An older post on this forum told me to remove the adapter's driver software and restart the system. I did this, and it tried to install the software on startup but it keeps failing when installing. Forcing it to look for new driver software resulted in it saying the best software is already installed.
View 4 RepliesYesterday I was on my computer when all of the sudden my internet stopped working. I am using windows 7 and at the bottom right I see a big "X" over the small computer icon. I already tried a computer reboot, a router+modem reboot, system restore, and I even reset the power to the room of the modem+router from the fuse box in my house. I tried everything.
I'm sure the problem must be from the actual cable or mother board itself. ( I hope it isn't ) I tried blowing out any dust from the ports and making sure that nothing was blocking the connection. I fell asleep last night with the internet not working, and woke up to it working. Every other computer in my house works except for mine. I tried all of the router ports as well. I did not attempt another ethernet cable though because my room is far and I would need to make a very long one.
I have searched the forums and found that there have been others with the same problem as me,but none of the solution offered was working for me so I decided to start this thread.I have an Acer laptop that wont recognize my ethernet cable, it says that there is no cable connected.
View 1 Replies View RelatedI have a computer that runs windows 7, and I run an ethernet cable from netgear router into my computer. It used to run fine, but all of a sudden it stopped recognizing the ethernet cable, and I can not access internet.
I know it is not the cable because I can plug in the same ethernet cable to my laptop (runs XP) and it recognizes and I can access internet.
Also, I know it's not the slot on the router because because I switched places with my other ethernet cable that plugs into Netgear Powerline Ethernet Adapter for my Xbox, and the slot recognizes the adapter just fine.
So I am thinking it has to do something with Win 7 or the computer. My computer does have the wireless capability, and I am running it on wireless right now.
I have tried 3 cables and all three are not recognized even though they are plugged in. I have uninstalled network adapter and re installed it and i have updated the driver still nothing so i don't know what to do next.my laptop is a hp pavilion g6 series
View 10 Replies View RelatedEver since moving back in with my dad, I haven't been able to connect directly to the modem. I can connect to the wireless network, but whenever I try and plug straight into the modem, nothing changes and I stay on the wireless. I'm running Windows 7?
My computer specs are as follows (directly from the TSG SysInfo application):
OS Version: Microsoft Windows 7 Ultimate, Service Pack 1, 64 bit
Processor: Intel(R) Core(TM) i5 CPU M 480 @ 2.67GHz, Intel64 Family 6 Model 37 Stepping 5
Processor Count: 4
RAM: 3766 Mb
Graphics Card: Intel(R) HD Graphics, 1755 Mb
Hard Drives: C: Total - 476837 MB, Free - 162910 MB;
Motherboard: Acer, Aspire 5742G
Antivirus: avast! Antivirus, Updated and Enabled
in the past my laptop has been able to connect directly to the internet using an Cat5e cable, but recently when I have been trying to direct connect, I have been unable to, and not sure when the problem started because I always used WiFi and it worked great. I do a lot of messing around, not only with my network, but with my laptop settings also, so something might have gone bunko. I have done much troubleshooitng, such as trying to update drivers, checking to see if the hardware was disabled, etc...
View 1 Replies View Related i just upgraded my laptop
Acer aspire 5551
Tech Support Guy System Info Utility version 1.0.0.2
OS Version: Microsoft Windows 7 Ultimate, Service Pack 1, 64 bit
Processor: AMD Phenom(tm) II N830 Triple-Core Processor, AMD64 Family 16 Model 5 Stepping 3
Processor Count: 3
RAM: 7930 Mb
Graphics Card: ATI Mobility Radeon HD 4200, 256 Mb
Hard Drives: C: Total - 953766 MB, Free - 577936 MB; E: Total - 99 MB, Free - 70 MB;
Motherboard: Acer, Aspire 5551
Antivirus: Norton 360, Updated and Enabled
and I am missing a few thing's since installing the windows 7 ultimate, the main thing is that the drivers for my Ethernet connection (wired) are now missing! I have searched online and with Acer and have downloaded a zip file FULL of different scary looking programs that don't make sense to me and none are simple enough to say "Ethernet driver for windows 7" .I can't access the interwebs in my OPS room without it being through an Ethernet cable.Here is a screen shot of the Ethernet controller window.
