i acces internet on my pc using tata photon+ mobile broadband service,my problem is that i bought a ps3 and want to share internet connection with pc using ethernet cable via lan modem, for this i connected ps3 and pc using ethernet cable,i go to custom and wired setting of ps3 but my ps3 keep saying 'connect ethernet cable'.
View 7 RepliesI am having a problem with my Realtek RTL8168D/8111D PCI-E Gigabit Ethernet NIC. It is not detecting my ethernet cable, and thus leaving me without internet on my desktop, after i updated its driver. The cable is not the problem as I have tested the cable with my laptop. I tried rolling back drivers, doing system restore and removing drivers with driversweeper and letting windows install the drivers again. However, none of these worked for me. I doubt the NIC is faulty as it was working before i updated the drivers. I am using windows 7 home premium 64-bit.
View 9 Replies View RelatedI recently moved into the dorms of my college and tried connecting my laptop to the internet using an ethernet cable. It worked, so I decided to try and play Xbox Live through the use of the ethernet cable and it did not work. After messing around with it and failing to get it to work for my Xbox 360, the ethernet decided to quit working for my computer as well. (To try and get my Xbox to connect to the internet with the ethernet cord, I tried network bridging by bridging the ethernet connection with the wireless connection, then unplugging the ethernet cable from the wall so as to connect it from my laptop to Xbox 360. This didn't work so I just deleted the bridge. This is when the problem started happening as the local connection stopped appearing.) I am able to plug it in and see that in the Network and Sharing Center, however, it shows up as being unplugged. After a couple seconds though, it disappears. If I click on it fast enough, it shows up with an Error Code 45 after looking at the properties. I have tried typing in ipconnfig /all and the ethernet connection doesn't show up there either.
View 16 Replies View RelatedI'm having an issue with my network adapter. It's not detecting the Ethernet cable, thus not able to connect to my home network. The trouble shooter (Windows 7 home 64) says it canning detect the cord. But the cable works fine on my other computer. The network adapter is a Nvdia nforce networking controller. All the drivers are up to date. The computer was completely formatted so it's a blank slate
View 8 Replies View RelatedToday when I came home from school, I opened my computer like everyday. Suddenly I noticed that my Internet isn't working. It said I need to connect the Ethernet Cable. Well, my cable sometimes gets loose, so I tried to tighten it up a bit but that didn't work. I tried the cable with another computer and it works fine. I checked device manager and everything should be fine there.computer is running Windows 7 Professional.Drivers are up to date, and nothing changed in the computer since yesterday when it was still working. Could it be just that the Ethernet cable port suddenly broke down? I also tried another cable, and that didn't work either. I restored the system to previous saved point.
View 4 Replies View Relatedi have a DSL connection which is established using a dial-up (PPPoE) modem. I recently bought a wifi router, and I found that when I plug the cable to one of the LAN ports and the laptop, it seems as if it wasn't connected at all (not detected on either side).I tried to format the system running on XP and I installed windows 7 but the problem persists.The only thing I can think of right now is using a crossover cable, but I somehow doubt that it should work since I tried plugging the router to my netbook (using a normal cable) and it worked like a charm. But maybe the fact that it's a quite old laptop (PB MV51-101) has something to do?
View 8 Replies View RelatedI tried 3 cables, and even one of them was new. So im sure the problem isn't the cables. For some reason, whenever I connect a ehternet cable to my computer, I cannot seem to get internet connection through it. Some days ago I installed this Wireless Lan device from a CD, that came with a sort of antenne I had to put on my computer. It works great, BUT its slow. Thats why i would like to go on internet with cable again. I remember one day to another that my computer didn't detect the cables anymore, what could be the problem?
View 7 Replies View RelatedSince changing battery my Dell C521 won't connect to internet. When I run set up CD it says it can't detect ethernet connection even though cable is connected.
View 1 Replies View RelatedComputer keeps saying that the I need to plug in a ethernet cable but I already did. This is happening on my Windows 7 Ultimate partition. I also have have a Mac OSX partition and the internet is working fine on that partition.Here is what I get for ipconfig/all command:[CODE]
View 18 Replies View RelatedMy roommate and I are trying to set up the internet, but my computer won't detect the Ethernet Cable. Whenever I go to Network and Sharing Center and try connecting to the internet, the computer simply says "Windows did not detect any networking hardware", even though the light is clearly on and should be working. The cable is also new so it should be fine. I've also been looking around on the internet a bit, and in trying to fix the problem it looks like some of my Services are turned off, which seems to be causing the problem. However, whenever I try and turn them on, I get an error message saying "The dependency service or group failed to start".
