was wondering what I might have done wrong or what is causing this.
View 5 Replies View Relatedhow do i connect two wifi routers to increase the range. One router is a cisco WRT120n and the other router is a d-link DIR524..
View 1 Replies View RelatedRegion : Canada
Model : TL-WR1043ND
Hardware Version : V1
I was wondering if it is possible to connect two routers through wireless and make them talk to each other. Here is why I need it, I currently Have 6 wireless IP Cameras going too 8. 2 are wired on one router in my house and the other 4 are wireless(with wired capabilities) Im going to wire the other 4 too a 2nd router so the cameras are always running and don't suffer any down time due to signal loss (happening a lot at the moment). How can I get Router B to talk to Router A, so I can look at all of the cameras from Laptop in my house which is closer to Router A.
My Router A is TL-WR1043ND, I'm also going to probably buy another one. How to configure it properly. So I can login to the cameras from my laptop.
Region : India
Model : TL-WR940N
Hardware Version : Not Clear
Firmware Version : 3.13.27 Build 121101 Rel.38183n
I have bought TP-Link TL-WR841N 300 mbps router. I have 20-25 wireless clients but only 15 wireless clients are able to connect to the router. Is there the limitation on numbers of wireless clients can connect to the router?
how do I link up my blackberry torch And my ps3 with the wifi.I'm not get connected
View 1 Replies View RelatedRegion : Canada
Model : TD-W8961ND
Hardware Version : V2
Firmware Version : 120608
ISP : Distributel
I've just installed this router today, connected physically 2 PCs, a PS3 and a VoIP and everything works fine !
The problem is with the WIFI connection ! my devices see the WIFI network, they connect, but I cannot connect to the internet ...
What settings Should I turn on/off or any config I should tweak ?
I have a TP-Link TL-WN723 USB WiFi adapter attached to my laptop, which runs WinXP Service Pack 3. It successfully detdcts the WiFi provided by my Edimax BR62-04Wg router, but when I try to connect, it cannot obtain an IP address and cannot connect to the network.
- The very same WiFi adapter can connect to other routers without any problem
- Any other device can connect to the very same network provided by my router without any problem
- Using the WiFi adapter with other computers does not work
Thus, it seems that the problem is somewhere between this specific router and WiFi adapter. Here is an interesting detail though:If I try connecting to my WiFi while a LAN cable from the router is plugged into my computer, the wireless connection establishes too. Even if I later unplug the LAN cable, the wireless connection continues to work. But it won't establish the connection without the cable plugged in.Here's what I've already know/tried:
- Rebooting the PC
- Re-installing the WiFi adapter's drivers
- All drivers and firmwares are the newest available
- Re-starting and reconfiguring the router
- Using the Windows client for wireless networking and the client included on the WiFi adapter's CD
- Changing the router's connection type to any available option: Access Point, Station Ad-hoc, AP Bridge WDS
None of these had any effect except for one:
- When I changed the router's connection type to Station Ad-hoc, I could connect wirelessly even without the LAN cable plugged in, and I had Internet access. However, in this case, other devices, such as smartphones could not detect the WiFi connection.
i contact Cisco support. They told me that VPN between a Blackberry and ASA5000 is not supported. Today 14 fév 2013 they don't have any date on when Anyconnect for Blackberry will be available. So we cannot use a Z10 because exchange server is beind the ASA. Protected with the ASA. Apple and Android work well with the AnyConnect and certificat.URL
View 2 Replies View RelatedI am trying to connect to VPN using Blackberry Playbook. how to configure this VPN using ASA 5520.
View 1 Replies View RelatedHow to do tethering using Blackberry 9790 n Samsung notebook NP500
View 2 Replies View RelatedI'm working on setting up my Blackberry Playbook to access the network over our IPsec VPN however so far I have had no luck. I'm also posting this on the Blackberry playbook support forum.
Settings on BlackBerry Playbook
Server Address: My IP Address
Authentication type: XAuth-PSK
Group Username: remote.com
[Code].....
I have an issue when I´m trying to authenticate my iphone&blackberry device with ASA 5520 using certificates. It seems that certificates are working fine, pass the ike phase 1 but never complete the phase 2. When i use pres hared keys everything works fine with both devices.
If you consider necessary, i can provide my current configuration in asa.
My friend was able to access my internet connection via my guest account WITHOUT having to enter the guest password. He was able to connect using a samsung galaxy phone with the android OS. However, when I connected to my guest account using my blackberry, I WAS asked for the guest account password.
View 3 Replies View RelatedI have netgear router WNR 1000 v2. I'm not able to connect to Apple ipod. The password is not been accepted.
View 2 Replies View Related