Install A Wireless Adapter In Fujitso Siemens Scaleo P Desktop
Feb 18, 2012I would like to install a wireless adapter in my "Fujitso Siemens Scaleo P" desktop ,how do find out which adapter is the most suitable,
View 1 RepliesI would like to install a wireless adapter in my "Fujitso Siemens Scaleo P" desktop ,how do find out which adapter is the most suitable,
View 1 RepliesI need to install a wireless PCI Adapter to my Dell Optiplex small form desktop computer, but how can i identify what type of PCI Bus slot do i have without opening the case.
View 1 Replies View RelatedI can install a Broadcom 802.11g network adapter into the HP G5326UK Desktop PC?
View 5 Replies View RelatedI cannot install driver for Nokia Siemens Network c2110. when try it show error message then followed by another message showing" required administrative right....." where as this connetion works on laptop and that same file installed into another computer.
View 1 Replies View RelatedI have a Vostro 460 desktop, recently bought, and then realized it would be better to add wireless router. Bought router and a PCIe wireless mini card that was suggested for my PC on Dell order site. The card arrived and am trying to install. The end plate with the aerial socket is not compatible with the removable access blanks in rear of case. Have I been sent an incorrect or unsuitable card, or is there some trick or adapting needed to install this card?
View 3 Replies View RelatedI recently had to wipe (start all over again) my fathers PC as it become infected with a virus which I struggled to remove. When trying to set up the wireless connection via my virgin wireless manager I followed all the steps correctly until the last where it could not find my USB wireless adapter. I installed the latest software for the adapter from the netgear website but it will still not succesfully install the drivers fro the adapter.
View 1 Replies View RelatedI simply, can't install Cisco Connect. I want to because it has the parental controls and guest SSID controls. When I try to install, the progress bar get's to 25% and then stops - the next screen says "Our Customer Support team can help. Your router was not successfully setup." I reset the modem and have my computer plugged in to port 1 while I try to install the software. I have been able to setup the router manually. It works great. My issue is that I can't install Cisco Connect desktop software for Mac.
View 9 Replies View RelatedFrom the Dell Drivers and Downloads page, I downloaded the WiFi Link 5300 driver (R213215.exe) assuming it would enable my WiFi to run. I tried to install it and was met with an error message: "This installation is not supported on this operating system version. The setup application will exit." It will not install and my WiFi is still down.My system is an Alienware m15x with Windows 7 64-bit. I recently re-installed Windows due to a small bug that was hampering Google Chrome. Before I re-installed Windows, the WiFi was working just fine. Any working WiFi driver?
View 3 Replies View RelatedMy desktop has always been connected via ethernet cable but I'm about to move to the Middle of Nowhere, Alberta and will be mooching off a school's wireless internet that's about 400m away apparently. Not sure if that's door-to-door or not...so it may not actually be 400m away. Anyway, the principal said other people get the internet from the same distance but it's "inconsistent".
View 2 Replies View RelatedI am running Windows 7 with the WUSB600N (v.2). Here is how I got it to work.The driver support is not a .exe. You will have to install it yourself...but it's not a big deal.Download the Windows 7 driver for your OS version from the Linksys Support page.Save it to the desktop and then unzip it to the desktop so you can find it easier.Once unzipped you will see 3 folders: Mac, Win7 32 and Win7 64. Choose accordingly.What I did was install it through the "Device Manager". (Right click "My Computer", choose "Manage", then Device Manager",or use the "Search Bar under the Start Menu...whatever. Once you are in the Device Manager...
