My cable tv was working great until we just hooked up the wireless internet & it went out,well basically out,its all fuzzy now w barely a picture & no sound,All the wires inside & out seem to be tight & secure,i was trying to figure this out before calling the cable company,i just cant figure it out.
View 9 RepliesI just bought a DIR-835 Router. the wireless works good-the problem however is the PC I have hooked up to the cable box, now the internet works only occasionally. I have tried disabling the firewall ,etc. The only time I can get the internet on the cable box connected PC to work is when I reset the router. I have a Gateway PC with Windows XP, I use Google Chrome. I assume it must be a Router setting that needs correcting. My previous D-Link router worked fine with the cable connected PC.
View 5 Replies View RelatedMy printer is hooked up wireless. Can i connect my usb cable to my printer and my computer?
View 1 Replies View RelatedSo i have 2 laptops and various phones and iPods hooked up to my network via the wireless and have 3 computers, 2 PS3s, 2 XBox 360s hooked up via LAN cable (These are not always running all at the same time). From time to time (it varies on time of day) the internet disconnects from all the computers in the house but the LAN stays connected. It will sometimes come back online if you wait anywhere from 30 seconds to half an hour at times. Manually restarting the modem by unplugging it for a while and plugging it back in sometimes works, at other times it does not. We replaced the switch and the router so far trying to eliminate them as the problem to no avail. We have not replaced the modem yet. My ipconfig info is below:
Microsoft Windows [Version 6.0.6002]
Copyright (c) 2006 Microsoft Corporation. All rights reserved.
C:UsersMike>ipconfig /all
[Code].....
Some background on a scale of 1-to-10 with 10 being Sheldon Cooper and 1 being a computer less grandparent, I'm about a 6. I'm home from school for the summer and trying to access my parent's DSL by adding my router as a middleman. I tried the basic hookup (wall->modem-->router-->computer) using a Motorola MSTATEA modem and a Cisco E1000 linksys router
View 16 Replies View RelatedFor home use, I have a Windows Vista PC which is hooked up to the Internet via a wireless EV/DO modem that plugs into a USB port. I just bought an iPad and for connectivity, I then bought a WRT120N wireless router. But I cannot attach the EV/DO modem to the WRT120N since the EV/DO only has a USB port. I plugged the PC into one of the 4 ports of the WRT120N and the iPad sees the router, but what I would like is that it also sees the internet when the PC is online via the EV/DO modem. Is there a way to configure this? I realize that the PC would always have to be switched on if I want to have the iPad online, but for the time being I am ok with that.
View 1 Replies View RelatedMy second computer was enabled to be brought up on my PC, but after I took it back to factory settings I lost it .Can you tell me how to get it back on my PC?
View 6 Replies View Relatedi have an asus laptop that had a rogue virus...i brought it back to zero to the manufacturers settings...now i cant use wireless i lose connection when i take the cord out of the (phone jack looking like thingy) to my router (netgear) how do i use the wireless or find a connection?
View 1 Replies View RelatedI received a new modem with wifi and I'm still not receiving wifi even though I've hooked it up. I think that it's not hooked up properly.
View 1 Replies View RelatedI can't get my Brother MFC-J410w hooked up to my Dell Computer. I am running Windows 7. I ourchased this printer 8/2/2011 and have yet to print.
View 2 Replies View RelatedMy linksys router all of a sudden stopped recognizing the 3 LAN lines that are hooked up to it, we are only able to access the internet via wireless. any suggestions on why the router would all of a sudden stop recognizing the LAN lines?
View 7 Replies View RelatedI hooked up with a Linksys WRT110 wireless router to a Zoom modem and my DSL on my desktop and laptop are both working fine. My problem is my phone lines quit working. I plugged a phone into the box outside and I had a dial tone. When you try to call my house it just keeps ringing.
View 1 Replies View RelatedI want to connect to the Internet small office where docsis (internet over tv cable) is used as WAN.For similar tasks but other WANs (adsl, dial-up) I used 800 series. But now I can't find anything in this series to solve my issue. There is 815 but it has no wi-fi.
