I have already successfully upgraded the firmware to DD-WRT with no problems.What I want to do is have the D-Link DIR-601 Router set as a Repeater Bridge because I am trying to expand my wireless signal to dead spots in the house.I have NO SECURITY enabled on my NetGear Router and I am still unable to successully setup the D-link DIR-601 Router as a Repeater Bridge.
View 2 Replies
I recently bought a new D-Link DIR 615 but I dont get adequate range in the rooms farthest away from the router. I have an old D-Link DIR 634M router which I'm told can be used as a wireless repeater. I went through several articles that describe connecting the two routers through a LAN cable. However is there a way to do the same without using a cable of any sorts?
View 1 Replies View RelatedI have Dlink N300 router and also WRT54G2 router now with DD-WRT firmware, configured as a repeater.I have a PPPoE connection through Dlink router and want to extend signals farther, hence want to use Linksys (WRT54g2) as a repeater.I have set up the linksys as repeater but dont know how to check if its communicating with my Dlink and also I not able to get internet connection from the repeater.
View 5 Replies View Relatedmake dlink dsl router 2640T to be working as repeater which will be able to receive wifi signals. I've seen one guy using the same dlink dsl-2640T as wifi signal repeater where he was successfully able to receive wifi signals[CODE]
View 5 Replies View RelatedI have a new internet router linksys EA2700 Firmware Version: 1.0.14, the wireless signal doesn't cover the whole house so I like to extend the wireless signal using my old router Dlink DSL-2750U as Access point, I configured the two router as following but yet didn't work.
Linksys
DHCP: enabled,
IP lease range 192.168.1.100 to 150
Wireless SSID, Security Mode, Passphrase, Channel Width and Channel number same as Dlink
Dlink:
DHCP: disabled
AP Mode: Access point
Bridge Restrict:Enabled
Remote Bridges MAC Address: is the linksys MAC.
And I removed the Layer2Interface and WAN old configuration.
I have been putting up with rubbish wireless signal down one end of my house now for quite some time. So I thought I have a spare wireless router and I could put it down there but I am sure ts not as easy as just plugging it and away you go.
Network Setup
Router 1 is a D-Link DIR-655
Router 2 is a D-Link DI-524
I need to know how to setup Router 2 so it basically become just a wireless access point
I've bought a new note book and i can't connect to my Dlink router, it won't accept my security key
View 3 Replies View RelatedFor reasons that are slowly pushing me over the edge of insanity, I have to reset this dumb router!!
I press the stupid little button on the back of it, the lights go out, one amber one comes on etc. etc. but when I go to 192.168.0.1, everything is still the same!!
Like the passwords are still there and nothing has changed! I thought resetting it was supposed to wipe all that stuff out so you could start from scratch? Also pulled the power cord in and out a zillion times but no way it will reset!
As an aside, I am having no end of problems getting my iPads (2) and iPhones (2) to connect to the wireless network! The "Network Discovery" button will not stay checked and though I have done all the Googling and been into Services to start things running, no way it is going to work!
But I digress, how do I get this fool of a router to reset properly?
I have a dlink router. Dir615 I believe. After installing hotspot Shield on my desktop, I can no longer connect to my router from my laptop, which I did not even install Hotspot shield in. when trying to connect, nothing happens. the wireless icon on the taskbar does not show that its trying to connect.
View 2 Replies View Relatedcan i use dlink switch as a router to set up LAN
View 1 Replies View RelatedI reset the router and now it doesn't have a default gateway address. It stops on the check for network status when trying the install wizard and says it can't install it.
View 2 Replies View Relatedhow to put a timer on dlink n150 router for protection on unwanted visitors or how to change password often for my internet cafe.
View 2 Replies View RelatedI have a very large house with many people using wireless laptops. i used to have verizon internet and I purchased a wlan 11g mini router from radio lads. After it was set up it worked great. I have just switched to comcast internet (my first mistake) and I can't get the mini router to work.
View 1 Replies View Related[URL] It works wirelessly, but I'm trying to get it to work physically. The end goal is to have my old PC as a server on the other side of the house, connected to nothing but the second router and a power cord. I know I could do this easily just by running an Ethernet cord across the house and skip using the second router altogether, but I'd really rather not.
View 2 Replies View RelatedHow to connect repeator to router
View 1 Replies View RelatedI'm using a new Buffalo router and wanting to use my old Buffalo router as repeater to extend the WiFi coverage at home.
View 1 Replies View RelatedIs it possible to configure a E2500 as router and WAP54G as a repeater? I used to have a WRT54GS as router but it has broken and now I bought a E2500 to replace it.
View 2 Replies View RelatedI have purchased a Dlink DWR 131 today. I did configure it as per the instructions. Initially my iPhone was able to detect the wireless network. Then I switched off the device and turned it on later and it stopped working. It is not damaged for sure, since http://192.168.0.1/ is still accessible from my laptop and I am able to connect to internet through LAN cable. But the wireless network is not working. Even my laptop doesn't detect the network neither does my iPhone. I suspect this to be some configuration issue. I have tried using different SSIDs. Also, MAC filter is disabled. I also tried using different wireless channels. I even did reset the router but no luck.