1. Make sure your WUSB600N is inserted in your computer.
2. Navigate down to "Network Adapters" If you see your WUSB600N adapter...great! Your halfway home!
3. Right click on the "Linksys WUSB600N Adapter.
4. Choose the option to " Update Driver Software"
5. Choose "Browse My Computer for Software"
6. Navigate to the desktop and choose the folder that contains the name of your Windows 7 platform.
7. It should update but, HOLD ON! We are not done yet!!!
In order for it to start transmitting in that shiny new 5GHZ band, you must go into "Network and Sharing Center". Once there, look on the left hand side of the main window and you will see "Change adapter settings"Go there. You should see here that your existing adapter is still working (enabled) and your new Linksys WUSB600N has a big fat red "X" under it (disabled).Right click on your existing adapter and choose, "DISABLE".Then, right click on the WUSB600N adapter and choose "ENABLE".The last thing you should have to do is choose the network you want to connect to (for me it was the 5GHZ one) ..and Viola!!
I recently reinstalled my OS of my E1505 and was installing drivers from the Dell Resource CD (which was for an ME051, is this a problem?). But, after installing all of the drivers and system software my Intel ProSet Wireless program still says there is no supported wireless adapter on the computer...I also cannot create a connection when I connected the laptop to my hardline DSL cable.
In addition, the video card driver will not install saying that one or more files needed to complete the install were missing and it closes the install wizard. Just in case any of you can answer that as well.
I have assembled desktop pc .I have downloaded and installed windows8 pro. I am not able to use wireless connection since my pc has no wireless pci adapter. I am using wired connection. can I instal a wireless hardware in my pc what is the best adapter
View 1 Replies View RelatedI can't get a wireless adapter to work on my newly purchased desktop. Tried 2 different brands, same result: After installing drivers, resetting wireless router etc. the wireless connection sometimes shows up but can't be connected to. I used:
1) TP link wireless adapter
2) Netgear N600 wireless dual band usb adapter.
The netgear one I'm using right now just says, "scanning" constantly. Here's diagnostics:
Host Name: MININT-SNNBPV2
OS Name: Microsoft Windows 7 Home Premium
OS Version: 6.1.7601 Service Pack 1 Build 7601
[Code]....
I own a dell demension 8300 OS Windows xp Professional. What would be a compatiable wireless adapter for my desktop pc?
View 1 Replies View RelatedI wan to buy an wireless adapter for my desk top pc. Which I should choose from PCI card or usb adapter?
View 2 Replies View Relatedi have a desktop with a wired Ether port, and want to use the DIR-655 to access the wireless LAN used by the rest of my household. this should be possible, right? i've seen discussion of the DIR-655 as a bridge and repeater, but can't figure this one out?
View 1 Replies View Relatedwhats the best wireless adapter for desktop computer with windows vista and 7
View 1 Replies View Relatedi just recently built a new computer (well today) and i plugged in a wirless usb adaptor that was about 2 years old and it was pretty fast but it still lagged my game starcraft (i was just trying it out to see how the computer would handle it). I went out and bought a brand new xtreme N desktop PCI adapter and it is even slower, and it disconnects every 5 seconds it seems. I installed it correctly and installed all the drivers, I also have rebooted the computer and it is still slow and wont even connect for a full youtube video. am i doing something wrong or is my adapter the problem (i am doing this on my laptop which is right beside my computer and is still connected to the internet).i cannot wire my computer to my router because it is to far away so that isn't a solution.
View 3 Replies View RelatedI would like to know if the D-Link DWA-525 Wireless N 150 Desktop Adapter [URL] is compatible with my ASUS P6X58D-E motherboard ?Its a PCI card, and even my mobo had the PCI 2.0 slot, but i happened to see the photo of the card and it seemed to have two gaps in its PCI connector,]
View 8 Replies View RelatedI have a GM4019e Gateway desktop. I need to buy a somwhat inexpensive wireless adapter, but im unsure of which one will work with my computer.
View 1 Replies View RelatedMy Win 7 shows 2 network adapters in device manager...in my Acer ao 722 net book. My desktop has XP and only shows one adapter..I believe one of the adapters in the Acer net book is wireless ( being a new machine ) and the desktop is an older pc with a wired adapter. Could i copy the wireless adapter and paste it into my Desktop, to enable wireless connections? Obviously, we are not talking about actual cards, they are all integrated into the Motherboard.