Is there a difference in an ethernet cable and an Ethernet networking cable? I have an Ethernet cable and a 6 port splitter I am trying to connect. I have 4 ports in the router that are in use. When I connect them to the splitter nothing s working.
View 1 Replies View RelatedMy computer is a Dell Inspiron desktop 531S. I use Windows Vista.
I have an NVIDIA GeForce 6150 LE INT with integrated NIC card. The ethernet port isn't recognized though. I have downloaded all the latest drivers and updated my BIOS and everything I found listed about.
This will be rather difficult as i'm on a cell phone. Anyways i'm unable to get my computer to recognize that an ethernet cable is connected. I know that the cable is good is i've used it with my girlfriends computer with on problems. I've blowed out the port, used two different cords. Apart from connecting to the internet (which i can't atm) i have no idea what to do.
View 12 Replies View Relatedi'm trying to hook up mi lorex 4 edge+ dvr to my lcd tv (not. full hdtv) i tried using the hdmi cable and adapter but it gave me a message "system not recognized" i would like to know if there is something else i could try. tv daes not have vga connection.
View 2 Replies View RelatedI have an EA2700 (fimware "classic" 1.0.14.129982) that used to work perfectly fine with a Comcast cable modem. I just recently switched to Charter with an Arris TM902 modem and that's where the problems started. The cable modem will not recognize my router. I have to plug in a computer into the cable model when it starts up. Then I need to clone the MAC address and restart the router (after disconnecting the computer). Why isn't the cable modem recognizing the router when I restart it? I guess this could work if it would be a one time thing but I had to power-cycle the modem and it stopped recognizing the router even with the cloned MAC address. So I had to do the whole spiel again.
Is there any way to make this work easier? Should I update my router's firmware to the "smart" one?
I am having a problem with my Realtek RTL8168D/8111D PCI-E Gigabit Ethernet NIC. It is not detecting my ethernet cable, and thus leaving me without internet on my desktop, after i updated its driver. The cable is not the problem as I have tested the cable with my laptop. I tried rolling back drivers, doing system restore and removing drivers with driversweeper and letting windows install the drivers again. However, none of these worked for me. I doubt the NIC is faulty as it was working before i updated the drivers. I am using windows 7 home premium 64-bit.
View 9 Replies View RelatedI have a WAG160N wireless gateway . Yesterday when i tried to power it on after a couple of seconds the power led was solid green and the Ethernet leds were blinking with no Ethernet cable attached to the router . The ethernet leds would keep blinking for minutes . I tried to use a screwdriver to do a hardware reset ( with power on ) and i noticed that the power led would start blinking green/red for minutes . I tried to use another wired router which i have for backup and it could connect to the internet normally without a problem.
What the green / red blinking power led means ( power led is green and then changes to red and then it starts over ) ?
I have a Dell XPS M1530 with Vista 32 bit. When i plug in a cable i get nothing, no error, and the comp does not recognize that a cable has been plugged in. I think that this started after my Hard drive failed and Dell replaced it but i'm not positive. No errors (? or !) in Device Manager and I can't find the Marvell 88E80XX 10/100 Ethernet Controller in device manager. I have attempted to Reinstall the drivers. The wireless is still working. I have one Light to the right of the port that is on all the time solid but no flashing with the cable in or out.
View 14 Replies View RelatedI'm trying to set up a system where a lecturer can sit at home and give his (video and audio) class across the street via an ethernet cable strung across the street. The only problem is he has a mac, and we in the class running it aren't going to leave our PCs for macs!Is there any simple way to connect the mac to PC (without running through a router, as it slows down the system)?If so, what programs will work best for both PC and mac for streaming the video (and are free)[BTW I don't think a 100m cable is too long for the signal.
View 2 Replies View RelatedWhat is the best Ethernet cable too run around my house?
View 3 Replies View RelatedI'm switching from using a wireless usb adapter to a wired connection via ethernet cable.
When I plug the ethernet cable in however nothing happens, I've tried using it with a different computer and it works like a charm but this one doesn't seem to be working right.
HP Pro Small Form Factor 3010 Windows 7 32bit (Other computer was using windows vista)
Windows IP Configuration
Host Name . . . . . . . . . . . . : HPPro3010
Primary Dns Suffix . . . . . . . :
[Code]....
