Browser (ff / IE / Chrome) And MSN Not Working But BitTorrent And Gameranger Work Fine
Apr 19, 2011
i share internet with my neighbor (we split the bill) and every so often like in the last 2 days, and usually not again for another 3 weeks for 2-3 more more days each time, am not able to browse(ff, chrome, ie) or use windows live messenger, but yet if i turn on bittorrent, the downloads are fine, the trackers don't update, but DHT and peer exchange update fine.And also, i can get on Gameranger (which uses UDP port 16000) and play games, and this happens to all 5 computers on the network, (4 wireless at my house[3 XPs 1 Win7] and one wired at her house[Win 7]), so it's not something on the computer, also, usually when i check my router the subnet is usually 255.255.255.0 but this morning before i came to work i noticed it was 255.0.0.0 , not sure if that matters, this has been happening for months, usually between every 3-4 weeks, we have no browser and msn use for 2-3 days?
I'm on a PC with XP spk3 and my broadband speed is 30+ Mb. In any browser, if I go to Vimeo, Youtube etc and watch higher quality vids I get terrible stuttering of picture and sound, really bad crackling and warbling and drop outs. But, if I download the same vids, they play fine on my computer. I've updated everything I can think of and there is no improvement. My machine is old and slow but this problem started just the other day and it was bad from the start. It didn't gradually creep up.I'm at a loss.
A few days ago my internet suddenly stopped working. I plugged in the ethernet cord and everything worked fine. Checking the properties in the device manager showed the device was working properly, I also tried resetting it to make sure it was enabled but it did not work.
Upon troubleshooting, the "Windows Network Diagnostic" said the problems was that the Wireless adapter was not turned on. Using the switch on the front of the laptop as well as the function keys does nothing. Usually a graphic pops up showing if the WiFi is on or off, changinging transparent to show the WiFi is disabled. Now when I turn the switch on it always appears transparent, effectively going from off to off
So I know the computer reads both the function keys and the switch on the front but both methods never actually turns the adapter on. I just finished a system restore and nothing has changed
I have cisco router 800 series 887 VAW. WiFi is connected to all my devices through this router, i.e., Windows XP, Vista, Wii, Nexus 7 and HTC Desire S. I can access internet from all these devices. The apps which are already downloaded on my Android devices connect to internet, but the bigest problem is here:
1. Google Play does not connect (on both Nexus 7 and Desire S). 2. Chrome does not work on Nexus 7 3. Nexus 7 fails to check for any system update. 4. Fails to sync accounts.
I tried to contact to the company which gave me this router, but they told the problem lies with my tablet. But the tablet works perfectly fine with others networks and Android phone works fine with 3G and other networks.
Email works, pinging www.google.com works, but cannot get anything with browser. I was using Chrome. But having same issues with IE and Mozilla. Second computer on network is not having any issues.
don't know what to do. For a good while now, at my home, the internet has been awful.Web pages barely load if at all, I can't play any online games, but when I start a download, either by torrent or regular, the download speed is perfectly fine, reaching the normal 500 kb/s. My router is TP-Link W9801G. We get TV through the router as well, and there never was any problem with it. It works fine, just like the download speed. The DNS and IP settings are all set to automatic like they should, and of course I've tried unplugging and resetting everything.I know it's not the computer's network adapter, because it's the same thing at my laptop when I connect to it wirelessly. The signal strength is at all 5 bars too
A couple of days ago I bought a new desktop PC (Here is the link if anybody wants info on the PC [URL] but anyway, I'll get to my problem. My wireless router is downstairs in the living room and my desktop PC is upstairs in the bedroom. Theoretically, My PC's wireless card should be able to reach the router perfectly, being as I have several other PC's in the house that I use from my bedroom and the connection is 'Very Good' to 'Excellent'. Although with this new computer the connection's strength is very weak and it's so slow using the internet or trying to download things. It's internet is almost unusable. I've tried swapping the wireless card, but to avail. The connection is still awful.
Or of a way to boost the signal of my wireless card?
Here at home I have great WIFI connectivity but on my main PC that is hard wired into the modem I have no Internet access. My service seems fine as my cable/VOIP telephone/wifi work great. I'm not sure how to detect my ISP settings. In 'device manager' it shows that the teredo tunneling adapter will not start. I don't know what that is or if its important here.