View 2 Replies View RelatedI just got new desktop and the wireless internet is about half the speed as my old laptop. The network adapter on the new desktop is 802.11n Wireless LAN Card, the laptop has Atheros AR5B91 adapter. the wireless router is a netgear N300.
View 2 Replies View RelatedI am making my wireless network with Wireless router DIR-600 and DWA-525 desktop adapters for my office. I created a most secured type of network WPA2. And I have to create profile for DWA-525 desktop adapter to connect to my network and it requires the network secret key to connect. But This secret key is viewable from the "Network connection manager" when one can click on modify network and click on "Show text in the password field" by everyone using this computer (I mean by all other office staff). I don't want to let any one know my wireless network secret key. Is there any way to protect the key while having the computers automatically connected to wireless network. More information is below
Model: DWA-525
Hardware Version: A1
Firmware Version: 1.10
Operating System: Windows 7
Service Pack: 1
The other day I went to a friends house, came back home, booted up my PC, and my wireless network adapter wasn't working. I've tried everything to fix it.It's a D-Link DWA-525 802.11n Wireless PCI netowrk adapter. On device manager it just says 802.11 Wireless LAN Card with a yellow exclamation next to it. And when I check what the error is, it's either error 31 or 52 at different times, depending what I've tried to do to fix it.I tried downloading the driver for it off the D-Link website, nothing happens at all when I install it. I tried taking it out of my computer and plugging it in. I tried enabling it and disabling it on device manager.I noticed one thing, when it's in my computer the green light at the back that says activity next to it isn't on.
View 10 Replies View Relatedcan you use a Mini USB WiFi Wireless Adapter LAN Network Card on a desktop computer
View 4 Replies View RelatedI have an HP SR2170NX desktop set up via DSL and cable to an ATT gateway router that enables wireless for my roaming with my laptop. The laptop works wirelessly even when the cable between the router and desktop is unplugged and the desktop turned off. I would like to equip the desktop with a Cisco-Linksys WMP54G Wireless-G PCI Adapter or similar PCI-card to allow for elimination of the cable between the router and the computer.
View 2 Replies View RelatedHow do I configure and set up my desktop to get on my neighbors internet connection with the netgear wireless adapter.
View 3 Replies View RelatedSo I recently updated my desktop to windows 7 and I have lost the CD for my E3000 router. My desktop doesn't have a wireless adapter I always had it set up on a direct connection. So I went to the E3000 support and downloaded the software on my laptop and burned it to a DVD and put it in my desktop so I could update the drivers manually and be able to connect to the internet. But it seems the software only supported wireless connections, am I just sol? Is there some way to get my desktop to update the drivers for the router?
View 2 Replies View RelatedI want to work on quickbooks 2010 pro between my desktop which is windows vista and my lap top windows 7. I will be the only user, how do i set this up?
View 3 Replies View RelatedAt one time this D-link adapter was installed on this same computer but somehow the drivers got deleted.I am trying to reinstall. The computer is running Windows XP Professional. I downloaded the driver from Dlink's web site and unzipped the files on the computer.The Ethernet Controller shows up in Device Manager with the yellow ? so I right click it and the click on Update Drivers. But when I tell it to install the drivers a window comes up saying it cannot install because it cannot find the necessary software.
View 14 Replies View RelatedMy computer has an option in the Bios and in the boot menu for the "internal network adapter boot." Can I use this to install an OS?
View 3 Replies View RelatedI am trying to install the software for my router (on a Windows Vista Laptop) and everytime I get to the software install and it is detecting the network-and then the program freezes and my wireless adapter is turned off. I have to force quit the program and turn the adapter back on.
View 1 Replies View RelatedAny way to install this excellent WiFi adapter on Ubuntu?
View 7 Replies View Related