Connected To Internet Using Huawei Wireless USB Modem?
Feb 16, 2012
I am connected to the internet using a Huawei wireless USB modem connected to my desktop computer(no other type of service available) I would like to set up a Wifi home network so that I can connect using Wifi to all of the other gadget that I have in the house. So the question is can I connect a Wifi router using a ethernet cable comming from my desktop computer? and if so what router would you recommend for this application?
Just purchased a WS320 repeater so that my son can use his I-phone and I-pad around the house when he comes home weekends.Sadly, when the repeater is connected to my router the internet drops out on even my wired connections.I recently connected up to fibre and notice that the new router has the same gateway as the repeater.
I own a Broadcom BCM5354-based wireless router (Tomato 1.27 flashed) and an Aztech DSL605E modem. When both are powered up, the wireless router sometimes doesn't get internet access because the modem automatically logs itself in. I have to plug the modem cable to my laptop, manually disconnect the modem, and plug the modem cable back to the router to fix it.
Every day for the past week my Internet access goes down. I have a netgear router connected to Comcast modem. I have to reset the modem then the router constantly and it gets irritating. I called comcast and they say reset them. But why should I have to constantly reset.... Sometimes I just ignore it and it comes back up later... what is going on??
I was very happy working with my WRT610N connected to the ethernetport of my previous internet modem. Recently I had to switch to a new modem CISCO EPC3925. Unfortunately this combination does not work anymore. I don't get an internet connection on my WRT610N anymore. I therefore have to connect all computers (LAN and WIFI) to this EPC3925. Especially for the WIFI I'm not fully happy. My IPAD2 sometimes does not want to connect, a problem which never occurred when connecting to WRT610N.
I probably need to change a setting, but where? In the EPC3925 or in WRT610N?
I am using a USB Modem from HUAWEI Technologies to use internet when im not on a wifi zone.. The Internet Speed is kinda slow (512 kbps), so I configured my browser to go through a proxy to make it a lil bit faster (2mbps now)..Everything works fine except that I couldn't connect to https sites (gmail, facebook, eBay, etc)
Region : Finland Model : TL-MR3220 Hardware Version : Not Clear Firmware Version : 3.14.2 Build 120822 rel.577775n ISP : saunalahti
dosen't support my huawei E392 4G modem. if possible would you make bin for this. there is not other modems that you can get for 4G connections from the service provider so it would be nice if there was more compatibility than some old ancient modems. starts to feel like this is been sold as 4G router and dosen't actually support that at all.
When I looked up the internet connection status, for the packets that I received 236, I only receive 30-40. When I click repair, it said the IP address already renewed. However, the internet still not working. When I use my laptop to browse the internet, it said the same thing, internet connected but cannot browse at all.
I tried so many things, such as clearing the DNS cache, releasing and renewing IP address, I did set the properties of the wireless connection to obtain DNS and IP automatically, I tried pinging, I turned off all my firewalls, I tried system restore, but still not working.
From last two days, my internet disconnecting frequently. Modem catching correct ip but no internet connection.modem catches correct ip address n other things, it shows connected to home network (i.e hathway) and internet access is allowed but browser display error 'webpage is not available' (same result for login page of ISP). I have tried different browsers but same result. windows network diagnosis center results as "your computer appears to be correctly configured, but the device or resource is not responding " OR "login.hathway.com is online but still not responding after couple of tries"(second error is not correct word to word tht was the over all meaning of it)In ping test, ping to default gateway gives very good result as 5-20ms but 'request time out' for url...So am not understanding whether it is my pc's problem or from ISP.I m using single pc with wired modem. windows 7 no changes made in network n sharing center.
connect my PC/tablet with wifi router, I have bought wifi router which works with USB modem, when i connect my USB Modem i can see all the lights up (singnal- wifi, 2g/3g) and also showing in my laptop that is connect to wifi but unable to open the internet.
Just yesterday my laptop could connect to the Internet. Now it would just connect to the modem (via wi-fi), and there would be no Internet connection. All other computers in my house using wi-fi work fine.Here are my results when I type in the ipconfig /all in the command prompt.
Configuration IP de Windows
Nom de l'h�te . . . . . . . . . . : Loc-PC Suffixe DNS principal . . . . . . : Type de noeud. . . . . . . . . . : Diffusion Routage IP activ� . . . . . . . . : Non
My desktop recently broke so i bought my first laptop. I have AT&T DSL and i bought a new D-Link DSL-2640B modem/router so i could have wireless internet. I installed it and i was able to use it with the ethernet cable, however when i tried to use wifi, it worked for only about 2 minutes before it disconnected.. Now when i try again it says that it is connected (full 5 bars) but it also says there is no internet access and i cannot use the internet.
Also, before, with the old modem i was able to just connect the ethernet cable to the laptop and just start using the internet. Now i have to connect by putting in my username and password provided by my ISP almost like if it was dial up. I don't know why i have to do this now but not before.
Tech Support Guy System Info Utility version 184.108.40.206 OS Version: Microsoft Windows 7 Home Premium , 64 bit Processor: Intel(R) Core(TM) i3 CPU M 380 @ 2.53GHz, Intel64 Family 6 Model
I have been using my DIR-655 for about 2 weeks now with Road Runner wideband services. Starting yesterday my internet became very slow and I discovered the cause was the router. I tried resetting it to factory settings and things will be fine and run smoothly for about 5-15 minutes but after that it goes back to being extremely slow. My speed tests would go from 10ms (normal) to 250-450ms. Before this issue occurred the Dlink was perfect, had full speeds. I am running a wire Ethernet connection.
