Yesterday my wireless internet just appeared to stop working completely, it has always worked fine up unti now!I have checked all the usual issues, it is nothing to do with my router as i can use other laptops/desktops to access the internet fine.I am using a Pavillion DV6-1215sa which has a Atheros AR9285 802.11b/g WiFi Adapter.It has full strenght but just says Limited Connectivity, so it is picking up the wireless network but wont actually let me connect to the internet via it.
I am able to access the internet when i hard wire the ethernet cable into my laptop, but the just wont work for wireless.I have tried lots of different suggestions so far, but still cannot access the internet.
I'm trying to get a static IP because I'm hosting a team fortress 2 server.So on windows, I made my internal IP static and that worked.On my router(cisco EPC 3925) you can go to administration ,then management and it says connection mode: DHCP which you can change to Static IP. When you change it to static IP it askes you:[CODE]
i've one of my 3500 that when finish to download the os, the front led stop working. During the power on and all the test the led is flashing in various colors pretty ipnotizing :-) When it bacame operative, the led stops. If i issue the test led flashing console command it works.
I recently built a new computer and it runs a wired connection. I was having problems with dns dropping.until i set static ip and dns. But now whenever my computer is on my router doesn't broadcast a wireless signal and none of my devices can connect to wireless until I turn off my computer. The router is a linksys wrt54g2
Region : Others Model : TL-WR741ND Hardware Version : Not Clear Firmware Version : ISP :
after year and a half of using TL-WR741 ND router, it suddenly stop working during the night. I have no problems with router before this happened (I think only one or two reset in 1 year and 6 months). System led light does not flash (some sytem error) and I can't access to 192.168.1.1 router setup site. I tried almost everything, unplug power, reset etc. for almost 100 times, reconnect the router with modem and PC in all posible ways, but still can't establish connection or even access to router's setup. Obviusly internet works fine?
After an hour on the phone with the Linxys support people I'm feeling like I've been scammed.I have a 2 year old, almost to the day, Linxys Wireless-N Broadband Router, model # WRT160NVZ, which decided to stop working today. I contacted Linxys support and was told since it is 2 years old it's no longer under warranty, ok. If I choose I can pay for a service call and the tech may be able to fix the router, no guarantee. I had another option to purchase a service plan but again no guarantee repairing the router. My third option was to purchase a brand new wireless router for a discounted price, if I chose this option the tech would attempt to repair the router at no charge. I expressed my concern that it would take a few days to receive the new router and what would I do while waiting. I was then assured the router I have now could be repaired and would be able to hold me over until I received the new router.So I chose the 3rd option purchasing a M20 wireless router to be shipped to me within 3 days. After providing my credit card number and billing/shipping address the technician was now able to work with me in trying to repair the current router. He had me access the Linxys website, he instructed me in resetting the router and resetting the settings for it on the website and PRESTO, my 2 year old router now works again.but feel that this is a scam, programmed in the router to occur within 2 years of purchasing where the settings entered no longer work but once changed works perfectly well.
I've lost connectivity with all but one of the ethernet ports on my E4200 router. My desktop PC was connected to Port 1 but stopped working. Network troubleshooting via my Windows 7 Dell 8300 said I was not connected and to check the cable. I did that with several different cables and tried the usual router and modem reset. Only through trial and error did I find that I could connect to port 4 which is why I am able to write this post. What could have changed to disable ports 1-3 and can I get them working again? No issues with wireless connectivity.
I received a Linksys E1200 from a friend who careless tried to upload an incorrect configuration. After that the device became use full. It don't work at all.
Few days ago the wireless in my son's Dell Inspiron 620 went bad. It does connect to my old router (WEP), but speed is terrible and connection goes bad after some time. I can also see my modern router and enter the key successfully (WPA2), but it won't connect. Connection to both routers went well for months before, and still goes well from all other devices in the house.
I read the issue with McAfee that was posted late August and followed the steps. Connection in safe mode didn't work. Then I removed McAfee from the PC, no difference. Then I restored the PC to a couple of days before the issues began, removed McAfee again (as it came back through the restore), no difference.
