Routers / Switches :: Where Is Wps Button On Router
Jan 1, 2012where is the wps button on router
View 2 Replies
ADVERTISEMENT
Routers / Switches :: Have Westell Wireless Router Where Is Wps Button
Jun 28, 2012Have a westell wireless router, where is wps buttob
View 2 Replies View RelatedCisco Switches :: Broken Reset Button On SG 300 Switch?
Oct 3, 2012I can't seem to reset my switch and realized the reset button is missing/broken off. Is there an alternate method to reset the switch to factory settings? If not, how do I figure out the IP of the web interface, it is not the default.
View 8 Replies View RelatedBelkin Routers :: Does N1 Vision Have A WPS Button
Jan 21, 2013Does the Blekin N1 Vision have a WPS button? I'm trying to add an extender.
View 1 Replies View RelatedBelkin Routers :: F5d8233 How To Reset Without Button
Feb 6, 2013How can I reset my N wireless router f5d8233-4v3? The reset button must have been pushed inside. I was setting it up as a repeater and then it keeps timing out.
View 1 Replies View RelatedBelkin Routers :: F5D8235-4 / Reset Button Instead Of Powering Down
Jun 13, 2013According to the Belkin support tech, apparently the weather (?) may have effected my Belkin Model F5D8235-4 v3 router. My wife pressed the re-set button instead of powering down which according to the tech set my router to reading zero (0).Belkin tech refused to tell me how to re-set the router unless I paid $75 for a six month support plan because mine expired recently.
View 1 Replies View RelatedBelkin Routers :: F5D8236 Rebooting Itself Because Of Reset Button
Apr 22, 2013Why My Belkin Router F5D8236-4 Ver 2 always rebooting itself. the router lamp is on and then the security lamp is on and then the router rebooting itself. this happening because im push the reset button. im already try to upgrade the firmware with recovering tool (Boot Loader / Tiny Kernel Version v0.02) from 192.168.2.1 but the problem still happening.
View 3 Replies View RelatedCisco Routers :: SRP527W VPN Status Disconnect Button (FW 1.01.26 (003))?
Jun 28, 2012Where is the disconect button on the VPN Status page gone in FW:1.01.26 (003) ? It used to be there as you can see in the below screen shots...
FW: 1.01.19(004)
FW: 1.01.26 (003)
Cisco Routers :: RVS 4000 - Allow Radio Button Stippled Out
Jan 17, 2012This type of issue has been posted time and time again by others. In this particular instance the ability to deny and allow access based on a time and day for one or more MAC id or IP address or range of addresses does not work. Because the code is so "weak" that it cannot handle a policy which passes the midnight threshold into the morning (the test is actually commented out in the code), one is forced to write one, perhaps two inverse permit rule(s). In this case, it cannot be done because the "allow" radio button is stippled out.
Some simple digging reveals that the file AccessRes.htm gets to the browser with the "allow" radio button stippled out because the token "disabled" appears in the generated html.
<input type="radio" value="allow" name="f_status2" onclick="setBLOCK()" disabled="">
I have several of these devices. They are all new V2 units. They all have the latest version of the firmware and they are all broken the same way. This behavior is the same on various flavors of browser. As an experiment, based on SOP responses I've read, I downloaded and flashed with the latest firmware (same version as delivered), and then performed the factory reset. No change. It's broken.
Belkin Routers :: AC1000 Menu Button On Finder Bar Is Not Illuminated Blue
Jan 6, 2013I am using a Belkin AC1000 DB Wifi Dual-band AC+ Gigabit Router with the Belkin Router Monitor on a Macbook Pro (mid 2012) running OS X 10.8.2. I recently installed the router and the Belkin Router Monitor and everything works very well. I have one concern, however: the menu button on the finder bar is not illuminated blue, as it should be, but gray.
