Internet cable to dir655 and cat5 to master computer with slave using wireless. Network between them always works fine. But if master connects to internet the slave will lose the internet until the master disconnects. like it won't share the signal.
View 1 RepliesI have DIR-615 Cx (bought in Taiwan) Hardware C2 ver. I reflashed with DIR-615 firmware from Singapore to get English interface. I connect to a internet through another router on which I setup D-Link on DMZ with port forwarding. Router works fine, I have internet connection. So the question is: I have small cafe and want to offer customers WiFi connection. I want to setup a time limit and allow them to browse only internet not internal network. (When I connect laptop to D-Link Wifi I can see my NAS on different subnet connected to cable modem/router) And if its possible to limit bandwidth. Can I do it with DIR-615 and how to configure such a setup?
View 1 Replies View RelatedI lose internet connection every day in the same time etc.i lose it in 2pm and i get it in 7.pm and tomarow again lose it in 2pm get it in 7pmit is not virus i have cleaned every infection whit Malwarebytes,Emsisoft,Hitmanpro,SuperAntispyware and Spybot
View 4 Replies View RelatedI lose every day internet in the same time etc.in 2 pm and tomarow again in 2pm and also i get in the same time etc i lose internet in 2pm and i get internet in 7pm and tomarow again i have caled my ISP and it is not problem whit it also it is not virus.
View 3 Replies View RelatedIt is usually by a router or install a third party software without anyone saying if it works or not.
I have two connections at home. One is a Wifi ( public wifi for my village) that i use for my phone and the other one is a wired dsl. I have used both but not on the same time. I tried connecting them both ( phone have tethering) but I think they are interfering with each other making me lose connection. I am using vista home.
I have seen the merge connections( in network and sharing center) and i have seen this one [URL].. but I am a little bit wary of changing my registry.
At around 2:30 PM each day, the internet slows down, and it says its connected but with limited access. A few minutes later, it gets full connection again, but it is super slow, then the same cycle starts over again. It stops happening around 8:00 PM.
View 1 Replies View RelatedFirst I tried restricting all computers from accessing the internet from 11:00PM to 6:00 through access control. I enabled it and set up the schedule but it does not cut off the internet. I went through create a new schedule and did that but again it still connects. Then, in access control, I selected always and put in my son's IP address and created a schedule for him but it won't allow him any internet access.
View 2 Replies View RelatedI am trying to set up a d-link router with a modem provided by time warner cable. I've powered down, reset the router, and I've put it on dynamic settings (sorry if that's incorrect terminology... not a comp. buff). I can't get my wireless to connect to internet.
View 1 Replies View RelatedI just got a dir-655 revb, and it does not connect to the internet. I have DSL, and the old router works fine with PPPoE, when I configure my dir-655b router, it can not connect to the internet. I get the flowing error:
info Mar 23 22:31:11 rp_pppoe =' read pppoe_conn_session error or first time dial
notice Mar 23 22:31:10 pppd 2.4.3 started by root, uid 0
info Mar 23 22:31:10 RP-PPPoE plugin inform wantimer to reset auth, discovery variable
info Mar 23 22:31:10 RP-PPPoE plugin version 3.3 compiled against pppd 2.4.3
info Mar 23 22:31:10 Plugin /lib/pppd/2.4.3/rp-pppoe.so loaded.
info Mar 23 22:31:05 Exit.
How to block Internet Connection during specific time.for example i want to block everyday between 8am to 12nn, then 1pm to 5pm.what are the options and better to achieve this kind of policy??
View 6 Replies View RelatedI have two routers one is a o2 router which is for the internet (broadband) the other is an old bt home hub which i have connected to the printer via usb. In order to print a document at the moment i have to disconnect my laptop from the broadband router and connect it to the printer router.Is there any way that i can connect to the two router s at the same time so that i while printing i can still keep my internet connection.
View 1 Replies View RelatedI am facing a proble in wireless connection speed that is getting very slow at a specific time, i.e., from 12pm to 2pm and from 9 pm to 2 am. The service is unlimitted type contract
View 1 Replies View RelatedIs the WAG320N iPv6 compatable ? ,or could it be with a firmware update ?.Is the X2000 in the same boat in iPv6 terms as th WAG320N ?.Is there a way of retrieving "UPTIME" / "DSL connection time" information from the WAG320N and also line attenuation stats etc.Wouldn't need the above but poor isp needs keeping an eye on.
