i have a problm in Epson LQ-2090 Dot Matrix Printer that is LAN Not receiving the data's .....Last time the same prblm came so i installed IP Add thn after 10day's again the same prblm repeating..... So can any one tel me the reason y it happen..... But i think LAN Memory power is gone.
View 1 RepliesI'm using Cisco 2100 cable modem. It worked fine until some time later where the Data Send & Receive LED's stopped blinking. A man came to check if the cable was the problem by replacing it, but it wasn't. He claims it might be related to the laptop. I have tried several times restarting it. (I'm using mobile broadband) I would really like fast rather than slow internet ( I was limited so now it's slow but free)
View 14 Replies View RelatedMy setup is as follows:
Linksys E2500 as DHCP client, all default network settings (MTU auto configured to 1500), connected to:
ZTE 831 II ADSL2+ modem in bridged mode
The issue is that whenever any large file is downloaded over HTTP, the download stops after about 4 minutes and never resumes. This results in:
1) HTTP downloads of anything > ~80 MB failing; tried using several browsers and CURL, all with the same results
2) iOS downloads in iTunes timing out
3) YouTube videos stalling every few minutes
Interestingly, Netflix streaming works OK. Perhaps that's because the protocol for Netflix is not a single large download but a bunch of smaller ones, but that's conjecture.
This all occurs over both wireless and wired connections to the E2500.
If I connect my Mac directly to the ZTE modem, I don't have the problem.
We are trying to isolate the fault. From Aggregator a router, we are receiving MAC address of distant end ethernet interface of a SDH box and vice versa is also possible. However ther is no packet received. My question is does ping test is must to see if the path is through or just receiving MAC adress at both ends would mean that packets have to go over the path.
View 1 Replies View RelatedI can not get onto the internet via dial up. The message says that I have no dial tone. Using the same line, I get a dial tone on the phone. I can get onto the internet via a DSL connection, but it will not make a connection when I have a telehone line inserted in the phone line jack. This problem started after the power went off and on quickly two times. I have followed all the instructions that I have found to reset the modem, but to no avail. Is it possible that the phone line jack needs to be replaced.I have a gateway laptop with Vista program.
View 4 Replies View RelatedWe recently upgraded to higher speed internet and were to "reset" our modem, which is PCI Soft Data Fax Modem With SmartCP.How does one "reset" their modem?
View 1 Replies View RelatedMy broadband seems to have stopped uploading data. I run broadbandspeedchecker and it shows download of 8 and then upload doesn't work at all and shows 0.I can browse some pages, but don't have full use of all pages like my CMSA admin, can log into my hosting using FTP, but can't access directories, Skype doesn't connect.Even stranger is it all works for a few seconds, even connecting Skype, but then stops again.I have completed a few system restores going back a week before the initial problem and still no joy!
View 7 Replies View RelatedIs there a way to limit the amount of data sent to a network printer? We have users trying to print a 2 GB documents and it causes issue on the print server?
View 2 Replies View RelatedI bought a new Toshiba Satellite C660 laptop with Windows 7 on Sept 1st, and had no problems at first with the mobile broadband. However, on Monday 13th I noticed massive spikes in the data usage. After browsing the internet for around an hour I decided to check my usage randomly, and it was at 350mb!Since then, there's times when I don't even have my browser open and in the space of 5 minutes it will reach 150mb of usage. There's also times when it works absolutely perfectly for hours on end (including today, where it was working fine up until around an hour ago!) I phoned the mobile broadband company twice last week, the first time the person told me that it was a computer issue and to go to an IT repair place.
So after sending him screencaps of Windows task manager processes/applications/network he can't see anything that could be doing it. He advised me to do a full antivirus scan, and full malwarebytes and ad aware scans and they've all come up clean.The second time I phoned the broadband company, they told me that there were some wrong settings, and that they've been changed now but if I have any more problems to ring customer care again.So after seeing an offer with a different mobile broadband provider, I decided to buy a new broadband stick and change networks in hoping that would solve the problem.... it didn't.