I reinstalled the drivers of the Dell wireless card, no difference.
wrt54g v1.1 After setting up the wireless router, I can use the internet on the pc as well as a wireless device. However after putting my pc in standby mode then back on, I can no longer connect to either. I have to restore factory defaults each time and re-enter all passwords and settings.
I have two computers in my house, one is set up directly to the modem/router and the other (in my room) is set up wireless using that belkin adapter above.
Everything has always worked perfectly, but two days ago things went haywire. If my PC connects to the wireless, then it makes the router stop working for the other computer and any wireless devices I have. As long as I don't have my PC connected, then things run smoothly and there are no problems, so it's definitely stemming from my PC?
I thought it might have been the router at first, so I switched it out and it worked fine for over 24 hours, but then the problem came back.
Windows IP Configuration Host Name . . . . . . . . . . . . : Sunako-PC Primary Dns Suffix . . . . . . . :
Whenever I start a Cisco VPN from any machine on the network, DNS requests to the DIR-655 stop working. If I reboot the router, DNS starts working again (the VPN was left on). Why starting the Cisco VPN would freak out the router?
Once again I'm stuck to tethering on my phone due to my router deciding to call it quits for the random moment. I cannot access its control panel, the network just goes kaput. Given that I don't have access to the router since it's part of a double house (the side I'm not on of course), this is getting beyond irritating to reboot it when this happens as that is the only way to fix it. The connections are even wired, too. What kind of money does it take to get a router that is going to STAY on and just work? I'm ready to dump some serious cash into this at this point because this happens at least twice a week anymore. I just want a router that works. It needs to be wireless as my neighbor does use his kindle on it every once and a while.
I have installed VM ware v Sphere Enterprise Plus 5.0.0 and created a VM using an OVA file with LMS 4.1 running in Linux. It was working good since 3 weeks ago and I was adding snmp server configuration in all my devices (routers/switches) and suddenly one day DCR Server process stop working. I was trying the following actions:
1.- dmgtd stop -> to stop daemons 2.- dmgtd start -> to start again the daemons
And the DCR Server does n´t start up automatic.
Then I try this:
1.- pdexe DCR Server
And show this message:
[CPLMSCOL01/root-ade ~]# pd exec DCR Server ERROR:Get reply from server failed:
I have setup a Cisco SR520W and everything appears to be working. After a few hours, it looks like the WAN port stops forwarding traffic to the Internet gateway IP of the device.
If I unplug and then plug in the network cable connecting the WAN port of the SR520W to my the modem, traffic startings flowing again. Also, if I restart the SR520W, the traffic will flow again.
Here is my config file:
Building configuration... Current configuration : 17830 bytes!version 12.4no service padservice tcp-keepalives-inservice tcp-keepalives-outservice timestamps debug datetime msecservice
I'll be downloading off of newsgroups and be pulling 3-4 MB/sec, no problems. My downloads are charted so I can see my speed never drops at all.but my web browsing will just STOP, for ~30 seconds. I'll have multiple tabs just STOP and crap out, while my downloads run fine. This also happens when I'm not downloading, so I know it's not a bandwidth issue,i assumed it was a router issue until I replaced my router and am getting the same issue.
I know about recomendation to update a system software! Here is my software version and rdp plug-in version: asa843-k8.bin, rdp-plugin.120424.I also tried to use previous version of rdp plug-ins, but connection through RDP still not work normally! 90 percent of the attempts to give a black screen.
I am using a dell Vostro 3550 series, window 7 which I recently upgraded it to 64 bit from 32 bit and after that my Intel WiFi utility stop working. I can create the WiFi hot spot and connect my phones and laptops but its not sharing the internet. I've checked the "share my internet" button too but still then its the same result.