View 3 Replies View Relatedi have a PPPOE type of connection for my modem and just now my router is blinking both lights Orange and blue at the same time....but the internet is still connected..
View 14 Replies View RelatedI have two laptops which connect to the router via wireless. This router is wired to the modem. I can connect each laptop to the router then make an internet connection. This works fine. But if one laptop is connected to the internet, then the other cannot. I have to disconnect the first laptop then reconnect with the second.
I have had this scenario working in the past and can't remember what I have to do to enable both laptops to use the internet connection at the same time.
AI have a Dir-825 router. The 5GHz is turned off and the wirless is on G/N. I have shawcable for my isp and my firmware is 2.06 and its a Rev B Router. I also have Qos Engine on for allowing me to have 2 xboxes on Open NAT.problem is my wireless signal for some wired reason is VERY weak. A while ago it used to work really far way outside. It was around 150ft distance at 4 bars. Now for some reason I can't even go upstairs without getting a 1 or 2 bar signal.
View 3 Replies View Relatedi have had my dir-655 one year now, have never had wireless problems with it until now.my notebook's internet gets very slow somedays, i just restart my router and then internet speed works normally.i have:
Hardware Version: A4 - Firmware Version: 1.32EU
One of my laptops is having a connection problem. I have 3 other laptops that can connect perfectly with my router, and normally there's only 1 laptop that is connected to my router. The laptop with the slow connection (takes 5 HOURS to load a website, sometimes will not even load), i re-installed the OS, and installed all the drivers needed, and it still wont work. it shows strong connection to me, and im sure the password for the router is right. below is the ipconfig/all information. Having this problem for 2+ weeks now!!! I think this problem started when i restored my router to factory setting, my router is Netgear WGR614v6.
View 14 Replies View RelatedMy Latitude D630 has been dropping internet connection all the time for the past three days. I looked up similar problems on this blog: a) cleared the DNS cache, b) downloaded windows XP- service pack 3, & 3 network software recommended for my laptop by Dell from the website and updated to the Intel PROSET/Wireless WIFI connection utility, d) ran ipconfig/all from C prompt and know the ethernet connections are disabled, e) called and checked with our local ISP and cleared the connection from their end. To sum it, I have tried everything I know and am still not able to maintain a steady connection to the net using WIFI. However I am able to connect using the cable to the router, so my net provider said the problem is with the wireless connection on the laptop. I didnt have this problem before.
View 1 Replies View RelatedI just bought a "DLink Xtreme N Gigabit Router DIR-655" I configured it correctly. It works well for the wireless connection but my Lan connection (wired connection) does not work. The Lan computer connects to the router but cannot access the internet. All of my machines work OK with a Netgear G router, including the Lan computer.
View 9 Replies View RelatedMy DIR-655 has worked for 2 years, but can no longer access the internet. My ISP is (Rockbridge Global Village -sub of Ntelos) and my modem is a Zhone. My connection type is DHCP, QoS is set to active, and the IP address boxes are not being filled in. The cables check out ok and there is no problem connecting to the internet if I bypass the DIR-655 and connect direct to the modem. Hardware is A4 with firmware 1.21
Nothing has changed in the house with regards to new cordless phones or wireless devices and I am using the same Zhone modem. I have tried returning to factory defaults and reconfiguring.
I have bought a new router to my parents these days, it a DIR-615 HW H1 firmware version 8. We have a ZyXEL Prestige 2000 series DLS modem.
There is no problems with connection to the DIR-615 router, but the strange problem occurs when I plugs in the internet cable. At the beginning the internet start to work fine but after some time the internet does not work anymore. What may cause the problem? The internet works if I plug the internet cable in my computer and it also work with the old router.
Yesterday, my linksys router broke down suddenly. I went to the store and bought a new one, a d-link DIR-615. After plugging it in and setting it up, i tried loading web pages and it worked ok. It wasn't as fast as my linksys router but it was fine. When i tried loading youtube videos, that wasn't the same story. The videos didn't load. It started playing but then stopped after a couple of seconds. When i connected my computer directly to the modem, the videos loaded fast. There seems to be something wrong with the video streaming.