I am currently using revB and tried upgrading firmware to 2.01NA which had no effect, but make my internet seemingly go back to normal for the first few minutes then nosedive again. I have also changed my speed/duplex settings in Network Config to 1gbs Full Duplex. I've also disabled QoS, and still no change. Not sure what else to do. When directly connected to the modem everything seems fine. The modem is also the provided Motorola SBG6580 which I have called Time Warner to set the modem into bridge mode and have the DIR-655 connected to it.
My neighbor is using my Belkin Router the basic one and has comcast. We both use his internet and have had no problems until the past 3 days. He just got the home phone service from comcast and the phone line is setup through the modem. Ever since comcast came to his apartment and set this up the home phone service to his modem the router is connected but there is no internet access. What is going on and how can I fix this. He has an HP with windows Vista and I have a Toshiba Satellite L675 that has Windows 7 Home premium edition on it.
Today I purchased a Motorola SURFboard extreme Cable Modem DOCSIS 3.0 in order to replace my old modem which is out of date and has been very slow as of late. I connected the coaxial cable, Ethernet cable(to Linksys wireless router), and power expecting it to simply work. All four lights came on green (power, downstream, upstream, connectivity). The downstream light turned blue which indicates a bonded connection.The device light was blinking on the modem. I connected to my wireless router, but no internet access. I then tried connecting my laptop to the modem directly via Ethernet cable, still no access. I think that rules out the router being the problem. I also ruled out my laptop being the problem as the same thing is occurring with my other laptop and desktop. I called my ISP (Cox Cable) and had them re-establish connection with my modem, this did nothing. I thought for sure this meant I had purchased a faulty modem; I hooked up my old modem and the results were the same, the modem connected fully with no problem (all four lights were green) but I have no internet access.
I moved into a new apartment in Mexico City a month ago. The internet, already installed when I moved in, comes through a device called a Huawei EchoLife HG8427. For the first month of my residence, the internet worked perfectly. Suddenly, on a recent day, I was no longer able to connect to the internet, though I was still connected to the network. This problem has persisted for some time now.I have tried just about everything that I know how to, including restarting the modem, fiddling with my IPv4/6 settings, disabling/enabling my connection, disabling my firewall, ipconfic/flushdns/registerdns, ipconfig/reset/renew, and probably a few other things that I have now forgotten.
My computer, a Toshiba NB505 running Windows 7 Starter 32-bit, has no problem connecting to the internet via other networks. Ping tests show that I am indeed connected to the network and have no OS problems. I do not have any McAffee software (I read somewhere that this was a problem for some people). I cannot do a hard reset because the modem does not belong to me and serves several other people living here (this is sort of a short-stay guesthouse). This afternoon, the map on my network and sharing center briefly showed a successful internet connection (for about 10 minutes). During that time, however, I was still unable to connect to the internet and when I restarted my computer, it was back to showing a broken connection.Windows IP Configuration
I just bought a WRT54GL router, and am following the CD instructions for installation. Everything is connected according to picture (cable to modem to router to computer), and my phone and computer are working properly. However, the router is telling me that it cannot connect, and to check the ethernet connection.earlier a screen popped up to enter a password, but it was under the checking status screen, so I was not able to enter one. how to get the modem connected.
I have two ASA 5505's. One is currently setup as my firewall connected to the Cox Cable modem and wireless AP. I have another ASA that I would like to use, I have an idea that I could set that one up as a VPN unit, but not sure how I could do that. If that is not an option, can you provide the command line instructions on how to setup the VPN via the console cable. [code]
I have one interface setup to a Cisco 2921 router connected to a Cable modem.DHCP is on the 2921.when I connect to the ssid for my guest i'm redirected to the authentification portal 220.127.116.11 .i'm putting valide credential and when pressing the submit button .. it just go anywhere.
I have setup another SSID with a psk and it's working fine.. getting ip and able to browse internet.From what i have read... it's apparently DNS issue on my router.. but what should I check.
I had my exisiting Huawei 3G Dongle replaced with a new LTE USB Dongle Huawei E392 from M1 Singapore. The router dectects it and I was able to get on to the Internet. But every after few mins, the connection will just hang and I have to go into the router to re-establish the connection.
Region : UnitedStates Model : TD-W8960N Hardware Version : V3 Firmware Version : ISP :
My Toshiba laptop can't get connected to the wireless ADSL modem router TD-W8960N. I have 4 different laptops and one desktop, all connected to the router very well, only the Toshiba cannot get on Internet. I can connect to the wireless network on the laptop, but it shows limited access.
I have DOCSIS 3.0 modem and a Linksys E1000 wireless router with which I get reults from SpeedTest of 8.6 mps down, 1.57 mps up up from 15 mps service from cable provider. Connected to modem via ethernet cable produces 16.0 speeds. Do I need to upgrade the router or are my settings wrong?
We have a standard surfboard modem and a standard wired router. I recently purchased a wifi-only tablet thinking I could connect to an ad-hoc hotspot. This however isn't the case and now I can't use my tablet at home.I'm going to buy an inexpensive wifi router and just have that dedicated for my tablet. I've read that you can connect a wifi router into a wired router, but it requires a lot of mucking about with the settings. Then I remembered the USB connections that modems and routers have.can you have one wired router connected to the modem via a standard cable and also have a wifi router connected to the same modem via a USB cable?
There are 3 people in my house that are connecting to the internet by a single modem router, everything is fine when there is only 1 of us online , but when there are 2 or 3 of us online , our download & our upload speed dramatically decreases . So is there a way to maintain our normal download & upload speed even when all 3 of us are online ?