View 1 Replies View RelatedBelkin Routers :: No Wifi Protected Setup (wps) Light And Button On N600 Db
Dec 1, 2012On Page 16 of my N600 DB manual it says that below the "Router Status Light" and above the "WPS" letters there is a "Wi-Fi Protected Setup (WPS) Light and Button". When I look at my router all I see in this space is a raised rectangular plastic strip. Should I have a light and button there?
View 1 Replies View RelatedRouters / Switches :: Setup An Home Network With A Wireless Router And Use Multiple Switches?
Jan 29, 2011I want to setup an home network with a wireless router and use multiple switches for wired connections through out my home. I currently have an Airport extreme hooked up to a cable modem and a leviton gateway hooked up to the Airport. The 2 computers connected to the Leviton are on a windows 7 homegroup and share fine, but won't share or discover any wireless device connected to Airport. My main goal is to have a wireless/wired network with all computers sharing information with each other. I want 2-3 wired switches/gateways with a min of 2 devices connected to each, connected to my wireless router whiich is connected to cable modem.
View 3 Replies View RelatedRouters / Switches :: Connect 2 Subnets With Two Switches And One Router Using SIM Software?
Apr 23, 2011how to connect two subnets with two switches and one router using router sim software?
View 1 Replies View RelatedWPS Button On Linksys WRT5462 Router
Mar 5, 2011I am trying to hook my tv up to my wireless network but I cannot find the WPS key on my router? Is this necessary?
View 1 Replies View RelatedLinksys Wireless Router :: No Power Button On E3200?
Oct 3, 2012I just got my new router today but i don't see a power button on the back of this unit. Am i blind? Of course the unit comes on when i plug in the adapter but i don't see a on off switch.
View 7 Replies View RelatedLinksys Wireless Router :: No Power Button On WRT54G
Jan 3, 2013I have a Linksys Wireless Router, model WRT54G. I read in the user manual that it is best to turn off the router when not in use for better security measures, but there in no power button on the router. So does this mean that the power cord would have to be unplugged from the electrical outlet each time to turn the router off? This is kind of inconvenient, especially where my cord is plugged in. Also would unplugging it from the outlet each time, would this mess up the settings on the router? Is it really necessary to turn it off?
View 9 Replies View RelatedLinksys WRT160N Router Not Working After Pushing Reset Button?
Dec 14, 2011I have a Linksys wireless router WRT160N, and its worked fine for the past year, till last night, when I pushed the reset button trying to solve another issue and now my router isnt working. I ran Linksys setup disc and it said I was all up and running, but still cant get online with my laptop through the router.I am at a point where I have my default gateway address 192.168.1.1 and my IP address, but not sure what to do with that to get this issue corrected.
View 14 Replies View RelatedLinksys Wireless Router :: E2000 Web Protected Setup Button?
Aug 31, 2012When adding a device that has a web protected setup button, can I use the web protected setup button on my Linksys E2000 router to set up the device even though I setup up my router using the Manual setup on the Web Interface configuration?
View 1 Replies View RelatedLinksys Wireless Router :: Where Is Logout Button On Cisco E3200
Nov 28, 2011I do not see a Logout button on the web configuration interface. Should not there be one?
View 1 Replies View RelatedLinksys Wireless Router :: Can Reset Button Be Replaced On WRT120N
Dec 26, 2011I can not get online, after a "Verizon" outage with my router connected, the Reset Button will not move. Can it be replaced? Or should I scrap the unit?
View 2 Replies View RelatedLinksys Wireless Router :: Reset E1550 With Bottom Button
Apr 6, 2012I reset my E1550 wireless router with the red button under it. Ever since then I can not connect to internet.
View 3 Replies View RelatedLinksys Wireless Router :: WRT610n Cannot Reset By Button Press
Aug 27, 2012Mu old router WRT610n is not reachable anymore... The address 192.168.1.1 gives an error and I cannot reset the router by button press.Wireless doesn't work and two of the three the leds keep on blinking all the time... One ethernet connection is still functioning as should.