So there's definitely something about the new laptop that's causing the data usage to spike I don't use any torrent programs, and haven't been watching youtube videos constantly or trying to stream online, like I said there's been times where I don't even have Google Chrome open and it's using up all my data! I don't use Skype or anything like that either (to be honest I have barely any programs on this new laptop)I've turned off all the automatic updates for as many programs as I think can have them. Ii's definitely improved a bit though, but there are still times (like around an hour ago) that the data usage starts spiking randomly.
Half of the time i have to stay at hotel due to business trip. The hotel i stay will provide free internet broadband with cable but no WIFI. Can i set up WIFI if i have router?
View 2 Replies View RelatedI am using PTCL' DSL in my country. I want to know how can i increase download speed of stuff from internet?
View 2 Replies View RelatedFor the last 3 weeks or so (right around the time I upgraded to IE8), my computer has been receiving a ridiculous number of bytes compared to what it sends.Within 5-10 minutes of logging on (I still use dialup), a check on the status shows around 100,000 bytes sent and over 2,000,000 received.I've been online for around 40 minutes, and it currently shows 650,000 sent (23% compression rate) and over 5,000,000 received (4% compression rate).Of course, the browser starts lagging and freezing after a while, which I assume is from the large number of bytes being received.
At the same time, there's a noticeable lag when I try to run programs, even when offline. For example,I click on my ISP connection and nothing happens for 5-6 seconds, then the dialog box appears. This is something that's never happened before. I'm running XP Home and no one else has access to my computer.I'm using the standard Windows firewall.I've run my AV and spyware programs multiple times (nothing found), cleaned my temporary files and cookies, even adjusted the FIFO buffers (the last thing I tried was turning the buffers off). I've been running Disk Cleanup everyday (which lags and runs slower than ever before), but it doesn't solve anything.I don't know how to adjust the compression rate for bytes received to see if that works.
One Day the internet is fine the next day The Internet Stopped working. The problem is my pc is sending packets but not receiving any i though it was a bug or something so i restarted my pc after i restarted my pc the internet was working fine until a couple of minutes passed it stopped receiving packets again.i tried resetting the modem but nothing worked.I tried winsock fix or resetting TCP/IP and stuff but nothing workscause its starting to frustrate me.
View 14 Replies View RelatedOur computer is sending but not receiving packets. We've tried 3 different wi-fi adapters, and that wasn't the problem. We have no idea what's wrong? It won't pick up any wireless signals by the way, and it works fine while connected via Ethernet.
View 5 Replies View RelatedI have a home network that does not connect to the internet, but which I use to play games on, or did before this issue happened by.For years my PC's and friends ones had been able to connect into the network with little or no problems, but a few months ago my tower PC just stopped picking anybody or anything up on the network and I have tried tons of different resolutions to solve this.Anyway, the other day I bought a new HD and installed XP SP3 again on it, and for about fifteen minutes I could connect to my Vista Laptop and share files and play games, then it stopped.Next day the same again and off and on till now when its been down for the last week.I have also now bought a new network card - no difference - and disabled the on board network card through the BIOS - no difference.I have done a Winsock repair, replaced automatic IP addresses with manual ones, and countless other remedies which have not solved diddly.
View 14 Replies View RelatedMy GPS was simply triangulating my location and then comparing that location to mapping information stored in my device to give me my next turn, among other information. From the referenced article, it appears that this device is doing a lot more than that, namely it is compiling information about my location and even my speed, sending it to the GPS manufacturer where that information is being compiled and sold.
View 2 Replies View RelatedI'm receiving about 99%CPU on 6500 .Butwhen i go show cpu sorted ,i can't see any process taking more than 2% load .My IOS is s72033-ipservicesk9_wan-mz.122-18.SXF13.bin
6500#sh processes cpu sorted | exclude 0.00CPU utilization for five seconds: 99%/97%; one minute: 99%; five minutes: 99% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 114 11136 1772 6284 0.79% 0.13% 0.30% 1 Virtual Exec 6 84386920 6320367 13351 0.71% 0.27% 0.23% 0 Check heaps 123 94861244 849807118 111 0.31% 0.38% 0.39% 0 IP Input 180 10647916 52152600 204 0.07% 0.03% 0.02% 0 CEF process 316 12053884 68553405 175 0.07% 0.21% 0.08% 0 OSPF Router 1 281 31925228 239981938 133 0.07% 0.04% 0.05% 0 Port manager per 213 61331112 213008378 287 0.07% 0.08% 0.09% 0 SNMP ENGINE 37 5577644 36376566 153 0.07% 0.05% 0.02% 0 Per-Second Jobs
i need to change my computer setting so it connects to a broadband modem?
