TPlink Router - Unable To Access Internet
Jul 23, 2012I am able to connect to TPlink router through my pc but unable to access internet.The router is unable to detect dynamic ip.
View 1 RepliesI am able to connect to TPlink router through my pc but unable to access internet.The router is unable to detect dynamic ip.
View 1 RepliesI have tplink router wr941nd. it was working fine but i when tried to use it again after some months i encountered this strange problem in which i am unable to connect to the router through its lan ports where has i can access the router through wlan i have tried reinstalling the firmware i have even installed dd wrt on it but i am unable to access it through the lan port.
View 3 Replies View RelatedI want to link a tp link router as access point to a d-link router.
View 2 Replies View RelatedI have a TP-Link wireless router which we have always been able to connect to the router with these laptops. My sister has come over to use our internet, which has worked before on her laptop, but now all of a sudden she can't connect to our router, it won't even allow her to type in the password it just says Windows can't connect to the network. I then tried one of our other laptop and after much battling it also refuses to connect to the router. eventually it did, but it still can't connect to the internet.I sat on the phone for about a hour with our network provider (I am from South Africa), and after trying many things, it still won't work. The guy said that there is nothing more to try.
[code]....
I have a tplink acess point TL-wa5110G . I have WISP ( wireless internet service provider). I have configured the acess point on wisp client router mode and wan type to pppoe gave the username and pwd..Now i want to share internet wirelessly. now my question is that can i connect the aces point to wan port of the wirless router to share internet wirlessly? Because i have seen the instruction figure in tplink access router where they have shown that u can connect it with with unmanage able switch to share it to wired lan.i want to ask can wirless works to share internet if i use wireless router to access point.
View 1 Replies View RelatedI had this problem for 3 months now, at random times I get no connection and the LAN led 1 in my router (which I am connected to) just keep blinking very fast, ADSL and ACT leds are just on. I tried to troubleshoot the problem and it detected 2 problems: "default gateway is not available" and "local area connection doesn't have a valid IP". even when it says that it is fixed, seconds later the problem is still there (sometimes it gives me one problem only). I tried many solution on the forum including reseting the router, disabling the laptop's wireless modem (I'm on a laptop) and even trying ipconfig/release - ipconfig/renew. everything is up to date and I update my antivirus (and it has auto update enabled). here are my specs:
Broadband connection: DSL
Router Make/Model: TP-LINK TP-8840
Anti-virus: Avira free anti-virus
ipconfig data:
[Code].....
have been trying to access 192.168.1.1 TPLINK Model TD-w8950ND configurations to ensure settings are correct and check password etc.
Have been unable to, I used to access it immediately, but for some reason, now I can;t after changing laptops. Not impressed. May have to reset laptop to factory settings as last resort. Don't know.
I'm trying to connect a non-wireless enabled pc to my virginmedia network by using a tp-link ta-wa500g router in client mode. The pc connects to the router via ethernet fine, and i can access the router admin page etc., but the router doesn't seem talk wirelessly to the virgin box. it finds it and everything, but i can't access the internet at all. i've tried removing the password, resetting everything, I've upgraded to the latest firmware, but have come to a bit of a dead end.
View 1 Replies View RelatedLost connection to Internet though router appears normal. Belkin router, MacBook.
View 1 Replies View RelatedI am trying to setup a DIR-601 wireless router (Hardware Version: A1 Firmware Version : 1.00NA ) with my connection from Astound.I am able to connect to the internet from the cable modem (Motorola SURFboard SB5101) but I am unable to get it to work through the router. All the lights on the router look ok.When I look at the WAN status from the router setup page I see :
WAN
Connection Type : DHCP Client
Cable Status : Connected
Network Status : Disconnected
Connection Up Time : N/A
[code]....
* I noted that the router did not show me the correct time. Is that normal ?I have even copied my laptop's MAC address but it did not work. I restarted the modem and the router a number of times but to no avail.
Here is my setup.Using all MAC OSX I have AT&T DSL ISP connected to a (ISP provided) Speedstream 5100 Modem.I just purchased a Cisco Linksys 5200 N Router and I cannot access the internet. I followed the set-up instructions to the T but to no avail. I cannot find anything online about these two devices being incompatable. Do I purchase a new modem? If so how can I be sure it's compatible with the router?
View 1 Replies View RelatedI've got a v1 E1000. Lately when I turn on one of my computers, or attempt to connect with my Motorola Xoom tablet it will show connected but I will not have internet access. Initially it will show that I have internet access but not work, then after about 1-2 minutes my PCs will show "No Internet access" for about 2-3 minutes, then it will show "Internet Acess" again and still not load. After that, in about 1-3 minutes the internet will start working and work as good as ever until I disconnect (manually or by turning off my computer) then connect again; the process described avove happens again.