We have a brand new Dell Insprion Q15R laptop which works fine apart from the fact that certain websites hang when we try to log on at home using our edimax router and we cant get into them. Other websites work fine. Also we have an old IBM laptop where all websites work fine. Its just the Dell that is playing up on certain sites. However if we go to somebody else's house and log on using their internet connection and router the websites in question work fine on the Dell.
Examples of the websites that we cant access at home and just hang are : argos, easyjet, national rail, expedia
I have changed the channels, changed the firmware, changed the position of the wireless router, reinserted my wireless card on my rig, changed the security, turned everything setting on or off.
I work in a small office/production building and lately we have been having problems with an unstable connection. We are using a Meraki MR24 access point in our warehouse, the connection always starts out strong but sooner or later everyone will briefly lose connection and the AP goes away, then comes back and we're reconnected at excellent connection again.
I've got a 3560-X that passes POST according to console, but there are issues nonetheless...USB console doesn't work. RJ45 works just fine. No status lights turn on at any point (e.g. syst, xps...). 10g network module is installed with a 10g LRM SFP. All lights on the module are amber. However, it passes according to POST. Switch passes traffic, obeys config, etc. Link lights on RJ45 ports work fine. This was brand new out of the box. Thinking about trying IOS reload..
certain javascript actions are not working on any browser (firefox 15.0.1 IE9, latest Chrome). [URL] and [URL]are two sites which do not work properly for me.
- Both sites worked in the recent past. One stopped working, then some days after, the other did too. Now both sites (eventually) load as simple hmtl but do not function.
- On screen notification from fantasy.premierleague.com asks me to 'enable javascript to continue using site'
- Javascript is ticked as 'Enabled' on all browsers.
- This problem only present on my Windows 7 laptop and not on either of the other 2 machines which share my home modem
- the problem is present on any internet connection my machine uses (i.e. work wifi, local cafe's wifi)
- the problem persists with antivirus turned off (AVG)
- I've performed a full Firefox reset as per mozilla instructions
- The problem persists when I disable Firefox add-ons (the only add-on I have is ad-blocker) - but again, the problem persists across all browsers
- I'm not using any internet funny business (such as IP blockers or proxy servers)
I've been trying to port forward my WRT54G2 router.I've tried to update the Firmware, use another computer or another browser.But it still doesn't work!
Had a look inside my HP Pavilion p6685l recently and found there wasn't any wifi card which was odd because it's been working fine for months.Device Manager says theres a 802.11n Wireless Lan Card in there but I traced the wires from the ariel to a chip on the board (MSI 2A9C according to Belarc ). Property sheet says it's a Ralink Card and so does the vendor id ( 1814 ) but the device id (3092) belongs to an Intel I20 1.5 Raid Controller which is where I got lost. I didn't know Raid Controllers did wifi.
I'll be downloading off of newsgroups and be pulling 3-4 MB/sec, no problems. My downloads are charted so I can see my speed never drops at all.but my web browsing will just STOP, for ~30 seconds. I'll have multiple tabs just STOP and crap out, while my downloads run fine. This also happens when I'm not downloading, so I know it's not a bandwidth issue,i assumed it was a router issue until I replaced my router and am getting the same issue.
Ethernet stop working, but the wireless is fine, check in the device manger for any conflics none. open the network sharing centre and ran the truoble shooting utiiity and message came up with ethernet cable not plug in or brocken, which i have change it for a new one so its not the cable and its not the routor because B.T just gave me the new B.T Hub3, this network adaptor is on board and i have a wireless card in the PCI slot and the is a new main board which i built, everything was fine afew months ago til this started to acur
My daughters laptop is having tones of trouble connecting to the net. All browsers are giving me same "Can't connect" messages but automatic updates and stuff seem to be ok.
Tech Support Guy System Info Utility version 1.0.0.1 OS Version: Microsoft� Windows Vista� Home Basic , Service Pack 1, 32 bit Processor: AMD Athlon(tm) Processor 2650e, x64 Family 15 Model 127 Stepping 2
My hp/g62 is fine conecting to the wifi, but browser (chrome or Explorer - the same story) is only sometimes richable. It is alike I can see one website every 60 min. browser says: the website is unavaiable, connect later, and down on it: dns is not responding. Other time: connect error: time out etc?
Nothing seems to be able to connect to my wireless network. It seems to have occurred after I installed a new copy of windows 7 onto my sister's desktop. A message appeared saying we have the same ip address. I've tried renewing our ip address on both desktop but it won't give us new ip address for some reason.