View 9 Replies View RelatedLinksys Wireless Router :: WPS Push Button On WRT610N Does Not Work?
Mar 28, 2012I am facing problems of the WPS Push Button on the Linksys WRT610N version 2.0 router which has stopped working. I don't see the Blue LED blinking. The WPS button no more works on the router. It was working before. I did a firmware upgrade. Could this be the cause?
View 4 Replies View RelatedRouters / Switches :: Get An IP From Behind A Router?
Apr 29, 2011i have a router connected to my ISP which can get me 2 different IP's at all times (the router gets one IP).Now i want to get my computer to have a different ip as my router has (seen from outside my home network) - i want my computer that accesses the internet through my router to have a different IP as my router. I know that if my computer gets it's IP from my router's subnet, then it will (seen from outside) always have the same IP as my router. So the question is how do i get around this ? Do i just have to change my PC's DNS / gateway settings to match my router's ? The PC is connected to my router via wifi. Or would forwarding some ports on my router work ?
View 3 Replies View RelatedLinksys Wireless Router :: WRT54GL Restarted Without Pressing The Reset Button?
Oct 21, 2011I bought a few months ago a WRT54gl router for home use. It works nice and everything, but today was the second time it totaly resetet without pressing the reset button. Why the router is resetting by its own?
View 1 Replies View RelatedLinksys Wireless Router :: Wrt54g V2 Reset Button Not Resetting Password?
May 13, 2013I was given this router (it's my 3rd one) and cannot get the reset button to reset the password. I have run throught a 30/30/30 reset as well as just holding the button in for the standard 30 seconds.
I know the router works, as in i can ping it. It asks for a password when i go to 192.168.1.1, but *blank* and "admin" do not work. When i click the cancel button it displays a pink(salmon) screen that says "401 Unauthorized Authrization required". (all of this is when i am connected to it with an ethernet cable to #1)
When it's sitting there it has an led lit over power and one ove wlan which flickers from time to time.
Routers / Switches :: Get Into Router To Allow Vudu Box
Feb 28, 2011I am trying to get into router to allow my VUDU box to connect so I can download movies,
View 1 Replies View RelatedRouters / Switches :: Cannot Get Router To Reset
Feb 16, 2013i cant use a new tablet i bought due to i can't remeber pas word for router it was such a long time ago it was installed
View 2 Replies View RelatedRouters / Switches :: How To Configure Router
Mar 30, 2011i have a pppoe connection coming through ethernet line. i.e i need to use dialer that i have created on the desktop..and i have bought a new Linksys E1000 router v2.1..now my problem is that1) After entering all the settings correctly my router worked for 3 days after that the net is not working.i.e it cannot connect to the internet keeps giving the error cannot get IP from PPPOE(i have connected my router in pppoe mode and use the router status page to connect and disconnect)I have also updated the router to the latest firmware 2.1.01 and after that the problems have started.My Net works if i directly plug the Ethernet cable in the PC.the problem starts when i connect it to my router.
View 3 Replies View RelatedRouters / Switches :: Cannot Get Router To Work?
Jan 28, 2011I have a Linksys Cisco system router and cannot get it to work, I believe I have it hooked up right. I am wanting it for a Sylvania wireless mobile internet device.
View 1 Replies View RelatedRouters / Switches :: Trying To Use Hp Desktop With Router
May 4, 2012HP desk top XP media edition 2005 is it wifi capable
View 3 Replies View RelatedRouters / Switches :: How To Get A Signal From Router
Jan 14, 2011Used the reset button, but my system is still not detecting my router!
View 3 Replies View RelatedRouters / Switches :: How To Connect 4 PCs Using A Router
Mar 8, 2012I have 4 computers on LAN using a router and I cannot see eachother, don't know how to configure the PCs. The router is set on DHCP for LAN, the PCs are using Windows 7 and can connect through the internet the router is providing (4 dells) but don't know how to set the computers to see eachother and to share files.
View 2 Replies View Related