View 2 Replies View RelatedI just bought a Linksys E1500 router and followed the CD instructions for setup. It is wired to my desktop and I am unable to access the internet. If I go direct to the modem and bypass the router the internet works fine
View 3 Replies View RelatedMy Dell Laptop is unable to access internet through my Netgear wireless router. Other equipment (Lenovo laptop, ipad, iphone, PS3) accessing internet fine through same router. I ran the onboard Dell Wireless WLAN Card Utility. Hardware diagonistics all pass. Connection diagnostics reports:
Radio Passed
Association Passed
Authentication Passed
Local IP Address Passed
[code]....
i want to block all internet access on all my computers from the time range of 9 PM to 8 PM. Yes, that gives 1 hour of internet access per day. However, it seems that there are certain rules of the router that won't let me do this. It seems I can't make 2 different policies for PC's within the same IP range (192.168.1.0 to 192.168.1.254) , it gives me the error: "The values you entered are invalid. Please try again."every time I try to do so. And when I try to give the time range from 9 PM to 8 PM it gives an error stating that the end time must be bigger than start time. I am using the WRT54GL with firmware v4.30.7.
View 5 Replies View RelatedSo I am an owner of this router for the last 2 years: TL-WR542G - Welcome to TP-LINK . Today it died on me. All of its leds are lightning up, but it doesn't provide a wifi network, and won't give me an interface when i try to access it through 192.168.1.1 on my desktop . There seems to be nothing I can do about it , I tried pushing the reset button on it's back but it does nothing at all.
Do I have any other options to get some life back into it?
I looked at portforward.com and have forwarded port 3389 in the modem with the ip address set to the router's address. I've also forwarded 3389 in the router to the pc's address.
View 14 Replies View RelatedI've got a a tp-link TL-WR741ND, but I don't have a ADSL2+MODEM ROUTER, (ADLS MODEM). Instead I've got a orange usb modem, how can I install the device?
View 2 Replies View RelatedI have a TP Link router installed at home with a 128 Bit encryption key. I have my home laptop and a couple of I-touches that are able to connect wirelessly. I have a laptop from work that I have not been able to connect to the TP Link after inputting the encryption key. how to be able to connect without affecting my home units that are already working?
View 3 Replies View RelatedI have router TP-link WR1043ND which cant handle more than 22 users?
View 4 Replies View RelatedI hav bsnl broadband connection in my home.... I connected a tplink wired for browsing...I also have a belkin wireless router..... I connected those routers.... And only wired communication is possible
View 7 Replies View RelatedI have a WISP internet connection. i have a Acess point tplink tl-wa5110g . i set it to wisp client router... My final goal is to share my wisp internet wirelesly.
Now i want to ask what i have to do next. do i need wireless router and connect it with the Ethernet port of the acess point..
I've been trying to set up my TP-Link WR740N router but it always give the error "Failed to Verify router settings" on the last step of the set up screen. Broadband: Globe broadband (Wired)Modem: Siemen Gigaset SE260 I'm also confused on the 2nd Set up screen, it gives the option to select Dynamic IP Static IP PPoEI've tried using the Dynamic IP and PPoE but still getting the same error message
View 1 Replies View Relatedis there a way to restrict the upload and download of computers on a wireless network (or at least get the router to favor one computer over the others?)i have a tp-link TD-W8960N router and the computer i need the extra bandwidth on is connected to the router via cable
View 3 Replies View RelatedI have IBM X3200 M3 ( with onboard 2 LAN ) not connected into internet,tplink modem router + wireless ( ADSL MODEM )--->cisco E2500---->ibm x3200 m3( ubuntu )
View 8 Replies View RelatedI bought a tp-link WA701ND and a netgear WGR614. i wish to pick up signal using 701 and then let 614 repeat it. no more tech support coz im already broke.
View 1 Replies View RelatedOk so I am accessing the Internet by LAN cable hooked up to the (LAN slots?) on the motherboard.After a lightning strike, where there was once 2 yellow lights is now gone.Question is what needs to be replaced because the slots are on the mobo itself.
View 5 Replies View RelatedMy wi fi strengh is good the only thing that shows up is a google page but unable to access the Internet at all.
View 1 Replies View Relatedethernet link light is green(blinking), but i am unable to access the network
View 2 Replies View RelatedIt is a period of time, of some weeks, since my laptop is unable to access the internet. It succesfully connects to a wireless network, I can see the name of it, but after connecting my laptop is displaying "Unidentified network", below the network name. Also, I don't have Internet access. In the task bar, my wireless icon has an exclamation mark, in a yellow triangle. I have tried to connect with another laptop at a wireless network my laptop can't connect and it worked for the other laptop. So, the problem is with my laptop, not with the network.
[code]....
I had a problem with client computer unable to connect to internet. the system is connected wirelessly and the signal strength ok. i tried it with another broswer, the same thing too. But when i used static ip addressing it was ok. this is our dns and dhcp address: 192.168.3.11 and the default gateway. but when i pinged the default gateway it way replying. using ipconfig /all:192.168.3.6 which is the peplink router switch it did show default gateway. and we are using dhcp in our organisation. Below are the command i carried out.
View 7 Replies View RelatedAfter I changed the router password today, I am not able to access the Internet through my machine. Seeing the 'Unidentified netwrok, access to local only'. However, other people connected to the same network are using Internet
View 14 Replies View RelatedUnable to access webpages and sometimes internet.I will be on my laptop which is the main computer I use (I usually use it wirelessly although I'm having the same problem now, even when I'm hardwired) and suddenly I can't access some or all websites. This isn't just normal dropping for a few seconds at a time, this can last for hours sometimes. Meanwhile, the desktop computer which is directly connected, doesn't have any problems at all.
View 7 Replies View Related