I can use cable modem that my ISP gave to me: this modem acts as bridge so I can use router with FE-based WAN but it is better to have one device instead of two.
I have a Sony Vaio running Windows 7 Home Premium. Yesterday I accessed the Internet at the office over a Cat5 cable. Last night I accessed the Internet at home via my USB Internet dongle (actually an O2 mobile phone). Today neither works. I have also tried to connect to the Internet via Wireless and that does not work either.Needless to say my desktop (using the same Cat5 cable) works. My mobile phone can access the Internet on it own. And others can get the wireless to work.My Vaio can connect to all three; however, all three say "No Internet access".I changed nothing between last night and this morning. I have scanned through the list of Windows Updates and nothing has been downloaded in the past week. I have turned off my firewalls (in both McAfee and Symantec Endpoint Protection). I have run the three NETSH reset commands with Administrator privileges. I have rebooted my machine numerous times. Nothing works.
View 4 Replies View RelatedAfter i reinstall my PC, i can't connect my vaio (VGN-TX750P) to internet through internet cable nothing appears in Control PanelNetwork and InternetNetwork Connections wifi is working fine but I can't connect using ethernet
View 7 Replies View RelatedI'm currently using wifi on my desktop but I usually disconnect and use cable. But just recently I do not know when, I can't detect any internet even the cable is attached to the pc
[code]...
My computer is only one month old. I did a clean install of Windows 7 on it and a clean install of Ubuntu 11.04 (dual boot). With Ubuntu, the wireless works without issue. In Windows, the connection is fine through a cable, but wireless networks are not detected at all. Since I did a clean install, I had to install drivers manually. I got these from the Samsung website (my laptop is a Samsung Q430). I think that my Wireless card is Broadcom but I am not sure. The wireless did work at the start, but there were connectivity issues, and so I removed the wireless driver from the device manager and reinstalled the Broadcom drivers. Now I can't get any wireless at all in Windows.
I think I may be missing some drivers, but I'm not sure. I have the Broadcom Wireless Utility but I can't get it to do anything useful. Right now I'm connected through a cable. Here is the result of ipconfig / all.
[code]....
The Ethernet cable really gets in my way and I'm trying to find a way to use my Internet without it... What would I have to change on my computer?
View 1 Replies View RelatedI have a ethiernet cable that I can connect to my pc and get internet, when I connect that same cable to the wirless router, I can't get internet, what am I doing wrong.The PC I am using connect to other wireless routers on the same network, but this ethiernet cable only work on pc when put in direct
View 4 Replies View RelatedMy laptop wireless suddenly stopped working yesterday ( this has happened before ) so I rang BT for them to mess about with the channels to fix it which usually works but my laptop cant even connect to the internet with the cable plugged in from the hub. The computer is connected with the wire now and is working perfectly fine.
Ive read on forums it could be the network adapters ive checked and they are all updated. Ive system restored and still no connection with either wireless or cable .
The error message is that the cable isnt plugged in... but it is and i know its not foulty. when i change the networking speed to 100mbs full/half duplex it sort of flickers a bit like its trying to get contact with the router but it never establishes it
View 4 Replies View Relatedmy system not connect with internet cable
View 1 Replies View RelatedI have DSL setup in my house and I want to know if using a cable modem will work and increase my speed. And will it work with a linksys router
View 1 Replies View RelatedI setup my own wireless connection using Cox Cable some time ago and it's been working with no problems. Today I tried to setup my sister's laptop with a wireless connection also with Cox Cable. Router is setup correctly and the connection says signal strength is excellent. However, the computer will not connect to the Internet.She has a Motorola Modem which a Cox Tech says he can see the modem so that's ok. I noticed the on the Modem the PC Connectivity light is amber and steady. While I have a different modem with the same company, my PC Connectivity light is green and it blinks from all the Internet activity P.S. All other setting are correct i.e. Obtain IP address automatically, DNS setting, DCHP etc.
View 5 Replies View RelatedI'm visiting my friend at her apartment and her internet only works through an ethernet cable. I unplugged the cable from her computer and plugged it into mine and it worked perfectly but when we switched it back to her computer her internet takes forever to identify and ends with local only connection how do we fix her computer?
