I have recently installed a new motherboard (Gigabyte X58A-UDR3R) and i've been having a problem where when i plug my ethernet cable in to my on board lan nothing is being detectedOn start up the with the cable plugged in the ethernet light will flicker letting me know its being detected then randomly shuts off when i reach my desktop. This happens and i dont have a connection to the internet
View 1 Repliesi need Ethernet and network controller drivers for gigabyte Q1500M
View 1 Replies View RelatedIs there a difference in an ethernet cable and an Ethernet networking cable? I have an Ethernet cable and a 6 port splitter I am trying to connect. I have 4 ports in the router that are in use. When I connect them to the splitter nothing s working.
View 1 Replies View RelatedI have recently purchased a PS3 and can sign into my PSN account but cannot access PSN when i try to play games on multiplayer.My university doesn't allow routers so I was wondering if:
1)Having a router would let my ps3 work properly online?
2)How to set up a router without it being detected.
I am having a problem with my Realtek RTL8168D/8111D PCI-E Gigabit Ethernet NIC. It is not detecting my ethernet cable, and thus leaving me without internet on my desktop, after i updated its driver. The cable is not the problem as I have tested the cable with my laptop. I tried rolling back drivers, doing system restore and removing drivers with driversweeper and letting windows install the drivers again. However, none of these worked for me. I doubt the NIC is faulty as it was working before i updated the drivers. I am using windows 7 home premium 64-bit.
View 9 Replies View RelatedI have a WAG160N wireless gateway . Yesterday when i tried to power it on after a couple of seconds the power led was solid green and the Ethernet leds were blinking with no Ethernet cable attached to the router . The ethernet leds would keep blinking for minutes . I tried to use a screwdriver to do a hardware reset ( with power on ) and i noticed that the power led would start blinking green/red for minutes . I tried to use another wired router which i have for backup and it could connect to the internet normally without a problem.
What the green / red blinking power led means ( power led is green and then changes to red and then it starts over ) ?
I have a Dell XPS M1530 with Vista 32 bit. When i plug in a cable i get nothing, no error, and the comp does not recognize that a cable has been plugged in. I think that this started after my Hard drive failed and Dell replaced it but i'm not positive. No errors (? or !) in Device Manager and I can't find the Marvell 88E80XX 10/100 Ethernet Controller in device manager. I have attempted to Reinstall the drivers. The wireless is still working. I have one Light to the right of the port that is on all the time solid but no flashing with the cable in or out.
View 14 Replies View RelatedI have a Realtek PCI GBE Family Controller. I recently reinstalled Win7 and it loaded drivers for the card automatically. I actually didn't notice the speed issue until I went to move stuff around on the home network.
The Device Manager lists the above NIC. Under Properties I have:
Auto Disable Gigabit = Disabled
Speed & Duplex = Auto Negotiate
I tried setting Speed & Duplex to 1.0 Gbps Full Duplex but I only interrupted a file transfer by doing this. (The Network icon in the System Tray indicated that the network connection was lost.)
I am using Cat5E 1 Meter or less cables. I have 2 PCS next to my desk with a D-Link Gigabit Switch sitting on top of one of the computers. AFAIK all ports on the switch support Gigabit.
I just received a new computer with the G41M-ES2H motherboard. Everything works as long as I use an ethernet cable, but I want to set it up to access the Internet wirelessly since I already have a wireless network. Is there some type of special set up to initialize a wireless connection, or do I need a separate wireless card to make this work. If I need a wireless card, which one is best for normal home-office type Internet use?
View 1 Replies View RelatedGA-890FXA-ud5 is supposed to have built in 802.11n. I just upgraded my Verizon modem to mifi2200 but cant's get them to play nice
View 1 Replies View RelatedI'm planning on building a gaming computer and I don't want it to run on my wireless network which is in the basement. I have absolutely no experience with networking, and I need setting up a gigabyte network and trying to reaching 1GB of speed. I have heard of gigabyte networks and what gigabyte networks are and how to achieve 1GB of speed.
View 14 Replies View Relatedi cant install network controller where do i can download network controller driver for gigabyte 8ipe1000,i cannot find it?
View 1 Replies View RelatedI don't have a router but I need to provide internet to two devices. I have a Gigabyte P55A-UD3 motherboard and a Linksys ethernet PCI card. Is there any way I can connect the Internet to my motherboard, and then provide internet to my second device via the PCI card?
View 5 Replies View RelatedI am assuming, that the slowest component on a network determines the connect speed? I am having a small network with 4 pcs and 2 of them show 1GB connect speed while the other 2 show 100MB. What would cause 2 units to run at the 100MB speed on a Gigabyte-Switch and Router?
View 3 Replies View RelatedI'm trying to set up a system where a lecturer can sit at home and give his (video and audio) class across the street via an ethernet cable strung across the street. The only problem is he has a mac, and we in the class running it aren't going to leave our PCs for macs!Is there any simple way to connect the mac to PC (without running through a router, as it slows down the system)?If so, what programs will work best for both PC and mac for streaming the video (and are free)[BTW I don't think a 100m cable is too long for the signal.
View 2 Replies View RelatedWhat is the best Ethernet cable too run around my house?
View 3 Replies View RelatedI'm switching from using a wireless usb adapter to a wired connection via ethernet cable.
When I plug the ethernet cable in however nothing happens, I've tried using it with a different computer and it works like a charm but this one doesn't seem to be working right.