View 1 Replies View RelatedI m having broadband connection.. but its speed is not that much good..
View 1 Replies View RelatedHow to share reliance broadband connection between two pc's using hub or direct line in one computer have windows 7 ..
View 1 Replies View Relatedmy local area connection is sending 0 packet and receiving unwanted packet
View 1 Replies View RelatedI have a Asus EEE PC 900 laptop running Windows XP Home. I DO NOT use a modem or router. I connect wireless to someones network (which of course i dont know who it is or how far it is from me) I connect to a Linksys unsecured network. I get good to very good (some times excellent connection from it) The name of my adapter is: Atheros AR5007EG wireless network adapter.Two days ago i was on the internet, and all of a sudden i Lost service ( usually when this happens i wait it out and it comes back)But it hasn't.So I'm checking through my settings and i noticed that im sending way more network packets than receiving. Last i checked it was around 40,000 sent and 5 received. So I wait and wait and wait and the most packets it would go up to is 90 while as sending is still in the thousands.It also says im successfully connected with good to very good connection status (but yet i cannot surf the web because i do not have enough network packets)
I tried different locations in my house (that didnt work)I uninstall and reinstalled my network adaptor (that didnt work)I turned off and on the wireless switch(that didn't work). Im wondering if this has something to do with my laptop or the other persons network? how can I increase the received network packets?
I had a customer call me and her desktop (wired connection only) is sending and receiving packets but she still cannot connect to the internet. Customer has tried power cycling her modem, router and desktop with no avail. Her system is running XP.
View 13 Replies View Relatedif an email can be sent from a persons private account after the account has been closed.
View 15 Replies View RelatedWhen i look at the network wirless connection status something is constantly sending and receiving Bytes and lots of them.the modem gets warm from all of the activity.
View 6 Replies View RelatedI cant connect to the internet. When I use other networks its fine. Also all the computers in this network im trying to connect to can connect and work perfect. I know i have the WPA code right. Its sending but not recieving any packages. The IP address 169.254.140.90 so i know its not working right.
View 14 Replies View RelatedI recently moved house and got a new ISP. I followed their instructions and set up my broadband. connection is working fine through the LAN, and I can connect to the wifi on my phone but when I try to connect my laptop via wifi it says it's connected but I can't access the internet and it looks like it's sending packets but not receiving.
View 7 Replies View RelatedYesterday none of the clients could access the server. I could VNC remotely to see that the server was running. On site I observed that the server can ping and VNC all the clients but while the clients can VNC to the server they cannot ping it, nor can they connect to it. I checked the router/firewall settings and nothing appears to have changed in the last 24 hours.
View 7 Replies View RelatedI have this new linksys wrt54gx2, my laptop connects to it, my modem LAN light comes on when its plugged into it via Ethernet cable . I can access my router settings.
View 19 Replies View RelatedI received a new modem with wifi and I'm still not receiving wifi even though I've hooked it up. I think that it's not hooked up properly.
View 1 Replies View RelatedIn Outlook 2003, I am receiving mail from all others on the office network except one person and wondering what I can check to fix this
View 5 Replies View RelatedEverything is fine except that whenever I am receiving packets, there is a corresponding upstream of packets which is subsequently slowing my download speed.I should be getting ~600kbps, but I am instead getting ~200kbps.The ratio of packets sent/received is almost 1:1.5, and of course when your upload bandwidth is being maxed it starts cutting your download speed.
View 3 Replies View RelatedMy internet connection is continuously transmitting and receiving, even when there is no application running! is there any way to find out what is being transmitted or received and how to reset the connection?
View 3 Replies View Related