Netgear Router Setup To Expand Wireless Coverage?
Aug 17, 2012My brother has a router for his house which lives right next door. I am getting wireless through a adapter right now but not good throughout my house.
View 1 Replies
ADVERTISEMENT
Linksys Wireless Router :: Wrt600n Expand Wifi Coverage
Aug 16, 2011My DSL Modem connected right now to Linksys Model: WRT600N (Dual Band Wireless-N Gigabit Router) to give a wireless internet access in my house. I have TWO spare Linksys Wireless Router (WRT350N-Wireless-N Gigabit Router) and (WRT54G2-Wireless-G Broadband Router) that I need to use to expand my wireless network at home.
How can i connect the two routers to became an access point or range expander to existing router. It is possible the two spare routers became an access pt or expander? How can i configure that? Cable configuration?
Linksys Access Point :: WAG320N / Expand LAN With Another Port And Wireless Coverage
Feb 26, 2012I'm using a router WAG320N in my home but now i need to expand my lan with another ports and wireless coverage.In a wired point (connect directly to the router) i need 3 ehternet ports and a repetear of a wireless signal.The optimal solution woulb be a switch gigabit with an integrated acces point, but I understand that there is no such thing...So going to buyng the switch SE2500 and the AP WAP610N... but then I realized the existence of the bridge WES610N!But the information on the linksys italian site is not enough and the relative page does not works... i need to now if this object can take a wired lan replicate it in 3 ports and expand the wireless network of my router.
View 5 Replies View RelatedExpand WiFi Coverage - Over Large Area Like 4 Or 5 Access Points
Oct 22, 2011expanding my WiFi coverage over a pretty large ares like 4 or 5 access points.
Connecting Netgear To Linksys Router To Expand Network?
Jul 6, 2011I have a netgear CVG834G main router, were my desktop is plugged on to.I pulled a new cable trough the house and garage to have internet access on the other side (cable length is about 80 meters).After the 80meters of cable I placed a Linksys WRT54GS v5.1 router. The problem is that I can connect to the Linksys, but the Linksys can�t connect to the netgear. On the Linksys the internet LED is blinking very slowly (what does this mean?). So first I thought that the cable was broken or too long. I tested the cable => not broken. I connected the Linksys with the netgear trough a shorter cable and then connected my laptop via the long cable (80meter) and this works perfectly.Is the maximum distends a netgear can take less than 80 meters? (thought is was 100meter ).
View 3 Replies View RelatedLinksys Wireless Router :: WRT120N Setup - Boosting Range To Get Good Coverage?
Apr 5, 2010I setup a WRT120N router in my home. I am having a issue getting good coverage over my single floor ranch style home. Would changing the Standard Channel (currently set 6) make a difference?
View 9 Replies View RelatedNetgear WRN2000 Giving Not Enough Coverage
Apr 26, 2012I have a Linksys WRT160N connected and it is working fine. My problem is the coverage is not enough. I have a Netgear WRN2000 and I want to hardwire it to my linksys so it can be used as a repeater but I can't get it to work properly.
View 13 Replies View RelatedSetup A Password For A Netgear Wireless Router?
Jan 25, 2011how do i setup a password for a netgear wireless router?
View 2 Replies View RelatedSetup A Netgear WGR614v9 Wireless Router?
Dec 30, 2012do i need to go to my control panal to connet to use it wireless
View 2 Replies View RelatedNetgear Router - Setup Wireless For Kindle Fire Pad?
Dec 29, 2012What in needed to setup wireless for an kindle fire pad? I have a netgear router
View 3 Replies View RelatedSetup A Netgear Wireless Router On A Company Network?
Dec 4, 2012i wanted to know if i could setup a netgear wireless router to my ethernet cable that is coming out of the wall. is it as easy as plugging the cable coming out of the wall into the internet port on the router?
View 5 Replies View RelatedNetgear WNR3500 - How To Setup Second Wireless Router Off Main One
Jul 7, 2012I have a wireless audio system using several Apple Airport Express boxes currently communicating using 802.11g through my Verizon FiOS MI424WR (Actiontec) router. I also have wireless security cameras and several laptops on the same connection. I occasionally have audio dropouts I suspect due to wireless bandwidth limitations. I have a Netgear WNR3500 Wireless-N Gigabit router that I would like to hang off of the Verizon router and move the Airport Expresses, which are 802.11N capable, to its Wi-fi connection. This would keep my audio streams separate from the video and other wireless traffic and take advantage of the 802.11N.I in configuring the router/s to facilitate this arrangement. I have numerous Windows machines (XP and Windows 7), mostly hardwired, on my main network along with a NAS containing my audio library. So all devices need to be able to see all other devices.