HP Pro Small Form Factor 3010 Windows 7 32bit (Other computer was using windows vista)
Windows IP Configuration
Host Name . . . . . . . . . . . . : HPPro3010
Primary Dns Suffix . . . . . . . :
[Code]....
Yesterday I was on my computer when all of the sudden my internet stopped working. I am using windows 7 and at the bottom right I see a big "X" over the small computer icon. I already tried a computer reboot, a router+modem reboot, system restore, and I even reset the power to the room of the modem+router from the fuse box in my house. I tried everything.
I'm sure the problem must be from the actual cable or mother board itself. ( I hope it isn't ) I tried blowing out any dust from the ports and making sure that nothing was blocking the connection. I fell asleep last night with the internet not working, and woke up to it working. Every other computer in my house works except for mine. I tried all of the router ports as well. I did not attempt another ethernet cable though because my room is far and I would need to make a very long one.
I just reinstalled Windows 7 on my computer again and appear to be having trouble connecting to the internet with my ethernet cable. I've only ever used a wired connection on this computer, but am completely unable to do so at the moment.
View 11 Replies View RelatedThe Ethernet cable really gets in my way and I'm trying to find a way to use my Internet without it... What would I have to change on my computer?
View 1 Replies View RelatedAn older post on this forum told me to remove the adapter's driver software and restart the system. I did this, and it tried to install the software on startup but it keeps failing when installing. Forcing it to look for new driver software resulted in it saying the best software is already installed.
View 4 Replies View RelatedI have vista system, belkin wireless realtec ethernet cable and alice modem internet provider is o2 everything is working as i have checked but I GET NO CONNECTION everything was fine for 2 years and then suddenly after checking the system I am told that the ethernet cable is not connected,
View 5 Replies View RelatedMy Ethernet Cable is not reading, when ever i plug in the Ethernet cable into the port into my Toshiba laptop, it doesn't read, What is the problem, My cable, Laptop or (ISP) Internet service Provider?
View 1 Replies View RelatedWith just a printer and an ethernet cable, can this be used to print without internet, modem, etc. just like using an USB to printer?
View 3 Replies View RelatedI am trying to connect my two laptops with one Ethernet cable without any internet to a Network. However, just one of the laptops is identifying the connection, the other doesn't recognize that it has been connected to another laptop. Obviously, the cable itself is working (because one laptop identifies the connection), but what might be the problem that the other laptop doesn't recognize any connections?
View 6 Replies View RelatedI would like to know what is the difference between LAN cable and ethernet cable? Is both cable is same? can we use CAT 6 and CAT 5 cable as LAN CABLE?
View 4 Replies View RelatedI'm trying to connect to the internet via the ethernet cable available in my office at the university but it won't work. I'm able to see other computers connected to the network, share printers and have access to shared files but have no internet access. I know that the problem is not the cable or socket because my old XP computer connects to the internet just fine.
I had a similar problem back at home but I just restarted the modem and was able to connect.
Setup:
Lenovo x220 tablet
Network card: Intel 82579LM Gigabit Network Connection
So I am trying to connect my desktop to my router via an Ethernet cable. When I plug the cable to my PC, it won't connect to my router. However when I plugged the cable to a laptop, it worked fine. I also went to check the Broadcom NetLink Gigabit Ethernet adapter in Device Manager and it has an error that says "This device is not working properly because Windows cannot load the drivers required for this device
View 2 Replies View RelatedMy onboard adapter wasn't working so I bought a new dlink adapter. Adapter installed and is registering in device manager.. but it says that there is no ethernet cable connected. I have a laptop connected to the same router that is connecting to the internet. I switched out cables with ones that worked with the laptop and on the desktop before. I have cycled the router
View 2 Replies View RelatedI'm having trouble with my ethernet port. I have a Asus g73jh computer running 64-bit windows 7 and i have an atheros ar8131 pci-e gigabit ethernet controller NDIS 6.20 for my network adaptor, that is fully updated and says is working properly but doesn't recognize when an ethernet cable is plugged in. The cable works on my xbox fine so I know that the cable works fine. I'm pretty sure that there might be something physically wrong with it or I just don't know.
[code]....
At the moment I cant run an ethernet cable through my house from my router to my desktop PC (Which is where I use the internet/play games etc) and connect directly that way because my parents dont want cables going through the house etc etc.For the past 2 months or more I used my old laptop to pick up the wireless connection downstairs then I bridged the connection and used my ethernet cable from the laptop into my PC/Xbox or whatever, no problems until today, I wouldnt even have to log into the laptop, i would just turn it on and leave it at the login screen and I would have internet on my desktop/Xbox.Tried to do that today and was getting unidentified network on my desktop, i dont know what the problem is, I can connect directly to my router with the ethernet (I tried it) but not the old way anymore, i'm on the laptop now on the wireless internet.In network connections there LAN network isnt there anymore, its just the 'Unidentified Network' which is the bridged connection.
View 8 Replies View RelatedI have two ethernet cables, a long one and a short one. The short one works fine, but the long one does not work with my computer. It has worked with other laptops, so I am fairly sure the cable itself is fine - is there anything I can do
View 3 Replies View RelatedI have searched the forums and found that there have been others with the same problem as me,but none of the solution offered was working for me so I decided to start this thread.I have an Acer laptop that wont recognize my ethernet cable, it says that there is no cable connected.
View 1 Replies View Related