View 9 Replies View RelatedI recently bought a dlink 825 and it seems right out of the box the wired internet connection seems very poor. Wireless works fine but it on wired the router refuses to download any files larger than 300kb. Images won't load, files won't downloads, etc. I've swapped cables, tried two different computers, hard reset, loaded the 3.01 firmware and nothing seems to work. I went back to my old router and it works fine. I am able to transfer from computer to computer okay with the 825,The cable modem is a SA dpc2100.
View 3 Replies View RelatedHere is my configuration. My new DIR-601 router is connected this way. Wan port to Isp modem, LanP1 to a Win7 Pc1, LanP2 to a Linksys router, DHCP diisable using the 4 LAN ports as a switch in wich 2 Pc are connected 1) Win Xp PC2 and 2) Ubuntu 10.04 PC3.
The problem is , I can not access internet behind the telesyn switch, PC2 and PC3 have no access to Html servers on the Wan, except if I define PC2 or PC3 , only 1 allowed at a time, as DMZ. If I plug PC2 or PC3 directly in DIR-601 port everything is ok.
Why DIR601 port connected to a switch does not work the same way than conected to a PC. Any solution to give Internet access to PC behind a switch ?
NB: This work if I replace DIR601 with DIR620 router.
I have seen several posts regarding internet connection dropping. Mine does the same. I have a cable modem in front of the router. The router is setup with two SSID's (one 2.4GHz, and the other 5GHz). So often the connectivity to ENET drops, forcing me to power cycle the router. Other then the two SSID's, the router setup is factory default. I need to debug this. I have noriced that the DNS IP addresses do not show up under setup. Where do I start?
View 6 Replies View RelatedI have a working internet connection (AT&T) but it is not being detected during the router setup. Is there a manual setup procedure that I can try?
View 1 Replies View RelatedConfigured a D-Link DIR-601 router? The internet is connected, but there is a yellow triangle with a exclamation mark on the bottom right corner stating it isn't connected. I read the manual and did everything as listed, but still have the same issue.
View 4 Replies View RelatedMy router keeps dropping my internet connection. I wonder If its the ISP cable modem that drops it and messes up my router forcing me to reboot. Drops it cause of some time out; or the like.If I can have the router periodically send a signal to my modem
View 1 Replies View RelatedI have some questions about DIR-655 want to ask.
1.I use it as a AP, no connection in the internet port, however I only see the DNS setting in the WAN interface, so some url setting can not normally run. Do it has AP mode or other setting that can resolve the DNS.
2.I notice that the Time will suddenly wrong something, even I set it to use local time or ntp.
3.I change the wireless setting to WPA Enterprise, and notice that always disconnect and reconnect, When it is disconnect, notebook and phone can not search the wireless, but ping in local is still alive, log also only show that reconnect, what is happen?
4.I run the internet wizard (not at beginning), I do not change new password in the second phase of wizard, however, after the end of wizard, restart the DIR 655, I can not use the password I set before to login and also I try to leave blank in password flied, it also failed, I use the same password in the user(not admin), I can login, is it the bug of wizard, if this situation need to reset the router, can I take the config first?
my internet connection keeps dropping recently. I first thought it was caused by my router, so I bought a new router D-Link DIR 835 but the problem still exists and seems even worse.
View 1 Replies View RelatedHow do I get internet connect to all connected to the switch. One computer can access internet right now but the other cannot.
View 1 Replies View RelatedI have been using my D-Link Wireless G Router for more than one year now and haven't met any connection problem with it until a month ago. I can no longer access the internet when the Internet cable is plugged in the router. I can access the net when the cable is plugged directly to our desktop. I bought a new router which is TP-Link TL-WR470N but the results are still the same. I tried configuring both routers using DHCP and Static IP settings but nothing changes. Power Cycling doesn't change anything. Renewing the IP, resetting WINSOCK and DNS makes no progress for me.
Here are details of my system:
OS Version: Microsoft Windows XP Professional, Service Pack 3, 32 bit
Processor: AMD Athlon(tm) Dual Core Processor 5050e, x86 Family 15 Model 107 Stepping 2
Processor Count: 2
RAM: 1790 Mb
Graphics Card: NVIDIA GeForce 6150SE nForce 430, 512 Mb
Hard Drives: C: Total - 152617 MB, Free - 132217 MB; D: Total - 152617 MB, Free - 152481 MB;
Motherboard: eMachines, WMCP61M
[code]....