View 3 Replies View RelatedHome Network Setup Using Netgear Wireless Modem / Router?
Feb 2, 2013I have two netgear wireless modem / router. I want to connect my internet, NAS and Media player on one device (netgear modem/router) and want to link the other netgear in my bedroom and connect another media player and also use the internet via primary netgear modem/router wireless connectivity.
View 1 Replies View RelatedSetup Netgear WNR2000v2 Router As Wireless Access Point?
Jan 6, 2012How do I setup Netgear WNR2000v2 wireless router as a wireless access point? I just upgraded to a Netgear WNDR3700 wireless router and I don't wanted the wnr2000 to go waste. So basically as the followings:
Internet(modem)---Ethernet cable--->3700---wireless-->2000---Ethernet cable-->Xbox360/PS3.
Can't Setup Netgear N600 Wireless Dual Band Gigabit Router
Dec 1, 2012I confused ,with which modem to purchase to set up my n600 wireless dual band gigabit router wndr3700, i'm on boardband with no modem
View 1 Replies View RelatedWireless N Extreme DIR-655 Connecting Switch To Router To Expand Ports
May 18, 2011I have a Dlink Wireless N Xtreme DIR-655 I have run out of port 4 on it to a switch with a cat 5 patch cable that is 25 ft long It is connected to the Internet port on a Dlink 4 port switch. When i run from that on any of the 4 ports back to my computer ( Win7). I get no internet access but if i connect the cable straight from the router there is no problem. I even attempted to use a older dlink router for the switches and no luck there at all. Any reason the internet would not be broadcasting through the switch.
View 3 Replies View RelatedLinksys Wireless Router :: How To Expand E4200v2 Wifi Range
Jul 5, 2012I cant find any wds setting in the UI.I want to bridge my old route for wifi expanding
View 3 Replies View RelatedLinksys Wireless Router :: WRT160N Bridge To Expand Signals
Sep 29, 2009I just installed a Linksys WRT160N router. The signal started of good about 50 to 70 feet from the routers location. Now the signal is registering as low to good, about 54Mbps. I was wondering what options I might have to install a wireless bridge for expansion of the signal. I have configured an encrypted network using WPA2. I am wondering what the technical difficulty would be to install and configure it. I setup the WRT160N myself if that means anything.
View 4 Replies View RelatedLinksys Wireless Router :: Wrt160n - Expand Network Range In House?
Sep 27, 2011I have a wrt160n that I would like to use to expand the range of my wireless network. I have tried a few solutions, but to no avail. I am thinking I have just not found the proper steps.I am behind a dsl wireless router that Telus has provided me. The values of that router setup are as follows:SSID: TELUS4108WPA/WPA2-AESDefault gateway: 75.156.190.1DNS address: 199.185.220.254Subnet mask: 255.255.255.0
View 9 Replies View RelatedLinksys Wireless Router :: Connecting A WET610N To WRT54GS To Expand Range
Aug 4, 2011I have a wireless network in a 2 storey house. The internet access and 1 WRT54GS router is on the 1st floor (using frequency channel 11). The wireless single doesn't do very well on the second floor unless there is a device with a strong antenna. I recently purchased a WET610N Bridge and I have an extra WRT54GS (using frequency channel 1).
I would like to be able to add wireless to the 2nd floor by attaching the extra router to the bridge which would wirelessly connect to the router with the internet.
Linksys Wireless Router :: E4200 - Any Tweaks To Expand Signal Strength?
Aug 20, 2011I went out and bought a e4200 today and the signal strength is worse than my WGT300n, is there any tweaks I can do to expand my signal strength?
View 3 Replies View RelatedWireless :: Set Router's Coverage To Minimum?
Jun 10, 2011belkin n wireless router minimum coverage ?
View 1 Replies View RelatedSetup Software For Netgear Router Wpn824 V2?
Aug 19, 2011unable to find download for netgear wpn824 v2 router
View 1 Replies View RelatedLinksys Wireless Router :: Way To Get Maximum Performance And Coverage
Jun 30, 2011Is this the best way to get maximum performance and coverage? I have a DIR-655 bridged to supply B/G on channel 11.I Gave Up On Linksys Firmware And Installed DD-WRT.
