Cisco WAN :: Complex Connectivity Involving Soft With IPMUX216 And RAD24

I have a rather complex issue that involves a Cisco softswitch, a Cisco router configured for BGP routing, a L2 Cisco switch, and two RAD IPMUXs.I am including a flat diagram that illustrates the layer 2 connections. On the diagram, the number adjacent to the vertical connection bar is the vlans allowed on that connection, either switchport access or trunk.
 
I use BGP routing on the router to advertise various routes. The issue is that the routes for the RAD IPMUX216 and RAD24 are both being advertised correctly and can be seen from remote sites. For example, from any remote site, I can ping any address on vlan 60 such as the switch, router, and IMMUX216 IPs. However, I can only ping the vlan 61 IPs for the router and switch, but not the RAD24. Even from the Softswitch and Router, I cannot ping the vlan 61 ip of the RAD24, 172.22.248.6. I can ping the softswitch from the router and vice-versa.
 
Here is a flat diagram for the network with some snippets of code. I can provide more info if needed. I changed the routable IPs just to hide some of our actual info. If I ping 172.22.248.6 from the softswitch and then issue the "sh arp" command, I get:
 
Victoria-SW#sh arp
Protocol  Address          Age (min)  Hardware Addr   Type   Interface
Internet  172.22.248.1            0   0016.4650.c411  ARPA   Vlan61
Internet  172.22.255.6            -   0019.5678.7d43  ARPA   Vlan80
Internet  172.22.248.6            0   Incomplete      ARPA
Internet  172.22.240.14           -   0019.5678.7d42  ARPA   Vlan60
Internet  172.22.240.13           0   0020.d239.01a0  ARPA   Vlan60
Internet  172.22.248.5            -   0019.5678.7d44  ARPA   Vlan61
Internet  172.22.240.1           69   0016.4650.c411  ARPA   Vlan60