How To Convert Local Lan Connection In Wifi System
Jun 20, 2011How to convert local lan connection in wireless connection.
View 1 RepliesHow to convert local lan connection in wireless connection.
View 1 RepliesI tried to use the Dell on a local wifi system with no luck and now I've done something and can't log into the computer. I've tried every user name and password I can think of.
View 2 Replies View RelatedI have a reliance netconnect + broadband connection (usb device) which I use to connect my laptop. Is there any device/ software which will convert this to WIFI so that I can use the same connection for my other WIFI enabled devices?
View 1 Replies View RelatedMy local area network connection disappeared from system tray
View 4 Replies View RelatedI'm building a security camera system,which can connect to internet to be viewed from away.The camera receiver connects to the modem with a Cat 5 ethernet cable,which results in a cable running across the room. My modem is a wireless type,but the camera receiver only has cable support it seems.
Is there a device that I can use to get rid of the Cat5 cable in this scenario?
My brother is visiting me, and i am trying to connect his computer to my router (wireless), i got connected but access says local Only.When connected by wire i get internet access ( Access: local and Internet)His computer had several adwares/spywares and numerous toolbars...... that i uninstalled. Cleaned by Malwarebytes and AVG 2012 free edition.Scan results are clean now.
ISP: RCN (cable 25mbps)
Router: Cisco Linksys E1000.
Cable Modem: Motorolla surband
I have 2 other computers connected through wifi on this router without any problem. Vonage Phone is connected to this router. Xbox is connected wireless and LG Blu-ray player is connected (wired).Xirrus Wi-Fi inspector screenshot is attached, IPCONFIG /all was run wile wireless was on ( of course Local only) but cable was not connected.
Windows IP Configuration
Host Name . . . . . . . . . . . . : PK-PC
Primary Dns Suffix . . . . . . . :
Node Type . . . . . . . . . . . . : Hybrid
IP Routing Enabled. . . . . . . . : No
WINS Proxy Enabled. . . . . . . . : No
[code]....
Me and my girlfriend moved into our new flat in September and since then we've been sharing my laptop as her laptop refuses to connect to our Wi-Fi, we are with Virgin Media and I have had literally no connection problems whatsoever but hers gives us various errors like 'No Internet Access' 'Local Connection Only' and sometimes it will connect for about 4 minutes and then just disconnects again, the only Anti-Virus she has running is AVG. It has also happened with friends who have brought there laptops over.
View 8 Replies View RelatedRegion : Others
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : 3.13.23 Build 121225 Rel.37950n
ISP : UPC Hungary Ltd.
I can't able to recognize a system - all wifi clients lose connection. When this happens, the ping answer time rech the ~2000 times, then totally lose the connection, the SSID is dissapear - checking with my phone (android - wifi analyzer) and TL-WN822N USB wifi adapter (with the inSSIDer application). Meanwhile the cable clients and the WAN connections works fine, didn't experience anything.If I restart the wifi service with the hardware on/off button, it runs well for some time.This problem appeared when I used the two older official firmware too.
I tried the auto-chanel function width auto channel width, tried to manually set up one of the less interfered channels with both 20MHz and 40MHz channel width, but none of them bring the solution.The intresting thing is, if I change the router with an old D-Link DI-604, the signal is weak, but the wifi connection is stable, with the same TL-WN822N adapter.I tried to guarantee the router, but after two weeks, my reseller said, it looks ok, they - at the TP-Link service - didn't find anything.
I have a guest house in the back. I access the net there through my Dell laptop using WiFi. I have a television there that needs to have its operating system upgraded through the internet. All it has is a LAN connector. How do I get my Laptop to convert the WiFi to LAN so all I need to do is connect a LAN cable between my laptop and the TV? Or do I need to buy something cheap to convert WiFi to LAN?
View 3 Replies View RelatedI'm trying to get an HP laptop running Win7 to see a desktop running WinXP on my network (both wired and wireless) When I run the troubleshooter in Win7, it tells me "system clock does not match local time" as the reason. I have a Belkin wireless router attached to my cable router. I have updated the system clock via the internet on the desktop and checked the time setting in BIOS. These seem to match. I have googled around on this and can't find any accounts similar. My son's Vista laptop and the Win7 laptop have seen each other since day one. The laptop and desktop did see each other at one time, but the connection was lost after I went to a hotel and changed public network settings temporarily. I can ping the desktop from the laptop, but it times out when pinging the laptop from the desktop. I'm running an avast firewall on both, but can't see a problem there.