I just reinstalled Windows 7 on my computer again and appear to be having trouble connecting to the internet with my ethernet cable. I've only ever used a wired connection on this computer, but am completely unable to do so at the moment.
View 11 Replies View RelatedThe Ethernet cable really gets in my way and I'm trying to find a way to use my Internet without it... What would I have to change on my computer?
View 1 Replies View RelatedI have vista system, belkin wireless realtec ethernet cable and alice modem internet provider is o2 everything is working as i have checked but I GET NO CONNECTION everything was fine for 2 years and then suddenly after checking the system I am told that the ethernet cable is not connected,
View 5 Replies View RelatedMy Ethernet Cable is not reading, when ever i plug in the Ethernet cable into the port into my Toshiba laptop, it doesn't read, What is the problem, My cable, Laptop or (ISP) Internet service Provider?
View 1 Replies View RelatedWith just a printer and an ethernet cable, can this be used to print without internet, modem, etc. just like using an USB to printer?
View 3 Replies View RelatedI am trying to connect my two laptops with one Ethernet cable without any internet to a Network. However, just one of the laptops is identifying the connection, the other doesn't recognize that it has been connected to another laptop. Obviously, the cable itself is working (because one laptop identifies the connection), but what might be the problem that the other laptop doesn't recognize any connections?
View 6 Replies View RelatedI would like to know what is the difference between LAN cable and ethernet cable? Is both cable is same? can we use CAT 6 and CAT 5 cable as LAN CABLE?
View 4 Replies View RelatedI'm trying to connect to the internet via the ethernet cable available in my office at the university but it won't work. I'm able to see other computers connected to the network, share printers and have access to shared files but have no internet access. I know that the problem is not the cable or socket because my old XP computer connects to the internet just fine.
I had a similar problem back at home but I just restarted the modem and was able to connect.
Setup:
Lenovo x220 tablet
Network card: Intel 82579LM Gigabit Network Connection
So I am trying to connect my desktop to my router via an Ethernet cable. When I plug the cable to my PC, it won't connect to my router. However when I plugged the cable to a laptop, it worked fine. I also went to check the Broadcom NetLink Gigabit Ethernet adapter in Device Manager and it has an error that says "This device is not working properly because Windows cannot load the drivers required for this device
View 2 Replies View RelatedMy onboard adapter wasn't working so I bought a new dlink adapter. Adapter installed and is registering in device manager.. but it says that there is no ethernet cable connected. I have a laptop connected to the same router that is connecting to the internet. I switched out cables with ones that worked with the laptop and on the desktop before. I have cycled the router
View 2 Replies View RelatedI'm having trouble with my ethernet port. I have a Asus g73jh computer running 64-bit windows 7 and i have an atheros ar8131 pci-e gigabit ethernet controller NDIS 6.20 for my network adaptor, that is fully updated and says is working properly but doesn't recognize when an ethernet cable is plugged in. The cable works on my xbox fine so I know that the cable works fine. I'm pretty sure that there might be something physically wrong with it or I just don't know.
[code]....
At the moment I cant run an ethernet cable through my house from my router to my desktop PC (Which is where I use the internet/play games etc) and connect directly that way because my parents dont want cables going through the house etc etc.For the past 2 months or more I used my old laptop to pick up the wireless connection downstairs then I bridged the connection and used my ethernet cable from the laptop into my PC/Xbox or whatever, no problems until today, I wouldnt even have to log into the laptop, i would just turn it on and leave it at the login screen and I would have internet on my desktop/Xbox.Tried to do that today and was getting unidentified network on my desktop, i dont know what the problem is, I can connect directly to my router with the ethernet (I tried it) but not the old way anymore, i'm on the laptop now on the wireless internet.In network connections there LAN network isnt there anymore, its just the 'Unidentified Network' which is the bridged connection.
View 8 Replies View RelatedI have two ethernet cables, a long one and a short one. The short one works fine, but the long one does not work with my computer. It has worked with other laptops, so I am fairly sure the cable itself is fine - is there anything I can do
View 3 Replies View RelatedCan I connect WIN98SE to DSL via ethernet cable? I'm trying to upgrade the OS to windows XP from the windows website. But I can't connect to the internet.
View 3 Replies View Related