View 5 Replies View RelatedI have tried 3 cables and all three are not recognized even though they are plugged in. I have uninstalled network adapter and re installed it and i have updated the driver still nothing so i don't know what to do next.my laptop is a hp pavilion g6 series
View 10 Replies View Relatedmy ps3 keeps saying ethernet cable not detected but it is connected.
View 1 Replies View RelatedA friend recently re-installed windows XP on their HP Laptop. They were connected wirelessly with a Linsys router (model wrt54g.1) and an RCA Cable Modem. The Cable ISP can ping the modem and gave me the IP address over the phone. I cannot ping the modem even when I take the router out of the loop. The network card (i1394) in the Laptop is functioning normally and I can see traffic on the modem (both the Cable Internet light and the PC activity light are flashing green) the ethernet port on the laptop is also flashing (amber). However I cannot reach the internet and cannot even ping the modem. The modem is brand new..
View 2 Replies View RelatedI have a desktop running windows XP Professional x32 SP3 and my network adapter is a Realtek PCIe GBE Family Controller. The desktop is connected to the network with an ethernet cable.Up until yesterday the internet connectivity just stopped working. I am seeing a very low number of received packets as opposed to the high number when it was working. It is showing that it is connected to the network but I still can't access the internet. Also I should mention that the desktop is at work and it is connected to a DHCP server that assigns IP addresses. I have updated all the drivers and I have used Winsock Fix and Netsh but it still isn't working. However the weird thing is that if assign a static IP address to it...it works. But I can't do this because I am not suppose to hook it up to the ports assigned to the switch for static IP's. It has to be connected to the DHCP switch. Why does it work when assigned a static but not if it gets an IP assigned by the DHCP server or switch. Also even if I try to reset, renew or release the IP...when I connect again it still gives me the same IP. It wont change.
View 1 Replies View RelatedSo, for some reason my internet connection started disconnecting about every 1-5 minutes. It worked fine this morning, however, when I turned my PC on a few hours ago it became very unstable. After it happens I have to reconnect to internet (it doesn't work all the time, I usually have to do it two times for it to work), and then again after a few minutes the connection dies. Tried restarting my computer, tried restarting the modem, tried the troubleshooting network thing (it keeps saying "Local Area Connection doesn't have a valid IP configuration", but gives no solution). Also, I tried connecting on my cellphone and on a laptop and both of those work. However, those connect through WiFi, while my PC is connected through an ethernet cable[code]
View 4 Replies View RelatedCould the new internet card be making my downloads and emails VERY slow or is it bad line speeds. Would a new modem router improve things.
View 1 Replies View RelatedI'm using a refurbished WRT54G2 v1.5 router. I've had the router for two and a half years and have never had a problem. I recently unplugged my DSL modem and this router to move them, and when I plugged them in again, the router stopped picking up the internet signal from the DSL modem. I'm able to get internet when I hardwire directly to the modem though. I tried resetting the router and setting the router up from scratch again, but now I just get error 321 Ethernet cable not connected when I try and run the setup cd.
View 6 Replies View RelatedProblem: My PS3 displays An Ethernet cable is not connected almost immediately after logging in. I am connected through a Linksys E2000 router. If I reset the cable modem, it will work for 10-15 minutes until it errors out again. If I plug the PS3 directly into the cable modem, it works fine. I'm really confused. I do not believe it is the router, as my computer is also connected to the router, and works fine. My Touchpad is connected wirelessly and also works fine. I do not believe it is the PS3, because it works fine if I plug it directly into the cable modem. I tried switching to wireless and it finds a lot of other signals (including mine), but I have the same problem if I choose wireless.I first had this problem with a launch PS3 and a Netgear router after almost three years of no problems.
View 8 Replies View RelatedI have DOCSIS 3.0 modem and a Linksys E1000 wireless router with which I get reults from SpeedTest of 8.6 mps down, 1.57 mps up up from 15 mps service from cable provider. Connected to modem via ethernet cable produces 16.0 speeds. Do I need to upgrade the router or are my settings wrong?
View 1 Replies View RelatedIs there a difference in an ethernet cable and an Ethernet networking cable? I have an Ethernet cable and a 6 port splitter I am trying to connect. I have 4 ports in the router that are in use. When I connect them to the splitter nothing s working.