View 6 Replies View RelatedI work in a company that has all our computers on a domain. no one of End Users is local admin. I always use remote desktop to access End Users computers,when I log in with my user name its OK but when I try to log in with End-User user name I got this message.The local policy of this system does not permit you to logon interactively.I do alot of searches and they said I have to add user name to remote access desktop group, which is difficult because I cannot add all users to the remote desktop group.when the user become a local admin to his machine , then I can access his computer remotely with his user name, and of course I cannot make all users local admins because I have to break the local admin group policy.
View 2 Replies View RelatedConvert Wi-Fi signal to LAN?
View 2 Replies View RelatedI have a cable internet.There is no other hardware that connects to the Cable.There is no modem or router.Just the RJ45 cable that I plug in to my laptop and go online.Now,I want to convert this to wifi.what router/modem will I require and possibly with the model number and something thats low in price.I will use only one laptop and no intention of multiple user.I dont intend to use printers either.I am using windows 7.The network adapters that are installed in my laptop are: Intel Centrino wireless N 1030.Microsoft virtual wifi miniport adapter and Microsoft virtual wifi miniport adapter #2,RealtekPCIe FE Family Controller?
View 1 Replies View Relatedis it possible to connect toshiba satellite pro 4600 into internet without the use of cable? how to convert it to wifi?
View 1 Replies View RelatedAm trying to patch an RG8U cable from a WiFi dish to an ethernet cable for connection to a router.
View 8 Replies View Relatedis there an adapter ( wifi reciver ) that plug into RJ45 port so RJ45 can receive wifi signal ?
View 1 Replies View RelatedI have an equipment which has LAN port for wired connectivity to the computer. I can connect 10 such equipment thru LAN to the computer & display the data of all the equipments on computer screen. This LAN network I wanna convert to Wi-fi/wireless.
View 4 Replies View RelatedI am trying to open internet through wi-Fi but my system is asking for network security Key and I am unable to find it out.
View 3 Replies View RelatedMy task is to plan out on how to setup a WiFi Access System in our college.There are more than 3000 users which include students, faculty, etc.Area is spread across almost 1 acre of land area.
Q1. How do I go about setting up a system where MAC based WiFi Access system is achieved?
Q2. What equipment will be needed, like routers, access points, etc.?
Q3. How many Access Points will be required, and which will be the best in terms of cost, range, speed and performance.
Q4. Which would be the best equipment for this?
Q5. User management solution?
Two years ago, a lightning strike fried my ADSL router and LAN port on the motherboard (ASUS A7V8X-X) of my now very old system. After that, I bought a Wi-Fi USB adapter (AirLive WL1600-USB) and disabled the fried LAN port. Since that moment, my computer kept freezing totally randomly for the past two years - it didn't matter whether I run a dozen of programs or simply leave the system alone. First I didn't know what's causing those freezes, until a week ago. You see, we were forced to cancel our ADSL account for four months, so I haven't used that Wi-Fi adapter for the entire summer (I disconnected it and uninstalled its drivers). During that time - not a single freeze for four months, no matter how great the system load or temperature. A couple of weeks ago, we activated our ADSL account again, so I plugged the Wi-Fi adapter in and installed its drivers - and the freezes started again.
View 3 Replies View RelatedI have been using my ACER tablet with my Netgear router for several months with no problems at all. Then last night I decided to restore my tablet to its default settings, meaning that all my programs, apps, files, etc., were erased. Then I rebooted my tablet and started from scratch, entering the requested information. Everything appeared to be going just fine until I turned on Wi-Fi and attempted to connect to my network (Secured with WPA2), which was available and showed Good signal strength. I clicked on it, then attempted to enter my password. As soon as I entered the first digit of my password, the option to Connect to the Internet immediately disappeared, becoming greyed-out. Repeated attempts to connect failed for the same reason.