View 2 Replies View RelatedOur router is a Dlink DGL-4500. Over the last 15 minutes I've been disconnected and reconnected about 5 or 6 times. This happens every so often. But even without it I get disconnected several times per day.I need to be able to stay online and for some certain programs to run, if they get disconnected I will have to reconnect manually and I can't do this if I am not near my computer.I think the problem is specific to my laptop. Most of the time I stay online ok, except for the lapses I've mentioned. I asked someone else in our house if they have been getting disconnected and they say they haven't. Here's an IPconfig and in the next quote box, I did an IPconfig/all>C:esults.txt, which I've posted the content of[CODE]
View 14 Replies View Relatedi have a dlink dir-628 and it not working problem. the power light, local network led and even the dlink logo is blinking. it was working fine yesterday but it just stopped working randomly, i tried to reset but that doesnt even work,
View 6 Replies View Relatedi want to set up my wireless router it is currently set on a static ip but i want to set up in pppoe(username/password) mode i set up once in pppoe but internet is not working?
View 7 Replies View RelatedI have a PC connected to the internet via a d-link 615 router and a cable modem.The PC is hardwired to the modem and the laptop can connect wirelessly via the router.I own a HP 6280 Network MFD and would like to locate this in a separate room to the PC.I own a Linksys WAG54GS mobem router from my last ADSL connection.Can I site the wireless router with the MFD and use it as a wireless hub?
View 4 Replies View RelatedNeed installing dlink router dir-615 version b2. I tried installing it but when i try to use my browsers, i'm redirected to my isp's web page, and i can not connect with skype.
View 1 Replies View RelatedI have a new Dlink wireless router. Previously I had a Belkin router. The new one was said to have stronger signal. I am not able to connect via wireless to the router from a PC with Windows Vista. It works fine when I use a cable. Then I am able to connect to Internet via the router. Also, I am able to print on a wireless printer. It is also possible to use Internet from an Ipad with wifi.
The Belkin router had a different network, 192.168.2....When the cable is connected I can ping 192.168.0.1 but not when I remove the cable. In Windows Vista the connection has status "connected". When the cable is connected, the ipconfig /all is printed as below. It is a Swedish version. Some translated words:
Tr�dl�s = Wireless
Ja = Yes
Nej = No
Fr�nkopplad = Disconnected
[code]...
This is an ongoing problem and I am wondering if a firmware update is called for. We have had the router for some time and to the best of my knowledge nothing has been done to fix the problem except the old "unplug for 10 seconds" routine.There are now four users on the home network with multiple devices.
View 1 Replies View Relatedi ahve a dlink dir 615 B2 router and it wont connect to the internet. on day it was fine and working, the next day the internet led wouldn't change from the red light to the green light.i have tried resetting it about 60 times, while the laptop was on/off, while it was plugged it, while it was without power, while the internet cable was in, while it wasn't, while it was shut down and i reset it and the i pluged it in while resetting it...i dont know what else to do!! short of smashing the bejesus out of it. The internet works fine when i connect the cable directly to the laptop, I don;t have a cable modem or anything, just a plain old cable from the street to my house.
View 3 Replies View RelatedI have Comcast internet and a DLink DIR-655 router. I have a laptop, Playstation 3 and 2 Blackberrys hooked up on my wifi. I also think my neighbor is using or trying ot use my wifi.I need a software program or piece of hardware that will allow logging of the URL's that are requested through my router.I currently use OpenDNS, and the service itself is pretty good. However, it doesn't tell which user is requesting which URL, and if a website is visited with 10 ads on it, it also shows the URL's for the ad hosting company, even though they didn't actually type that URL in.
View 5 Replies View RelatedTrying to set up a minecraft server, I have a dlink DIR-601 router.I followed instructions on the portforward site, and use a portchecker and my ports are correct in practice, but they wont ever show as open.Below is what I have done, virtual server is empty and nothing checked. The ip in the picture is my static IP.
View 8 Replies View RelatedI have a Dlink DIR-615 wireless router. Without re-setting or changing the password I want to block my neighbour from using it as he knows my password
View 19 Replies View RelatedI'm on a Virgin media 50 Meg connection currently connected via cable using the modem provided.I'm hoping to connect my PS3 to the internet using the router provided (dlink DIR-615) and I'm wondering if I'll still get the same speeds if I connect the cable through the router. I hear that the wireless data transfer won't be able to handle 50 Meg but if I attach a cable from the router to my PC will I still get the full 50?
View 1 Replies View RelatedMy wireless devices are having a hard time connecting though my router. They see the router and can connect to it but cannot get on the internet. When I go into my router and check Wireless Status to see connected devices the window is empty. Usually if I reboot my router some of my devices will connect but if I leave them idle for any amount of time the connection is dropped. Suggestions. I have Dell 530 desktop running Vist Home Premium and the router is Dlink Dir 615. The desktop has no issues connecting to the internet as it is connected through LAN port
View 2 Replies View RelatedI have a D-Link Router and I need to find the WEP number. How do I find it on my Router?
View 1 Replies View RelatedI am trying to get my wife's mac book to print wireless to my hp desk jet 3050a 611g printer. The print report advises that the Mac hardware address of the printer must be added to the list of permitted devices for my wireless routed.
View 1 Replies View Related