View 1 Replies View RelatedWhen I plug my ethernet cord into my Dell XPS laptop, Windows doesn't detect that I have a connection. I've tried another cord and it works (it's too short to use instead) and my roommate has tried my cord and it works fine on his computer.I've tried diagnosing the problem, disabling and enabling the Local Area Connection, but nothing seems to work.
View 9 Replies View RelatedRecently I've been trying to switch to a wired connection. The cord and the port works because I tested and the connection works fine with my laptop. But my desktop won't connect. The light where the cord plugs in lights up but my desktop does not detect it.
View 1 Replies View RelatedMy laptop connected to internet with wifi, but it cannot use even my laptop detect connected, when i run trobleshooter it's show 'no valid IP address' even i already set up to automatically detect , restart my wifi router and unplug doesn't make any changes
View 14 Replies View RelatedSo lately my computer's wireless network has started to get really bad, we have 100mbit, and it only gets about 0.3. This seems to be an issue with the range, or something, since if i move the computer right next to the router, it runs at about 50-60mbit. Now a few days ago i decided to get an ethernet cable to try and solve the issue, but my computer doesn't detect a LAN connection, only the wireless one ( atleast it doesnt show up among the other connections). Some weeks ago the wireless connection worked nicely, but now suddenly it doesnt anymore. Currently i'm typing this from an old mac computer, since my internet doesn't work at all on my pc.
View 11 Replies View RelatedMy ZyXEL modem/router does not detect my ethernet cables. it has one that runs to the main computer and i have a cable connected to my xbox. the light does not turn on when i try to use the internet for my xbox and the xbox does not detect ethernet. the other port works fine for the computer.
View 1 Replies View RelatedI'm currently using wifi on my desktop but I usually disconnect and use cable. But just recently I do not know when, I can't detect any internet even the cable is attached to the pc
[code]...
we recently upgraded our home router and have been having trouble ever since. Our old router was a Netgear one, so we bought a newer netgear model. Since installing the new one we can not get my daughters laptop, an iPad and ipods to work on the wifi. My computer is wired into the router and works fine, it is just the wireless. All of these things worked perfectly using our old netgear wirelss modem and all of them can find the wireless network on their list of available networks, they all say that they are connected with a good signal, but when they try to browse the internet or check emails, it comes up saying not connected to the internet. We even bought a range extender because we thought the signal might not be strong enough between the new router and my daughters bedroom which are at opposite ends of the house and on different floors, but it made no difference and wasn't a problem before.
Anyway, the router we bought is a Netgear N150 wireless modem router DGN1000, the cables are plugged in to ports 1 and 4 ( there is only 1,2,3 and 4 to choose from). The extender is a Netgear universal range extender WN2000RPT
I have tried turning it all off and back on again, have uninstalled it and reinstalled it, but still nothing. Daughters laptop uses Vista and she has McAfee security. Exactly as it has always been and has worked fine using our old wireless router, just not this new one.
My EA6500 are not displaying all the connected network devices on in the GUI. How do i force this? Is it a bug? How can I make sure all my devices are showing in the GUI?
View 5 Replies View RelatedWhen reinstalling windows corp. edition, windows installs, but the cable modem is not detected, and won't connect to internet.
View 3 Replies View RelatedIs there any way to use an asa 5510 to detect which computer on the inside of my network is connecting to ip 87.255.51.229. I am being blacklisted for w win32/Zbot connection, I need to identify this computer and get it disconnected from the network ASAP.
View 6 Replies View RelatedI have a WAG160N wireless gateway . Yesterday when i tried to power it on after a couple of seconds the power led was solid green and the Ethernet leds were blinking with no Ethernet cable attached to the router . The ethernet leds would keep blinking for minutes . I tried to use a screwdriver to do a hardware reset ( with power on ) and i noticed that the power led would start blinking green/red for minutes . I tried to use another wired router which i have for backup and it could connect to the internet normally without a problem.
What the green / red blinking power led means ( power led is green and then changes to red and then it starts over ) ?
I have a Dell XPS M1530 with Vista 32 bit. When i plug in a cable i get nothing, no error, and the comp does not recognize that a cable has been plugged in. I think that this started after my Hard drive failed and Dell replaced it but i'm not positive. No errors (? or !) in Device Manager and I can't find the Marvell 88E80XX 10/100 Ethernet Controller in device manager. I have attempted to Reinstall the drivers. The wireless is still working. I have one Light to the right of the port that is on all the time solid but no flashing with the cable in or out.
View 14 Replies View RelatedI tried connecting someone else's laptop to a network cable but the laptop refused to detect the hardware device plugged?
View 1 Replies View Related