I called ACER Level 2 Support and tried a couple of procedures which didn't solve the problem. One was pushing the Reset Button twice. The technician told me that I may have a problem with my router settings. He suggested that I go to a local fast food outlet and see if I could connect there. I went to McDonald's and was able to get on the Net without using a password. I returned home and tried again to connect, but still was unable to enter my password.
Would it make sense for me to completely disconnect my router from everything, then reconnect and go through that set-up process all over again? I guess I would have to change my User Name & Password, or whatever is required. Also, if I go this route, should I change my security setting from WPA2 to a different option -- WEP, for example? I just don't want to foul things up to the point where my laptop wouldn't work. I doubt that would happen. I recently received the Ice Cream Sandwich upgrade which has been working satisfactorily; however, it does mean that I'm now attempting to start over from scratch with a different operating system.
I've made an observation that the newer routers above my E3000 don't have LED icons to indicate the port is connected/active and also to show Wi-Fi is active? I find this good at a glance without having to go look in the back of the unit to see which ports are open etc.
View 1 Replies View RelatedThe Internet on my Toshiba laptop suddenly has stopped working. If I connect the laptop directly to the router the internet works ok. Othe computers work ok using the same router.
View 1 Replies View Relatedmy system an emachine e350 wouldnt share wireless connection to other computers but can receive perfectly well.when i try to set up an adhoc network,it does not show me turn on internet connection sharing,so when other computers try to connect,it just shows they re connected only on my system but not on the other ones and they cant access the internet also.the network discovery too wont stay on, every time i turn it on and save changes it goes back to off.
View 5 Replies View RelatedI didn't install new program or make a lot of change in my computer lately?Anyway here's the ipconfig/all result of my computer
Windows IP Configuration
Host Name . . . . . . . . . . . . : asus-95bdea2abb
Primary Dns Suffix . . . . . . . :
Node Type . . . . . . . . . . . . : Unknown
IP Routing Enabled. . . . . . . . : No
WINS Proxy Enabled. . . . . . . . : No
[code]...
lost wifi access thru local (home) connection. can connect thru public network. my grandma during last visit accidentally changed the network to her laptop. Have tried to reset netgear wnr2000v1 with pin in back. turned off and waited and turned back on again--no success. have tried to set up new network--see the network listed but no internet access available. have modem/router from comcast. My laptop is Acer Aspire 5733 with Lan Broadcom and wireless lan atheros.
[code]....
I have a local network that I want to connect to a WiFi site. The site is a free service offered to our community by a local ISP. The network uses a wireless router but cable links the two relatively old PCs. They are used for a single inventory-accounting program. One serves as the softwre host. The organization wants episodic Internet access so they can use a software update auto installation service. There are alternative ways to accomplish these updates, but this pathway is the only one acceptable to the organization. Why they reject a simple thumb drive using an out of system download is beyond me, but it seems to be a locked in idea. Oh, the current wireless router cannot accept DD-WRT, but one is available if it can be used if useable.
View 3 Replies View RelatedI have a problem, I have a TV with usb port, TV support only usb flash card. How can I connect it to my wifi file storage? May be somebody knows a device which emulating local flash drive via usb, but in fact mapping network drive via wifi
View 2 Replies View RelatedIs it possible to run both LAN connection and dial-up modem for internet on the same system?
View 11 Replies View Relatedis it to increaze the broadbandwith by using a double usb-modem dial-up ...i know tha we can use double connection, but not in real time...
View 8 Replies View RelatedI have PC System Windows XP home edition Version 2002 SP3 and I lost Internet access in the middle of downloading a new program. I have a Motorola modem and modem is connected to the Netgear router. When I turn my desktop PC on which is connected to the router it shows the local connection is connected, but the Bridge Network cable is unplugged I have no idea what that is and if I need it to be connected to the internet. I called the Comcast service and the lady assistant did not even know what the Bridge cable is and I do not know ether since. I do not know what I should do to get the connection back to the PC; another PC work just fine also is connected to the router.
View 1 Replies View RelatedIs there a software that can be used to disconnect internet connection on selected system on a lan
View 2 Replies View RelatedI want to know how to configure my system to connect to Remote Desktop Connection?
View 1 Replies View Related