Perhaps once a week my ethernet port stops working. That is, it is still displayed as 'working properly' in the device management screen, but it is unable to connect to dns. System restore does not solve this problem. plugging the ethernet cable in and out (10 times) does not solve this problem. Modem reset does not solve this problem either. I decided that perhaps ethernet controller is faulty, or perhaps the ethernet port in itself- so I bought a 'usb to ethernet' adaptor and surprisingly the internet connection problem persisted (during the instances when my laptop ethernet port had problems connecting to DNS, the adaptor was also unable to connect to internet).
What does solve this problem is this: I have another notebook - I plug the ethernet cable into that computer. Obviously, internet works without any problems with my second notebook. After that, I plug the ethernet cable back into the laptop which is now unable to connect to DNS. Quite often the Not being able to connect to DNS issue still remains the first time I do this, so I have to connect ethernet cable back into my second notebook and then plug it back into the notebook with a connectivity problem. After I do this 2 or 3 times, my windows 7 laptop is finally able to connect to internet.
I'm having problems connecting to the Internet using the wireless adaptor - it will connect initially but the connection is very very slow and then will eventually drop out and stop working.When I connect using an Ethernet cable, there are no problems whatsoever so I know it is not a service provider issue.I have updated the BIOS to A11 and all drivers are up to date. The wireless adaptor is Intel Centrino Wireless-N 1030. [code]
My 3rd day with my newly bought All-In-One 2320 i7, 2TB, 8MB...This is the seond issue I found on this machine:Browse iplayer page, choose a video to watch, but...when viewing video from iplayer in IE, browser stop working. The whole page freeze.Same thing happened on youtube.
Things I have tried:
- Test it in Firefox. Same result. So bad.
- Update my flash player, java,..etc.
What else can I do? So dissapointed. I have promissed my son to show him the cbb animation cartoon on my new computer (big screen)..
So I just got this new WRT160Nv2 router. I have (1) wired computer and then my laptop running wireless to it. For the first couple days I had some issues getting consistant internet but after reading some stuff on here I downgraded to the version 8 hardware and it worked GREAT for about 3 days. Now my power light won't stop flashing and I have NO internet connection at all through the router. I have tried to reset the router by holding down the button and also unpluging it but still nothing.
every couple of minutes my internet stop sending data but the downloads keep running, i can see it in my net meter, my skype get disconnected, online games too, this happen specially between 11 am and 9 pm, i know that my isp during pick hours is most probably the problem, but my friend that lives close dont have this problem with the same isp. is there anything i can do to solve this?
When I browse or surf the internet with my computer, it causes the router to stop working on all devices connected to it. This includes my laptops, iphone, ps3 and other desktop. However, if I or anyone else connected to the router had a stream running on youtube, a file that is downloading, a game running online or voicechat with ventrillo, nothing happens to those processes. I just can't start a new download, or open a new tab, or start anything that requires internet connection.I've tried using different browsers, I've tried updating my computer, using different ports both on my computer and the router, shutting off all my firewalls, factory resetting my router and nothing works.I've narrowed the problem down to an issue with my computer as this would never happen to any other or device. This problem ONLY happens when I surf the web or view/open websites.The only way I can fix the problem is by walking up to my router and restarting the router (the router only) and waiting a minute for my computer to reconnect.I've noticed that the router stops working when I go to sites or links that have on screen popups of flash or java. When I check my network connection after the internet stops working, the rate of packets received becomes dramatically reduced.
I will like to know that i have 3 computer in a router (tplink broadband router n-series) network which has internet access but i don't want to access internet in other 2 computer how can i do that?
I have this new problem, when I start my computer its connect fine to the internet, after a while its stop and lag after that but the modem is working fine and even with my laptop works also fine I've use HiJackThis and I got this:Logfile of Trend Micro HijackThis v2.0.4
Scan saved at 09:57:27 م, on 04/01/11 Platform: Windows 7 (WinNT 6.00.3504) MSIE: Internet Explorer v8.00 (8.00.7600.16385) Boot mode: NormalRunning processes:[code]......
I have little knowledge about computers and any thing IT related. I use os: xp (sp3), AV: Bit Defender, Malwarebyte. Constant dowload traffic @120-130 kbps even when internet is not in use, os updates turned off.