View 4 Replies View RelatedLinksys Wireless Router :: E3200 - How To Optimize Coverage
Mar 29, 2012I had an old LINKSYS WRT54GS whihc had a poor coverage of my whole home.I just bought a new E-3200 which is supposed to have a real higher coverage but seems not.When I am in a room at 15m from the routeur, no coverage !How can we optimize the coverage of the routeur ?
View 5 Replies View RelatedNetgear Router Setup - Access Point / Switch?
Dec 9, 2011I need to setup my Netgear as a switch/access point. I need the following set-up. My ipconfig /all reports:
View 27 Replies View RelatedCablenet / Netgear Jnr1010 Wifi Router Setup Without Modem?
Feb 16, 2013I am having netgear JNR 1010 wifi router and I use Cablenet. the wire which carries internet is directly connected to my Desktop pc's LAN port without modem.Is there any way to install this router without conecting to modem?
View 3 Replies View RelatedNetgear Router / Setup An Internal Network In One Room Of A Building?
May 1, 2012internet provided to whole building with connections in every room -> personal router in my room -> my PCs, Macs & printer, how to set up my computers so that they can share files with each other and print to my network printer, but without being susceptible to being accessed from other computers in the building? I have my own netgear router. But at the moment, my shared folders are accessible by everyone in the building, so is my printer If I set all the computers to automatically set ip by DHCP, they can access the net, but everyone in the building can access them (and my printer which requires a manual ip doesnt work). If I set all the computers to manual addresses (e.g. 192.168.1.14 ... 192.168.1.15 ... 192.168.1.16 etc.) they work with each other, the printer works, its secure, but I can't access the internet!Is there a way to for example have my own internal network with manual ip addresses, while also being able to connect to the net?
View 1 Replies View RelatedLinksys Wireless Router :: EA6300 With Less Coverage - Increasing Output Strength?
May 12, 2013I just upgraded my router from the WRT54GL to the EA6300, and it appears there is less coverage with the new unit. Previously, my neighbor could share my router and now with the EA6300 my phone switches to 4G at the end of the driveway. Has anyone seen any specs which publish to output of the ea6300?
View 3 Replies View RelatedLinksys Wireless Router :: E4200 2.4GHz Has Lesser Coverage Than WRT54G V2.2?
Jul 11, 2011Both use the same encryption (WPA2-Personal), same channel and they are tested in the same location with g-only mode. Only one router is switched on at any one time during the test. When 3 g-client notebooks (of various brands) are associated with the E4200, the signal indicator is a single bar, wherelse they can get 3 bars with the WRT54G (in the same location). For Internet speed test on a 20Mbps link, WRT54G is able to substain about 10Mbps, but only 1-2Mbps with the E4200.
Is such difference in performance between the two router models normal? Is there any configuration required to tweak the E4200? Or is it a hardware related issue with E4200?
The E4200 has been updated with the latest available firmware as of yesterday.
Linksys Wireless Router :: WAG120N - Handle 20 Connections With Large Coverage
Nov 20, 2012we are currently using a modem router LINKSYS WAG120N Wireless-N ADSL Router but are not satisfied. lots of dead zones and I think that there are too many users for this AP. last count gave around 20 users. so I'm looking for a solution to be able to handle 20+ concurrent connections and with large coverage - 600 m² .
View 7 Replies View RelatedLinksys Wireless Router :: 2 Story House To Extend Coverage EA-4500
Nov 18, 2012I have 2 story house and trying t extend wireless coverage in the house. I have have 2 routers. One is just wrt54g while the second dual mode EA-4500. Cable modem is located in the basement so i would like to have one of the routers connected to it and use another router as bridge. So which router would be best to use a bridge. If i use ea4500 as a bridge then i would lose dual band features of it.
View 9 Replies View RelatedLinksys Wireless Router :: Recently Bought E4200v2 Very Poor Coverage
Apr 13, 2012I recently bought a e4200v2 router and installed it by connecting it with my old modem d-link 2730u.I was disappointing to see that the new router i.e e4200v2 has the exact same coverage as my old router which is costing about 35 usd and linksys cost about 200 usd.. this is a terrible waste of money!!
View 1 Replies View Related