View 1 Replies View RelatedFor some reason, i cannot connect to the internet using my current ethernet cable. I am 100% positive that adapter is working fine, as i had maintenance come into my room and check it out, but my computer won't connect to their internet through my cable. [code]
View 4 Replies View RelatedI have cable internet with time warner, who provided me with a basic ambit modem. It works if I connect it directly with my PC. But if I try to route the connection through my netgear router (eg. connect modem -> router -> PC), I don't get internet access. The troubleshooting tool tells me that "DNS server isn't responding".
View 3 Replies View RelatedI have a cable internet.There is no other hardware that connects to the Cable.There is no modem or router.Just the RJ45 cable that I plug in to my laptop and go online.Now,I want to convert this to wifi.what router/modem will I require and possibly with the model number and something thats low in price.I will use only one laptop and no intention of multiple user.I dont intend to use printers either.I am using windows 7.The network adapters that are installed in my laptop are: Intel Centrino wireless N 1030.Microsoft virtual wifi miniport adapter and Microsoft virtual wifi miniport adapter #2,RealtekPCIe FE Family Controller?
View 1 Replies View RelatedI normally have fairly speedy cable internet (12 MBPS) and it has never caused me any issues in the past. My ISP is a company called Ygnition (not the best). My problem is as follows: I was using my internet on Tuesday to play an online game (SW:TOR) and I walked away from my computer for about 30 minutes, and when I returned I had been disconnected from the game and the internet appeared to be non-functional. I've now discovered that the internet IS CONNECTED but it is INCREDIBLY slow. It takes at least ten minutes to load the google homepage and websites like speedtest.net are unusable. I obviously cannot use the internet with any efficiency, much less log into an online game.
View 1 Replies View RelatedI have a small office where we work over a cable network through our dear old router.Recently, we wired internet, which comes in via a wireless router to avoid another wire. every time one of us want internet to work, we have to disconnect the cable. We're working on windows 7 platform and I haven`tfound how to redirect the internet connection to the wireless.
View 2 Replies View RelatedI have ATT U-Verse wireless internet but cannot use it in parts of my house. Is ther a booster that I can get to increase wireless internet to the uncovered areas?
View 2 Replies View RelatedI have plugged my computer into the modem by way of a Ethernet cable and I immediately got a Local Area Network 2 icon that said a network cable is unplugged. Ive checked the cable with this PC, and it works. i tried this:1.) Shut dowm your PC.2.) Unplug the power cord. 3.) If you have a laptop, remove the battery as well. 4.) Walk away from the problem for at least 30 minutes. 5.) When you return, reconnect battery and power cord.5.) Start as usual.6.) If this solves the problem, take 20 minutes and post this to all of those message boards that you didn't find the solution to.
And This:Try a Simple Power Cycle ( as it is called so in Tech Terms )i,e Switch of the Computer/S , Router, Modem of your ISP Wait for 4 to 5 mins Switch on the Modem -- Wait untill all the lights come up and then again wait for 2 mins Switch on the Router -- Wait for 3 mins Switch on all other computers that are working, then check conectivity Switch on this computer that has a problem, then Try browsing.
This resolves most issues ( Basically it is the static in the unused ports that gets discharged )It that does not happen, delete all existing Lan Connection, Uninstall your network Driver, Reinstall the Drivers, then reconfigure you net connection then try It still that does not work out and you still get the " Network Cable Unplugged " Msg Then Unplug the Cable Then go to Start > Run > type regedit Navigate to HKEY_CLASSES_ROOTCLSIDThen Delete the key below {7007ACCF-3202-11D1-AAD2-00805FC1270E} Then Restart the comp and reconnect the cable and then tryand this:Using windows xp, the quick fix for this is to reinstall the drivers for your NIC
Is it possible to buy an adapter that, when plugged into the cable jack. will give me internet? My wireless network is painfully slow since it's based in the basement yet I work in the attic. (DL speeds tap out at around 250kbps)I dont have an ethernet only the cable jack.
View 1 Replies View Related