We have FIOS at our home. All the wall connections for ethernet are wired to the control panel in our house which are then connected to a wired router. We have another wireless router in the upstairs which gets internet through the wall port and it works fine.We had another downstairs wireless router in the living room that was working fine as well, but I reset it for certain reasons and it no longer works properly. All the proper lights light up: internet, port, power but the computer can only connect to the network and not the internet for some reason.
Out of the blue my wireless connection stopped working, my browser cannot connect, I don't know what to do. I have a Samsung laptop that's running on Windows 7. I thought it was the browser so I installed the Internet Explorer 9 and while doing so it was able to download the updates but when I open up the browser it still doesn't work.
I'm thinking that it might be a network problem but I've ran out of ideas. I have a netgear router that's connecting a desktop computer, two VOIP devices, my sisters Mac works but we have two laptop that aren't working. I've also tried connecting it directly to an ethernet cable from the router but it's still not able to open the browser.
Have a v2 E1200. Connect with PPPoE to ISP. IPv4 works fine. With firmware included on router, 2.0.01, it would receive a /64 of IPv6 from the ISP. This /64 would show up under 'status' / 'local network'. Although it did not seem to advertise this space to PC's on my network so I was unable to use it. I updated firmware to 2.0.04. Now it does not even pick up the IPv6 /64 at all.
Anyone have PPPoE and IPv6 working? Anywhere I can download 2.0.01 to try it again?
Is there a model of router that actually works with IPv6?
Region : Italy Model : TD-W8968 Hardware Version : V1 Firmware Version : 0.6.0 1.1 v0005.0 Build 120926 Rel.27100n ISP : Alice (Telecom Italia)
I have just bought this new device, installed, DSL is working fine but not the USB printer sharing. Allways tells me: "This system was not supported yet." Here is the message box: usb_printer_error.JPG.I have a HP DeskJet 1050 and a Canon Pixma MP150 machine. I know, the HP is not in the supported printer list, indeed Canon is.
suddenly all of my browsers stoped working,with mozzila it happens nothing at all,even don't show this page cannot be displayed thing,google chrome show that kind of message,while internet explorer suggest testing conectivity and shows message that problem is winsock provider catalog.
Daughter is at college with brand new Vostro 3450. Was working on school network during summer but drops the connection multiple times during the day. She runs the Troubleshooting which then allows her to connect and 30 minutes later the connection is dropped again. The laptop works fine when connected to the internet via the ethernet cable. Here is what has been done by the IT support at the school.
1 - Deleted the Intel wireless utility as they thought it was "fighting" with the Windows software for control over the wireless.
2 - Increased the power for the wireless card to "high performance".
3 - Reinstalled Windows 7 to eliminate that there is a software issue.
4 - Replaced the Intel Wireless Card with new part sent by Dell.
Now the IT supports recommendation is to "get a new system" and that perhaps the Vostro's wireless card is "not compatible with their network". For Dell computers they sell the Latitude to the students.
My daugther likes the Vostro. She doesn't want to give it up. Wants the system to work. She had the laptop during the summer session and had problems with connection. The Windows software was reinstalled thinking there was a virus (although no evidence of one) and then she had no connection problems for the whole summer. She came home for 2 weeks and returned back to school and then the system would not work again.
I don't know what to do. Can I buy a USB wireless adapter for her to temporarily use until I can figure out how to fix this problem. Personally, I think there is a design flaw with the vostro.
We have a pair of CSS 11503 installed in our DC. Stickiness is configured for one of the application since long back and was working pretty fine till last couple of months. Since last two months, we observed that CSS is not distributing sessions the way it suppose to be. Mostly, it forwards the session to same server even though request is coming from different sources. Once we refresh the sessions manually, it starts working fine. We have to do this exercise manually every alternate day.
My 3rd day with my newly bought All-In-One 2320 i7, 2TB, 8MB...This is the seond issue I found on this machine:Browse iplayer page, choose a video to watch, but...when viewing video from iplayer in IE, browser stop working. The whole page freeze.Same thing happened on youtube.
Things I have tried:
- Test it in Firefox. Same result. So bad.
- Update my flash player, java,..etc.
What else can I do? So dissapointed. I have promissed my son to show him the cbb animation cartoon on my new computer (big screen)..
My brother keeps downloading torrents and I don't want him to so I was wondering if there was a way to keep torrents from going from my router to his computer but still give him access to the internet. I have a Linksys WRT160N V3 router.
